PDF download Download Article PDF download Download Article

Smokers are a great way to cook your food to perfection. They may take a while, but the results are well worth it. The dampers are the primary way to control the smoker’s temperature. Close the dampers more to cool the smoker down, or open them further to heat things up. Remember that wind, fuel, and outdoor temperatures play a role, too. Once you understand how these affect the smoker, you can become a master at smoking meat.

Part 1
Part 1 of 3:

Adjusting the Temperature

PDF download Download Article
  1. The intake damper is located at the bottom of the smoker, where the fuel is. It controls how much oxygen reaches the fire. You can open and close it however much is necessary. [1]
  2. The exhaust damper is located near the top of the smoker. It helps pull the oxygen through the fire. It also allows the gasses, heat, and smoke to leave the smoker. You should always leave the exhaust damper open least partway in order to maintain airflow. [2]
    Advertisement
  3. This setting may vary from recipe to recipe, but in general, it lays between 450 and 550 °F (232 and 288 °C). In order to get the smoker this hot, you need to open the intake damper all the way to allow the most oxygen in. [3]
  4. The more you close the intake damper, the cooler the smoker will become. To get a medium heat range of 350 to 450 °F (177 to 232 °C), leave the intake damper open halfway. To get a low heat range of 250 to 350 °F (121 to 177 °C) leave the intake damper open a quarter of the way. [4]
  5. Some recipes call for a low heat or a slow smoke. This usually converts to 225 to 275 °F (107 to 135 °C). In order to get the smoker this cool, you should leave the intake damper open an eighth to a quarter of the way. [5]
  6. If the bottom vent is closed all the way and the temperature is still too hot, try closing the top vent a little--not all the way. You can also try removing some fuel with metal tongs. Never dose coals inside the smoker with water. On the other hand, if the smoker is running too cool, you can try opening the exhaust vent more. [6]
    • Still having trouble increasing airflow? Prop the lid open a little.
  7. Advertisement
Part 2
Part 2 of 3:

Maintaining the Temperature

PDF download Download Article
  1. The water will help absorb the heat and regulate the temperature. Depending on the size of the pan, your smoker, and the temperature, expect to refill it every 3 to 4 hours. In most cases, you'll want to use hot water, but if the smoker is getting too hot, switch to cold water. [7]
    • The water pan should be in the middle of the cooking section, right under the bottommost cooking grate. [8]
  2. Much like using an oven, you should not peek at your food. Each time you open the lid, you will increase the airflow and temperature. The only time you should open the cooker is to turn the meat, check the fuel, or add water. [9]
  3. It can take a long time before the temperature on the smoker starts to rise. Once the temperature starts to rise, however, it can shoot up pretty quickly. Be extra-vigilant during this time and make minor adjustments before the temperature reaches the target. [10]
    • It is easy to overshoot your target temperature, but difficult to go back down to it.
    • If the temperature is rising too fast, close the damper a little. The temperature will still rise, just at a slower rate.
  4. Any adjustments that you make to the intake damper or fuel won't happen immediately. Give it a couple minutes or hours before you try something new. [11]
  5. Meat will absorb more heat during earlier stages of cooking, resulting in slower temperature rises. As the meat cooks, it will absorb less heat, resulting in faster temperature rises. [12]
    • The temperature may spike as your fuel breaks down. It should climb back down after about 15 to 30 minutes.
  6. Advertisement
Part 3
Part 3 of 3:

Troubleshooting the Smoker

PDF download Download Article
  1. A dry run is where you run your smoker without any food. This will help you gauge how long it takes your smoker to reach a certain temperature. Write down how long it takes for your smoker to reach the right temperature. Keep this for future reference. [13]
    • Use a lid thermometer to keep track of the temperatures inside the smoker.
    • Some smokers have built-in thermometers, but these can be off by 50 °F (10 °C).
  2. Some parts of a smoker are much hotter than others. If you place your thermometer near these areas, you won't get an accurate temperature reading. [14]
    • Some thermometers, especially electric ones, are just inaccurate or go bad. You should replace it when this happens.
  3. If the temperature inside the smoker does not match the temperature on the damper, you may have a leak. This is especially common among cheap, barrel-shaped smokers. The leaks typically occur around seams. Once you find them, seal them with gaskets or food-safe silicone. [15]
    • If sealing leaks did not help, try using the exhaust damper instead of the bottom ones to adjust the temperature.
  4. If the inside of the bowl or ash catcher are dirty, you will have poor airflow, which can affect the temperature. The bottom damper should also be clean to reduce clogs. If it is clogged, then you won't have enough oxygen reaching your fire, resulting in low temperatures. [16]
    • If your smoker tends to run too hot, leave it smoky and greasy inside. This will make it less reflective and allow it to radiate heat outside the smoker. [17]
  5. If it is a hot or windy day, close the intake damper to reduce the temperature inside the smoker. If it is a cold day, open the damper to increase the temperature. If that doesn't help, try the following: [18]
    • Hot day: move the smoker out of sunlight or shield it with a canopy or patio umbrella.
    • Cold day: have extra fuel handy.
    • Windy day: work downwind or move the smoker next to a wall to shield it.
  6. If your intake damper is open and the temperature has not changed for several hours, give the charcoal or firewood a stir. If that doesn't help, add some more charcoal or firewood. [19]
    • Switch up the brand of fuel. Sometimes, that is all that you need to do. Not all brands are created equal. [20]
    • Lump charcoal tends to burn hotter and faster than coal briquettes. [21]
    • If the smoke is white, the wood may not be burning properly. Open the intake damper to allow more oxygen and create a hotter fire.
  7. Advertisement


Expert Q&A

Search
Add New Question
  • Question
    What are some ways I can lower the temperature of a smoker if it's too high?
    Mark Nichols
    Classically Trained Chef & BBQ Expert
    Mark Nichols is a Classically Trained Chef & BBQ Expert and the Owner of Arizona BBQ Company in Gilbert, Arizona. Mark has over 30 years in the hospitality and culinary industry. Mark and his wife, Colette, opened their first business, JC’s Catering in 2011, catering many private and corporate events. In September 2017, Mark and Colette opened their second business, Arizona BBQ Company, to share comfort food while infusing the flavors of the Southwest with their community. They are known for their high-quality smoked brisket, pulled pork, smoked chicken, St. Louis Ribs, smoked wings, Green Chile & Bacon Mac n’ Cheese, and signature Arizona BBQ sauces. Arizona BBQ Company has been featured on local news outlets including Fox 10 News, The New Times, East Valley Tribune, and Gilbert Sun Times. Additionally, Arizona BBQ Company had the pleasure of being featured on PBS’s "Check Please” hosted by Chef Mark Tarbell. Mark is a graduate of Scottsdale Culinary Institute, Le Cordon Bleu.
    Classically Trained Chef & BBQ Expert
    Expert Answer
    The easiest way is just cracking the door to let the heat out, depending on the kind of smoker. You can also scatter your coals, or you can put a pan of water at the very bottom. That will actually help regulate your temperature a little bit more evenly.
Ask a Question
      Advertisement

      Tips

      • Not all smokers are created equal. Even ones made by the same brand may have some imperfections.
      • Not all fuel is created equal. A charcoal briquette from 1 company may burn differently than a charcoal briquette made by a different company.
      • The dampers are the primary way to adjust the temperature inside the smoker.
      Show More Tips
      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Thanks for submitting a tip for review!
      Advertisement

      Things You'll Need

      • Smoker
      • Lid thermometer
      • Water
      • Charcoal or firewood


      Expert Interview

      Thanks for reading our article! If you’d like to learn more about barbecuing, check out our in-depth interview with Mark Nichols .

      About This Article

      Thanks to all authors for creating a page that has been read 70,277 times.

      Did this article help you?

      Advertisement