PDF download Download Article PDF download Download Article

Using spray foam insulation or sealant and accidentally got some on your hands? Spray foams are meant to be tough to remove, especially after they’ve dried—thankfully, however, they’ll fall off your skin on their own in a few days. But if you don’t want to wait that long, you can speed up this process with a few simple tricks. We’ll walk you through them in this complete guide on how to get spray foam off hands.

  1. If the spray foam hasn’t dried, acetone can remove its stickiness. Dip a rag in acetone or nail polish remover and gently rub at the spray foam. Doing this before the foam has dried keeps it from attaching to your skin.
    • Avoid pouring acetone directly onto your skin, since this can cause irritation. [1]
    • Acetone will evaporate by itself very rapidly, but you can wash it off with water if you prefer. It can, however, dry out your skin, so apply a moisturizer after using it.
    • Acetone also works great for spray glue, not just spray foam. With a few drops of acetone, you can get any glue or other spray adhesives off your hands easily.
  2. Advertisement
2

Baby Powder

PDF download Download Article
  1. Baby powder gets rid of spray foam while being gentle on skin. Pour a generous amount of baby powder on both the front and the backs of your hands, enough so that there’s a decent layer of powder all over. Rub your hands together for 15 seconds, then rinse them off. Repeat this process 3-4 times—although you may not be able to get everything off at once, your hands should be noticeably more free of the spray foam. [2]
    • Although this method works best if the spray foam or insulation is still a little wet, it can also help you get dried foam insulation off your hands.
3

Water and Dish Soap

PDF download Download Article
  1. Fill a pair of rubber gloves halfway full will a mixture of water and several drops of dish soap. Put the gloves on your hands, tape them around your wrists, and leave them on for a couple of hours. When you remove them, the spray foam may have loosened up enough to be scrubbed off. [3]
    • If you have spray glue or adhesive on your hands, washing your hands with water and dish soap thoroughly should be enough to remove the glue. You may have to wash your hands several times before it’s all off.
  2. Advertisement
  1. Dip a rag in gasoline, then rub it onto your hands. Afterwards, wash your hands thoroughly with soap and water. The spray foam should be much easier to remove with a bit of light scrubbing.
    • Remember that gasoline is extremely flammable. Be sure to use it in a well-ventilated area, very far from any open flames or heat sources.
    • Gasoline works best if the spray foam is still wet and sticky.
    • After using gasoline, be sure to scrub your hands with enough soap and water to remove all of it from your skin.
  2. Advertisement

Expert Q&A

Ask a Question
      Advertisement

      Video

      Tips

      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Thanks for submitting a tip for review!

      Warnings

      • Avoid using commercial solvents, like WD-40, to get spray foam off your hands. Lacquer thinners may also cause irritation. These chemicals can be absorbed into your skin. [7]
      Advertisement

      About This Article

      Thanks to all authors for creating a page that has been read 181,057 times.

      Did this article help you?

      Advertisement