PDF download Download Article
Troubleshoot & fix common Frigidaire dishwasher drainage problems
PDF download Download Article

If your Frigidaire dishwasher has a big puddle of water in the bottom after it finishes a cycle, you probably have a drainage problem. The good news is most of the common causes are simple enough for any homeowner to fix by themselves. This guide will help you do just that by explaining the most common causes and walking you step-by-step through solutions to tackle each problem.

Common Causes of Frigidaire Dishwasher Not Draining

When a Frigidaire dishwasher is experiencing drainage issues, the most common causes are a kinked drain hose, a dirty drain filter, or a clogged air gap. Removing the blockage should take care of it. Other culprits include a blocked drain hose or a bad drain pump.

Section 1 of 3:

Causes of Frigidaire Dishwasher Not Draining

PDF download Download Article
  1. When the spray arms rinse food and grease off the dishes during a cycle, the resulting debris can collect in various parts of the dishwasher. It's also possible that your drain pump is damaged or malfunctioning. Most of these are easy DIY fixes! Below is a list of the most common causes of a dishwasher not draining:
    • Dishwasher needs to be reset
    • Drain hose kinks or leaks
    • Drain hose obstruction
    • Full filter
    • Air gap clog
    • Garbage disposal blockage
    • Faulty drain pump
  2. Advertisement
Section 2 of 3:

How to Fix a Frigidaire Dishwasher That's Not Draining

PDF download Download Article
  1. Most newer Frigidaires have a Start/Cancel button on the display. Press it down for at least 3 seconds to start a manual draining cycle. You can also try unplugging the dishwasher for a few minutes and then plugging it back in to reset it. [1]
  2. When you turn the garbage disposal on, run it for 15 seconds after you hear it stop grinding to help break up and remove any remaining food buildup. [2]
  3. Remove the stainless steel air gap cover on top of your sink and unscrew the plastic piece underneath. Shine a flashlight into the hole and clean out any debris you see with a stiff brush (like a toothbrush) and water. Then, replace the air gap and its cover. [3]
  4. If the air doesn't flow through, there's something blocking it. You can try removing the obstacle with a flat-head screwdriver or a straightened wire hanger, but if that doesn't work or the clog is too deep, the best option is to replace the hose. [4]
    • Don't use a pipe cleaner to unclog the drain hose! The pipe cleaner has sharp edges and may puncture the hose.
  5. Locate the drain hose under the sink and try to straighten out any kinks you find. After that, look for holes or signs of water leaking from the hose. If you find any, replace the hose with one that Frigidaire recommends for your particular model. [5]
    • To replace the drain hose : Unplug the dishwasher, shut off the water supply valve behind the appliance, and unscrew the counter mounts with a drill or screwdriver. Then, unscrew and remove the kickplate under the dishwasher and lower the feet by turning them clockwise if they aren't already touching the floor.
    • Arrange towels on the floor to catch any water that drips out, then slide the dishwasher out from under the cabinet. Lay it on its back or side so you can access the bottom.
    • Next, detach the drain hose from the drain pump on the bottom of the dishwasher and the air gap at the other (if you don't have an air gap, the drain hose may be connected to the drainpipe under the sink or to the garbage disposal unit). Connect the new hose, ensure it's free of kinks, and make sure the connections are secure.
  6. Remove the bottom rack from your dishwasher and locate the drain filter or glass trap handle. Unscrew it counterclockwise and pull it out. Rinse it in warm water to remove any food debris, let it dry, and put it back in the dishwasher. [6]
    • To remove stubborn food and grime, soak the filter or glass trap in warm, soapy water for 10 minutes. You can also use a soft brush to scrub off stubborn debris. Rinse the soap off and let it dry before reinstalling it. [7]
    • Cleaning expert Chris Willatt recommends cleaning your drain filter once a month and your whole dishwasher every six months. To eliminate hard mineral deposit buildup (which can also contribute to clogging), Willatt says to fill the dishwasher with 1 4  in (0.64 cm) of vinegar and run a full cycle with it. The acidity in the vinegar will dissolve the minerals.
  7. The check valve is located on the bottom of your Frigidaire dishwasher, just inside the drain tube. To access it, unplug the dishwasher, slide it out from under the counter, and set it on its back. Then, disconnect the drain hose from the drain tube and evaluate the condition of the rubber check valve flap. If it's stuck or the tube is blocked with debris, clear it to fix the issue. [8]
  8. The drain pump is located on the bottom of the dishwasher, so you'll need to unplug it, turn off the water supply, and unscrew and remove the kickplate to access it. [9]
    • Disconnect the wires from the drain pump and use a nut driver to loosen the hose clamp. Then, lower the support feet (if necessary), pull the dishwasher out from under the counter, and lay the dishwasher on its side or back.
    • Locate the drain pump on the bottom of the dishwasher. Use a set of channel locks to grip the drain pump hose clamp and move it to one side. Next, use a thin tool like pliers or a screwdriver to leverage the plastic tabs holding the pump in place, so you can pop the pump off.
    • If the pump appears cracked, brittle, or broken: Replace it with a brand-new one that matches Frigidaire's recommendation for your model. Align it and push it into place, and then use your channel locks to squeeze the clamps back into place. Reattach the drain hose, screw the hose clamp back on, and put your dishwasher back into place.
  9. Advertisement
Section 3 of 3:

When to Call a Professional

PDF download Download Article
  1. Your dishwasher could have a serious problem, and you might cause more damage if you troubleshoot it yourself. Signs of deeper issues with your dishwasher include a persistent clog, leaks outside the appliance, and strange noises coming from the pump motor.

Expert Q&A

Ask a Question
      Advertisement

      Video

      Tips

      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Thanks for submitting a tip for review!

      About This Article

      Thanks to all authors for creating a page that has been read 399 times.

      Did this article help you?

      Advertisement