A Step-by-Step Guide to Check if You Have a Tilted Floor

PDF download Download Article
Expert advice on measuring if your floors are level—even without tools
PDF download Download Article

Whether you’re putting down new floors or you feel your furniture is unsteady, there are several ways to check if a floor is level. The most precise way is by using a bubble or laser level—tools designed specifically for this task, but in a pinch (if you don’t have carpeting), you can use a round object to see where your floor is sloping. Keep reading this article to learn the best (and easiest) ways to see if your floor’s not level.

Things You Should Know

  • Lay a 4–8 ft (1.2–2.4 m) carpenter’s level on the floor. If the bubble doesn’t sit in the middle, the floor doesn’t touch the bottom of the level, or the level teeters, it’s sloped.
  • Put a laser level in the middle of the room, then stand a wooden plank up on one end. Move the wood around the room, and mark where the laser hits it to see if it’s level.
  • Get a perfectly round object and put it on the ground to see if it rolls. Repeat against all the walls, and in the middle of the floor. If it rolls, your floor isn’t level.
Method 1
Method 1 of 3:

Using a Bubble Level

PDF download Download Article
  1. Pick a spot in the middle of the floor or against one of the walls. Lay a spirit level horizontally, so that the bubble is on top. Check the level by laying it on a surface, noting where the bubble in the middle is, flipping it over one end, and seeing if it’s in the same place. [1]
    • If you only have a short level, lay a 4–8 ft (1.2–2.4 m) long board on the floor and set the level on top of it. The longer the board, the more accurate your measurement.
    • This method will work on any type of floor.
  2. If the bubble isn’t in the lines in the middle, the floor isn’t level. When the bubble touches the sides of the lines, it’s off about 1 inch (2.5 cm) per 4 feet (1.2 m), sloping down in the opposite direction of the bubble. [2]
    • The further the bubble is to the side of one of the lines, the more sloped the floor is.
    • For example, if 3/4 of the bubble is in between the 2 lines and the other 1/4 is outside of 1 of the lines, the floor has a minor slope. If the bubble is all the way to 1 side, the floor has a major slope.
    Advertisement
  3. Get down on the floor by the level and check if the bottom edge rests completely flush on the floor. Measure the depth of the dip from the level, or check the slope by lifting one end of the level until the bubble is centered and measuring the height of the raised end. [3]
    • Raised spots in your floor cause the level to teeter back and forth. Once again, center the bubble in the level by supporting one side, then measure the distance from the level to the floor. Measure from the end of the level to the point it rests on to get the length for the slope.
    • If you’re planning on leveling your floor, mark any dipping spot with a piece of tape.
    • Find the slope of the floor by dividing the length of the level by the height you measured.
    • If you don’t have a long level, check the grade with a straight edge (like a plank) at least 6 feet (1.8 m) long.
  4. Place the level near each edge of each wall and in the middle. Read the bubble and look for gaps to make sure the floor is level all over. [4]
    • If you have a shorter level (and no supporting beam) check several spots. For instance, if you’re using a 4 ft (1.2 m) level, it check 2 different spots near each edge of the floor and at least 2 spots in the middle.
    5. Advertisement
Method 2
Method 2 of 3:

Checking with a Laser Level

PDF download Download Article
  1. Use a long piece of wood, such as a 2 in × 4 in (5.1 cm × 10.2 cm) plank, of any length that is comfortable for you to hold standing up. [5] Cut the ends completely straight.
    • You can use this method for any type of floor.
    • 2 in × 4 in (5.1 cm × 10.2 cm) boards from a hardware store almost always come with straight cut ends.
  2. Set a tripod-mounted laser level approximately in the center of the floor. Press the laser level’s ON button to project the laser beam. [6]
    • You can get a laser level at a home improvement center or online for a starting price of around $40 USD.
    • If you don’t want a specialized tripod, use a standard camera mount tripod , which you can get online for about $12 USD.
    • Many laser levels project the laser beam 360 degrees, so you don’t have to move the laser at all to check levelness all over the floor. Others might require you to turn the laser to project it in different directions as you work.
  3. Stand near one corner of the floor and hold the piece of wood up straight up next to you. Position it so that the broadest side is facing the laser. [7]
    • Keep the end of the plank completely flat on the floor.
  4. Adjust the height so the laser hits approximately 6 in (15 cm) lower than the top of the piece of wood you’re marking on. Use a pencil to carefully trace over where the laser hits the wood. [8]
    • This gives you plenty of room to make markings higher than the laser if the floor is uneven in places. [9]
  5. Move the wood to each corner around the center of the room, and make a mark where the laser beam hits it. This shows you whether other parts of the room are higher or lower than the first spot you marked. [10]
    • Laser levels are self-leveling, meaning the laser will be at the same height all around the room, so you don’t need to worry about adjusting the laser at all.
    • Measure the offset from the first line at each point, then write it down on tape and stick it to the spot you checked from.
    6. Advertisement
Method 3
Method 3 of 3:

Using a Round Object

PDF download Download Article
  1. One of the easiest ways to check if a floor is level is with a golf ball test. Get a perfectly round object (or several), then set it on the floor. [11] If the ball continues to naturally roll to one spot, that’s a dip. If there’s a spot it won’t stay on, that’s a peak.
    • If the object rolls, the speed at which it rolls indicates how great the slope of the floor is and in which direction the floor slopes. For example, if it rolls slowly to the left, it indicates that the floor slopes slightly to the left.
    • This method won’t work with carpeted or tiled floors. The floor must be hard and smooth so that the object can roll, such as a concrete, hardwood floor, or linoleum floor.
  2. Move around to the different edges of the room and set the round object down. Watch to see if it rolls and take note of the direction and how fast it goes. [12]
    • This is a very basic way to find general directions of slopes and estimate how serious they are. However, if you find that the floor is not level, check it using a bubble level or laser level to get more precise indications of where the slopes are.
    3. Advertisement

Expert Q&A

Search
Add New Question
  • Question
    How do I fix a floor that is really unlevel?
    Kevin Schlosser
    Home Improvement Specialist
    Kevin Schlosser is a Home Improvement Specialist and the Owner of Home Tech Handyman Ltd. With over 20 years of experience, Kevin specializes in age-in-place installations, flooring, roofing, and general remodeling handyman services. Kevin holds a blend of construction and in-home technology-related certifications including NAHB Certified Age-in-Place Specialist, CEDIA membership and certifications, and a Certification from the Association of Certified Handyman Professionals. Also, he is in training to receive certifications in Construction, Project Management, and other CEDIA qualified system integrator certifications. He is fully-insured in the state of Colorado.
    Kevin Schlosser
    Home Improvement Specialist
    Expert Answer
    If anything is extremely unlevel, I'd suggest more serious repairs to the foundation, the structural framing, and any other potential issues.
    Thanks! We're glad this was helpful.
    Thank you for your feedback.
    If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
    Yes No
    Not Helpful 1 Helpful 2
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
      Advertisement

      Tips

      • If you’re working with subflooring and see any cracks, signs of rot, or termite damage, call a contractor or foundation specialist.
        Thanks
        Helpful 0 Not Helpful 1
      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Submit
      Thanks for submitting a tip for review!
      Advertisement

      Things You’ll Need

      Using a Spirit Level

      Checking With a Laser Level

      Using a Round Object

      • Round object

      You Might Also Like

      How to
      Use a Ratchet Strap
      How to
      Use a Light Timer
      Homemade Dawn Powerwash: Easy Recipe for Refills
      Moving a Vehicle’s Electric Power Seat Forward or Back Manually
      5 Ways to Reset Any Maytag Washing Machine
      How to
      Make a Smokeless Fire Pit
      How to
      Fix a Leaky Sink Trap
      How to
      Make a Drone
      Safe & Effective Ways to Clean & Unclog Any Sink Drain
      How to
      Paint on Plastic
      How to
      Clean a USB C Charging Port
      How to
      Adjust a Lazy Susan
      How to
      Adjust a Furnace Gas Valve
      How to
      Disassemble and Clean a Honeywell Quietset Tower Fan
      Advertisement

      References

      1. ↑ https://youtu.be/kOnwTzSeFtE?si=PLZZWnlj5UgnyfDH&t=199
      2. ↑ https://www.thisoldhouse.com/tools/21015437/how-to-choose-and-use-a-level
      3. ↑ https://youtu.be/kOnwTzSeFtE?si=Fwnrdy1lT-bNOz10&t=378
      4. ↑ https://www.thisoldhouse.com/flooring/22397889/how-to-level-a-floor
      5. ↑ Kevin Schlosser. Home Improvement Specialist. Expert Interview. 19 February 2021.
      6. ↑ Kevin Schlosser. Home Improvement Specialist. Expert Interview. 19 February 2021.
      7. ↑ Kevin Schlosser. Home Improvement Specialist. Expert Interview. 19 February 2021.
      8. ↑ Kevin Schlosser. Home Improvement Specialist. Expert Interview. 19 February 2021.
      9. ↑ http://www.ultimatehandyman.co.uk/how-to/diy/floor-level
      1. ↑ Kevin Schlosser. Home Improvement Specialist. Expert Interview. 19 February 2021.
      2. ↑ https://youtu.be/L0yskx-gouE?si=_zahCOeO5YL5pmq2&t=27
      3. ↑ https://www.bobvila.com/articles/leveling-a-floor/

      About This Article

      Thanks to all authors for creating a page that has been read 85,795 times.
      If you buy through links on our site, we may earn a commission .

      Did this article help you?

      Advertisement