Download Article
Make your golf club the perfect length for you
Download Article
Are your golf clubs too long? Believe it or not, you can adjust them yourself, without going to a professional. These relatively easy steps will help you shorten a golf club in 45 minutes or less!
How to Shorten a Golf Club
- Place the club into a vice grip so the grip end of the club faces you.
- Cut off the grip with a utility knife and peel off the tape.
- Measure and cut the club to your desired length with a hacksaw.
- Let the shaft cool, then sand the cut metal to smooth the shaft.
- Apply grip tape, spray it with solvent, and put the grip on the shaft.
Steps
-
Prepare the work area. Place a towel or clothes underneath your vice grip. -
Place the club into the vice. Put the club into the vice such that the grip end of the club is pointing at you.Advertisement -
Cut off the grip. With a utility knife, carefully make a cut along the grip. Remove the grip and dispose of it in the garbage. -
Remove the tape. Underneath the grip, you will find tape. Remove this by peeling it off.
Advertisement
-
Measure the desired new length of club. With the measuring tape, measure the desired length to be cut off. This distance should be taken from the top of the club. Mark the length. Use a permanent marker to mark where the cut should be made. -
Cut the club at the desired length. Using the hack saw, carefully cut the club where you marked it. Be sure keep fingers away from blade for your safety. -
Wait 10-15 minutes for shaft to cool off. The metal you just cut will be hot so set it aside for several minutes and allow to cool down. -
Sand/dull the end of metal that was just cut. Take the sand paper and carefully smooth the end of the shaft. It will be sharp, and you do not want to rip the new grip that you will put on later.
Advertisement
-
Apply grip tape to the end of the shaft. Put the new grip along the shaft to see how far down it will extend. This is how far you want the tape to go on each side. -
Spray with solvent. This will lubricate the tape so you can easily slide the grip over it. This solvent will dry up and become a sticky glue. -
Spray solvent into the grip. Hold your finger to the tee-sized hole at the end of grip and spray the solvent into the other end. Shake this around to lubricate the inside of the grip. -
Put the grip onto the end of shaft. With your finger still holding all the solvent liquid inside the grip, slide the big hole onto the shaft. -
Let sit for at least 6 hours. In order for the tape and solvent to fully set, allow time for it to dry.
Advertisement
Expert Q&A
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Tips
- Take your time. You do not want to restart the whole process and waste a new gripThanks
- Complete each step before moving onto the next oneThanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Warnings
- Do not ingest grip solventThanks
- Failure in proper hack saw use may result in severe injuriesThanks
Advertisement
Things You'll Need
- Golf club
- Utility knife
- New golf grip
- Grip tape
- Grip solvent
- Hack saw
- Measuring tape
- Marker
- Table vice
- Any color permanent marker
- Sand paper
About This Article
Thanks to all authors for creating a page that has been read 33,849 times.
Advertisement
94%
of readers found this article helpful
.
Click a star to add your vote
% of people told us that this article helped them.
