PDF download Download Article PDF download Download Article

Having an air conditioning unit in your home probably means that you have a condensate pump to help remove excess water that is given off when the system is running. This helps to remove dirty water from your home so it won’t contaminate the water that you drink. If you don’t already have one or if you need to replace one, here is a guide to install one.

  1. Before installing the pump, let the air conditioner run a few cycles so that some condensate collects and to remove any oils that are left in the system.
  2. Advertisement
  3.   It is always important to make sure that you turn then power off at the fuse box before installing any electrical components of appliances. [1]
  4. [2]
  5.   After all of the electrical is done, move to the next step.
  6.   The pump should have slots built onto the unit that will allow it to be mounted.  
  7. Make sure that the pump is close to the air conditioning unit, installed below the coil drain, and that the pump unit is level.   If the pump isn’t level, it will not function properly.  It is also important to make sure that the unit will not spray or splash when it is running.  Once the pump is mounted correctly, you are ready to pipe the unit.
  8.   This pipe should be installed so that gravity will do the work when the pump is draining the system.  The inlet pipe should be on an angle where it enters the tank and should not interfere with the operation of the float valve that the pump uses. [3]
    •   It may also be a good idea to install a check valve somewhere on the discharge line to avoid backflow of the discharge water so it can’t be sucked back into the a/c unit.  The discharge line should run into a line that goes to the city’s waste, once again to avoid contamination of fresh water.
  9.   Watch the pump and make sure that it is working correctly.  Ensure that the electrical units are working correctly without sparking and that the piping is not leaking in any area. [4]
    • The best way to test a condensation pump is to pour room temperature water into the pump's collection container. Once the container is filled, the pump motor will turn on and discharge water out.
  10. Advertisement

Community Q&A

Search
Add New Question
  • Question
    We changed the condensation pump, but now the air conditioner won't come on. What could be the problem?
    Community Answer
    It is probably and issue with the float valve/switch. Make sure your unit is level, then check the float to make sure it isn't sticking.
  • Question
    Where are the yellow wires found that are connected to the condensate pump on the air conditioner?
    Community Answer
    Cut the red wire from the furnace to thermostat and connect the yellow wires to the cut ends of the red wire. This way, if the condensate pump fails the safety switch (yellow wires), it will stop the furnace/AC and no more water from condensate will be generated. If heating or AC are a must, then connect the yellow wires to an alarm.
Ask a Question
      Advertisement

      Tips

      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Thanks for submitting a tip for review!

      Expert Interview

      Thanks for reading our article! If you’d like to learn more about air conditioning, check out our in-depth interview with Victor Belavus .

      About This Article

      Thanks to all authors for creating a page that has been read 93,021 times.

      Did this article help you?

      Advertisement