PDF download Download Article PDF download Download Article

Suturing is a term used to describe the closing of a wound, artery, or part of an organ using a specific needle and thread. The main reasons for placing a suture are to stop bleeding and inhibit infections from making further damage. Although not discussed in this page, some suturing techniques are done for beauty reasons or for preventing a scar from forming. The first step of performing any suture is to make sure that it is fixed and will not open up with any movement of the patient, hence requiring the instrumental tie. Then, one can go ahead and continue with a certain suture technique, such as simple interrupted, simple running, running locking, and vertical and horizontal mattress sutures.

Part 1
Part 1 of 7:

Preparing

PDF download Download Article
  1. [1]
    • To practice the suturing techniques, you will need a suture pad. It can easily be obtained online (from Amazon, for example).
    • Tissue forceps: opens up wound and allows clear vision of the needle's puncture site
    • Scissors: To cut excess thread.
    • Needle holder: To prevent the spread of germs, the needle must always be held by the needle holder rather than being held with your hands.
    • Needle with thread: The choice of the needle size and thread type depend on the reason for performing a suture and the nature of the wound. The needle with thread used in the following steps is 2-0 silk.
  2. Advertisement
    • Make sure to pull all the thread out.
  3. Advertisement
Part 2
Part 2 of 7:

Instrumental Tie

PDF download Download Article
  1. This allows for better visualization and avoids hitting muscle.
    • This step should always be done before puncturing the skin, which is introduced in the next step.
    • Remember to always avoid pushing down on the skin with the tissue forceps.
  2. Aim for about half a cm down from the end of the wound with a 90 degrees angle between the skin and the needle, twisting your hand clockwise for about half a circle. [4]
    • The needle goes through the skin from outside to inside.
    • Also, make sure that you the needle exits on the inner side of the skin; it should go down to a depth of about 0.5cm.
    • To release the needle holder's "click" to pull the needle out, pull the needle holder with your ring finger to the right and push with your thumb to the left.
  3. However, in this step, the needle goes from inside to outside.
  4. Hold the needle with the needle holder (without the need to hear a click) and pull so that all the thread, except for about 3–5 centimeter (1–2 in), is on the left side of the wound.
  5. After releasing the needle from the needle holder, use your left hand to hold the thread near the wound and wrap it approximately a cm or two from the tip around the closed needle holder. [5]
    • Make sure to wrap the thread three times outward (clockwise) while keeping the thread in close proximity to the wound.
    • Note: The direction in which you wrap the thread does not matter as long as it alternates between consecutive steps.
  6. Slightly open the needle holder with the thread wrapped around it, grab the 3–5 centimeter (1.2–2.0 in) of thread on the right side with the needle holder.
  7. Using your left hand, pull the long thread to allow the wrapped thread to pass out of the needle holder and get tied around the loose 3–5 centimeter (1.2–2.0 in) of thread on the right.
    • Be careful to NOT pull too much on the skin, causing one side to be pushed on top of the other.
    • Only pull as much as you need in order to bring together and seal the two sides of the wound.
  8. 8
    Next, do steps 5 to 7 again with a couple of alterations:
    • Note: these three steps (5 to 7) will be done a total of 3 times, with a small difference in them each time.
    • First, do steps 5 to 7, wrapping the thread inwards (counterclockwise) twice around the needle holder.
    • Then, do steps 5 to 7 a third time, wrapping the thread only once outwards (clockwise) on the needle holder.
  9. Advertisement
Part 4
Part 4 of 7:

Simple Running Suture

PDF download Download Article
  1. 1
    Again, start with the instrumental tie at the beginning of the wound in order to fix the thread in place but do not cut the excess thread.
  2. MAKE SURE that every loop you make is on the upper side of the suture pad (away from you).
    • This is going to be one long suture running along the entire wound with an instrumental tie at the beginning and end of the suture. [6]
    • This suture is as if you are continuing to make whirls in a clockwise direction.
    • Use the last loop of the running suture to perform an instrumental tie since there is no loose end to grab with the needle holder.
  3. Advertisement
Part 5
Part 5 of 7:

Running Locking Suture

PDF download Download Article
  1. 1
    Like before, start this altered version of the simple running suture with an instrumental tie at the beginning of the wound and then puncture the skin about a cm from the instrumental tie on the right and left side of the wound, respectively.
  2. Before pulling the thread completely to seal the wound, it's very important to MAKE SURE that the loop is on the lower side of the suture pad (towards you).
  3. Continue performing steps 1 and 2 multiple times along the extent of the wound and end the suture with an instrumental tie to prevent any loosening up to take place.
    • Note: You will notice that a line will form on the left side of the suture, which provides extra firming, allowing the suture to remain in place.
  4. Advertisement
Part 6
Part 6 of 7:

Vertical Mattress (or "far-far-near-near") Suture

PDF download Download Article
  1. Start with a puncture of the skin on the right side of the wound, but make sure to do so approximately double the distance that you used for the previous sutures, so approximately 2 centimeter (0.79 in) out from the wound site. [7]
  2. Travel under the skin to the left side of the wound and bring out the needle at the same distance, so approximately 2 centimeter (0.79 in) out from the wound site.
  3. 3
    Turn the needle around 180 degrees with the help of the tissue forceps and hold it with the needle holder.
    • This will make the next step easier.
    • DO NOT use your hands to adjust and turn the needle around.
  4. The next puncture site inwards will be on the same side of the wound (left) and halfway between the puncture site made in step 2 and the wound.
    • The 4 puncture sites are represented by the 4 red dots.
  5. Of course, you will need to pull the thread out, bring the two sides of the skin together, and finish with an instrumental tie to secure the suture.
    • If you place your suture pad with the wounds lined horizontally, then you will see that the puncture sites line up vertically, hence this suture's name. In addition, a bigger needle is usually used to perform this type of suture.
  6. Advertisement
Part 7
Part 7 of 7:

Horizontal Mattress Suture

PDF download Download Article
  1. 1
    Start at the beginning of the wound and take a bite inwards approximately 1 centimeter (0.39 in) from the wound site. [8]
    • Leave approximately a 3 centimeter (1.2 in) of the thread loose.
    • A "line" will form between the second and third bites. [9]
  2. The last bite for this suture is across from the third suture, taken outwards about 2 centimeter (0.8 in) from the first bite.
    • The puncture sites are represented by the 4 red dots.
    • With the suture pad placed horizontally in front of you, it will seem that you are moving horizontally along the wound, hence this suture's name.
  3. Advertisement

Expert Q&A

Ask a Question
      Advertisement

      Tips

      • Always make sure that the two sides of the skin come together in order to prevent infections and bacteria from entering the wound.
      • If you are performing a suture on an actual person, then make sure that all of the equipment is sterilized, ready to use, and easily reachable.
        • Unsterilized material can cause irritations and infections.
      • Another name for the Vertical Mattress Suture is "far-far-near-near" because of where the bites are taken in respect to the wound, which could help you remember the procedure.
      Show More Tips
      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Thanks for submitting a tip for review!
      Advertisement

      About This Article

      Article Summary X

      If you need to suture a wound, use tissue forceps to expose the skin near the end of the right side of the wound, puncture the skin with the needle and thread, and twist your hand clockwise in a half circle. Next, puncture the left side of the skin directly across the wound, pull the needle so that all but 3-5 cm of the thread is on the left side, and secure the thread with an instrumental tie. Then, continue puncturing the right and left sides to close the wound. Finally, tie off the last loop and cut the excess thread. For tips on using different techniques, read on!

      Did this summary help you?
      Thanks to all authors for creating a page that has been read 147,110 times.

      Reader Success Stories

      • Connor K.

        Apr 19

        "I have an inherent interest in the medical field, and even though I have a feeling that medical school is well out ..." more
      Share your story

      Did this article help you?

      Advertisement