Download Article
Download Article
Redbud trees, or cercis canadensis , are a type of North American tree that bloom in the spring. They are low-maintenance as far as pruning goes. Once you prune out all the dead or diseased branches in the winter, you only need to do some structural pruning in the late spring or early summer.
Steps
-
Make a shallow cut under the branch, next to the collar. Choose the branch that you want to cut off, then use a hand saw to make a shallow cut into the underside of the branch, 4 to 5 inches (10 to 13 cm) from the collar. [1] X Research source
- The collar is the swollen ring where the branch joins the trunk. When you cut in this area, the collar will release chemicals that will help heal the wound faster.
- This is only for thick branches. If the branch is thin enough to cut off in a single cut, chop it off right at the collar instead with pruning shears.
-
Cut the branch off 2 to 3 inches (5.1 to 7.6 cm) from the shallow cut. Make sure that you are cutting to the outside of the shallow cut, not between the shallow cut and the collar. This way, then the branch falls down, it won’t rip the back off all the way; the bark will stop tearing at the shallow cut. [2] X Research sourceAdvertisement
-
Remove the rest of the branch, all the way down to the collar. Try not to cut into the collar, however, or the wound won’t heal properly. At the same time, don’t leave any wood sticking out of the collar either, otherwise it will become a breeding ground for pests. [3] X Research source
- You do not need to seal the cuts. Leaving the wound open will allow it to breathe and heal faster.
-
Cut 1 ⁄ 4 inch (0.64 cm) above buds. Do not cut through a bud, as this can lead to disease or dieback. Instead, cut 1 ⁄ 4 inch (0.64 cm) above the bud. If there are multiple buds, choose 1 bud that’s facing in the direction you want the new branch to grow in. [4] X Research source
-
Remove 1 of the branches from the V junction if the tree is young. Redbud trees have 2 branches that stem from the trunk; this is known as a V-shaped junction. Unfortunately, these can break off during harsh windy or icy conditions. Cutting 1 of these branches off will help reduce damage. [5] X Research source
- Cut your desired branch off, 4 to 5 inches (10 to 13 cm) above the junction.
- Cut the rest of the branch off 1 ⁄ 4 inch (0.64 cm) above the junction.
-
Sanitize your tools with rubbing alcohol after each cut that you make. Spray or pour some rubbing alcohol onto the shears or saw, then wipe them clean with paper towels. You need to do this after each cut that you make, even if it is on the same branch. [6] X Research source
- If you don't sanitize your tools, you risk spreading the disease to your other trees (or to other branches on the same tree). [7] X Research source
- If you don’t have alcohol, use a solution of 1 part bleach and 10 parts water instead.
Advertisement
-
Plan to prune dead or diseased branches in late winter or early spring. This is when the tree is dormant, so doing extensive pruning is fine. The tree flowers in the winter, so if you care about enjoying the flowers longer, prune the tree in the spring, after the flowers have fallen. [8] X Research source
- Try to prune before the sap starts to form, and this will prevent sticky messes. Sap usually forms around early to mid spring. [9] X Research source
- You don't need to do any other type of pruning at this time. Things like thinning and shaping are considered to be structural pruning, and are best left for the summer.
-
Learn how to identify cankers and Verticillium wilt. Redbud trees are prone to other diseases, but these 2 require that you prune the tree immediately; do not wait. Even if a branch looks dead, but you aren’t certain if it is diseased, you should still treat it as one; it is better to be safe than sorry.
- Cankers: look for brown, wilting leaves and cankers on the branches. Dark pits with black centers are another sign.
- Verticillium wilt: look for brown or yellowing leaves and lack of new, healthy leaves. More severe cases may include dead or dying branches.
-
Cut at least 3 to 4 inches (7.6 to 10.2 cm) below the affected area. There is no way to chemically treat a canker or Verticillium wilt, so you have to cut the branch off. To prevent the fungus or disease from spreading, cut it at least 3 to 4 inches (7.6 to 10.2 cm) below the canker. [10] X Research source
-
Look for healthy wood under the cut, then prune more if needed. Sometimes, the disease spreads further along the branch than what is visible on the outside. If you just pruned off the branch, and the exposed wood still looks dead, the disease is still present. Cut the branch back by another 3 to 4 inches (7.6 to 10.2 cm).
- If you don’t cut all of the dead or diseased wood off, the infection will continue to spread. In more severe cases, it may kill the entire tree.
-
Leave branches that have recently wilted. Just because there's nothing growing on a branch at the moment does not necessarily mean that it is dead. Give it a few weeks, or wait until the next spring season before making your judgement. [11] X Research source
- If the branch blooms, then it is both alive and healthy, and does not need to be pruned.
- If the branch has been dead for several years or does not bloom the following spring, cut it off.
Advertisement
-
Plan to do structural pruning during the summer. This includes things like low-hanging or crisscrossing branches. You should take care of water sprouts at this time as well. [12] X Research source
- If you choose to prune in the summer, wait until the leaves reach their fullest size. [13] X Research source
-
Start pruning with any crisscrossing or crowded branches. Remove the inward-growing branches and leave only the ones that point towards the outside of the tree. This will help clear up some clutter within the tree’s canopy and allow for both air circulation and light penetration. [14] X Research source
- Air and light are both important as they can reduce the growth of mold, bacteria, and pests. The light will also allow the leaves to photosynthesize.
-
Remove the lower branches, if desired. This is purely for aesthetic reasons. Take a look at your tree, and note the space between the ground and the lowest branches. Do the branches get in the way of anything, like porches, swings, etc.? If so, prune them off! [15] X Research source
- Only do 1 or 2 branches each year, otherwise you’ll shock the tree. Keep pruning yearly until you remove your desired number of branches.
- The younger the tree is, the more effective this will be. It is still possible for older trees, however.
-
Apply a slow-release fertilizer around the tree’s drip line. A fertilizer that is formulated for trees and shrubs will do just fine here. How much fertilizer you use depends on the format (granular or liquid) and the brand; read the instructions on the package. [16] X Research source
- Read the instructions that came with your fertilizer to find out if and when you should water it.
- The drip line is the span of the tree's canopy. Take a look at where the shadow lands when the sun is directly above your tree; that is the drip line.
- Plan to reapply the fertilizer every 6 weeks during the spring, until summer begins. [17] X Research source
-
Cover the soil around the tree with mulch. Begin applying the mulch about 6 inches (15 cm) from the base of the trunk, and extend it out to just past the drip line. If the instructions that came with the fertilizer tell you to water it after applying the mulch, then do so now. [18] X Research source
- When reapplying the fertilizer, just move the mulch aside, add the fertilizer, then cover it back up with mulch again.
- If you can't move the mulch aside to reapply the fertilizer, just add the fertilizer on top of the mulch. Double the amount to ensure that it penetrates through the soil.
-
Do additional summer pruning every 3 to 5 years. Redbud trees are low-maintenance, so after the first 3 years, you only need to prune the tree every 3 to 5 years afterwards. Keep in mind that how often you do this will also depend on the tree’s health and growth rate. [19] X Research source
- For example, if the tree gets cankers or dead wood, then don’t wait 3 to 5 years to cut the branch off. Do it immediately.
- This is only for the pruning discussed in this section. You should do the winter pruning each year.
-
Trim off suckers and water sprouts every year in the summer. Suckers are vertical stems that grow from the ground, near the base of the tree. They won’t turn into new trees, and only take away nutrients. Water sprouts are similar, but they grow from the tree’s base. [20] X Research source
- Trim water sprouts as close to the base of the tee as you can. In order to reach the base of the suckers, you may actually have to dig into the soil.
Advertisement
Expert Q&A
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Tips
- If a branch is too high up to reach, lean a sturdy ladder against the tree, then climb it so that you can reach the ladder.Thanks
- Wearing protective gear, such as safety goggles and safety helmets would be a good idea.Thanks
- If you are working on a ladder, don't work alone. Have someone close by in case you fall.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Thanks for submitting a tip for review!
Advertisement
Things You'll Need
- Hand saw
- Heavy-duty pruning shears
- Gardening gloves
- Ladder, if needed
- Rubbing alcohol or bleach
- Fertilizer
- Mulch
Expert Interview
Thanks for reading our article! If you’d like to learn more about pruning plants, check out our in-depth interview with Gus Briones .
References
- ↑ https://www.bhg.com/gardening/trees-shrubs-vines/care/how-to-prune-trees/
- ↑ https://www.bhg.com/gardening/trees-shrubs-vines/care/how-to-prune-trees/
- ↑ https://www.bhg.com/gardening/trees-shrubs-vines/care/how-to-prune-trees/
- ↑ https://www.bhg.com/gardening/trees-shrubs-vines/care/how-to-prune-trees/
- ↑ https://www.bhg.com/gardening/trees-shrubs-vines/care/how-to-prune-trees/
- ↑ https://hgic.clemson.edu/factsheet/redbud/
- ↑ https://www.treehelp.com/redbud/
- ↑ https://www.wildflower.org/expert/show.php?id=10193
- ↑ http://www.hawkslandscape.com/redbud-pruning-winter-care-and-fertilizing/
- ↑ https://www.treehelp.com/redbud/
- ↑ https://www.treehelp.com/redbud/
- ↑ https://www.bartlett.com/resources/Plant-Health-Care-Recommendations-for-Redbud.pdf
- ↑ http://www.hawkslandscape.com/redbud-pruning-winter-care-and-fertilizing/
- ↑ http://www.hawkslandscape.com/redbud-pruning-winter-care-and-fertilizing/
- ↑ http://www.hawkslandscape.com/redbud-pruning-winter-care-and-fertilizing/
- ↑ https://hgic.clemson.edu/factsheet/redbud/
- ↑ https://hgic.clemson.edu/factsheet/redbud/
- ↑ https://hgic.clemson.edu/factsheet/redbud/
- ↑ http://www.hawkslandscape.com/redbud-pruning-winter-care-and-fertilizing/
- ↑ http://www.hawkslandscape.com/redbud-pruning-winter-care-and-fertilizing/
About This Article
Thanks to all authors for creating a page that has been read 80,692 times.
Advertisement
86%
of readers found this article helpful
.
Click a star to add your vote
% of people told us that this article helped them.
