Download Article
Get resin and tar off your pipe or bowl with these easy cleaning hacks
Download Article
Does your glass pipe have a layer of dark residue coating the bowl or clogging the inside? After you smoke from your pipe a few times, the tar and resin stick to the glass and can make any hits you take feel harsher. Well with a few common household items, it’s a breeze to clean your pipe and make it look good as new. Keep reading, and we’ll cover the best ways to break down that sticky residue so you have smooth, clean draws the next time you smoke.
Need to clean a wooden tobacco pipe instead? We’ve got you covered !
Things You Should Know
- Put your glass pipe in a resealable plastic bag with rubbing alcohol, hydrogen peroxide , or distilled white vinegar so it’s completely submerged.
- Add coarse salt or baking soda to the bag to help scrub hard-to-reach places inside your pipe.
- ​​Shake the bag for 2–3 minutes to quickly clean out your pipe. For stubborn residue, let your pipe soak in the bag for 12 hours.
Steps
-
Tap any loose ash or residue into a trash can. If there are still any large chunks still inside your bowl, use a pipe cleaner or a toothpick to scrape them out. [1] X Research source
- Try rinsing your pipe with plain warm water since it can remove some of the buildup trapped inside.
-
Bring a small pot of water to a boil. Use enough water to completely submerge your pipe. As soon as the water is boiling, turn the heat down to medium-low. [2] X Research sourceAdvertisement
-
Soak your pipe in the boiling water for 20–30 minutes. Warm up the pipe in your hands or under warm water to ensure the temperature change doesn’t break it. Set your pipe in the pot so it’s completely underwater. [3] X Research source
- Keep your eye on the water level to make sure it doesn’t evaporate since the heat could cause it to crack. If the water level starts to get too low, add more warm water to your pot to cover your pipe.
-
Use a pipe cleaner or cotton swab to remove any remaining residue. Take your pipe out of the pot with a pair of tongs and hold it with an oven mitt. Run a cotton swab or pipe cleaner through your glass pipe to wipe away any resin that’s still trapped inside of it. Then, let it dry completely before using it to smoke. [4] X Research source
- Avoid rinsing your pipe underneath cold water since the quick temperature change could cause the glass to shatter.
- If you still see residue inside of your pipe, try boiling it again for another 20–30 minutes.
Advertisement
-
Remove any loose residue from your pipe. Hold your pipe upside-down over a trash can and gently tap the bottom so any loose particles fall out. Then gently scrape any stuck-on residue with a pipe cleaner , cotton swab, toothpick, or needle. [5] X Research source
- It’s okay if there’s still some residue left on your pipe. Getting rid of the larger loose chunks will just make the cleaning solution work more effectively.
-
Submerge the pipe with your cleaner in a resealable bag. Use rubbing alcohol for the fastest, most effective clean since it breaks apart resin the best. If you want to clean your pipe without alcohol, then use hydrogen peroxide or white distilled vinegar instead. [6] X Research source
- If you’re cleaning a bubbler pipe that has multiple pieces, take them apart and put them in separate bags to clean.
- Use 99% rubbing alcohol if you have some since it’s the strongest cleaner. It’s okay to use a lower concentration, but it may not strip all the resin and tar off of your glass pipe.
-
Add 1 tsp (7 g) of salt to the bag. Use coarse sea salt or Epsom salt if you have it since it will scrub away the resin easier. Otherwise, table salt will work if you need to clean your pipe quickly. [7] X Research source
- Salt acts like an abrasive on your pipe to clean out buildup that’s hard to reach inside your pipe.
- If you’re using vinegar, try adding baking soda instead of salt. It will still act as an abrasive, but it will also make a bubbling reaction that can help loosen residue on your pipe.
-
Shake the pipe in the bag for 2–3 minutes for a quick clean. Start by gently shaking the bag so some of the salt goes inside your pipe. Then, put your fingers over the openings and vigorously shake the bag for 2–3 minutes so the cleaning solution breaks apart the resin. [8] X Research source
- Hold onto your pipe firmly so it doesn’t slip out of your hands and break.
-
Soak the pipe in the solution overnight if it’s extremely dirty. If you still see buildup inside your pipe, leave it inside the bag and let it sit in the cleaning solution for about 12 hours. The next day, shake the bag to get rid of any buildup that’s still stuck on your glass pipe before dumping the cleaning solution out down the drain. [9] X Research source
-
Rinse the pipe out with hot water. Hold your pipe underneath hot water from your faucet to clean out any resin and leftover solution. Keep running water through your pipe until it comes out clear. [10] X Research source
-
Clean out any remaining spots with a pipe cleaner or cotton swabs. Dip the end of your pipe cleaner or cotton swab in your cleaner and gently rub it into any leftover stains. Give your pipe one final rinse when you’re finished and let it dry completely before smoking with it again. [11] X Research source
Advertisement
-
Try denture cleaning tablets for a quick clean. Put your glass pipe inside a plastic container and fill it up with enough hot water to submerge the bowl. Then, drop 2-3 tablets into the water and let your pipe soak for about 30 minutes. Scrub off any leftover residue with a pipe cleaner before rinsing the pipe with warm water. [12] X Research source
- Denture tablets may also help get rid of surface stains on the glass.
-
Use a dedicated pipe cleaning solution made for glass pipes. Read the instructions on the cleaning solution you get since they may vary between brands. Some will have you fill your pipe with the cleaner and shake it for 1–2 minutes to remove the residue. Others may have you soak your pipe in the solution for a few hours before rinsing it out. [13] X Research source
- Avoid using other household cleaners on your pipe since they could leave the taste of chemicals inside your pipe when you smoke from it.
-
Freeze the pipe to remove hard buildups. Put your pipe in the freezer for 30 minutes to an hour so the residue hardens up. Then, quickly scrape at the resin with a toothpick or needle to break it apart. Try to remove as much of the resin as you can within a few minutes before it starts feeling gummy again. [14] X Research source
- If the resin becomes sticky or hard to work with again, put it back in your freezer for another 30 minutes.
- Freezing your pipe might not be enough to completely clean it, but it will help remove large pieces of residue to make other cleaning methods more effective.
Advertisement
Expert Q&A
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Video
Tips
- Clean your pipe regularly once you start noticing stains and buildup so you can keep your piece shiny and sparkling. [15] X Research sourceThanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Thanks for submitting a tip for review!
Advertisement
Warnings
Advertisement
Things You’ll Need
Rubbing Alcohol, Vinegar, or Peroxide
- Pipe cleaners , cotton swabs, or toothpicks
- 99% rubbing alcohol , hydrogen peroxide or distilled white vinegar
- Coarse salt or Epsom salt
- Resealable plastic bag
Boiling Water
- Pot
- Pipe cleaners , cotton swabs, or toothpicks
References
- ↑ https://www.slyng.com/blog/how-to-clean-a-glass-pipe
- ↑ https://marijuana-science.com/how-to-clean-a-pipe/
- ↑ https://youtu.be/LbwAub4Uz8k?t=192
- ↑ https://marijuana-science.com/how-to-clean-a-pipe/
- ↑ https://www.slyng.com/blog/how-to-clean-a-glass-pipe
- ↑ https://www.canncentral.com/clean-glass-pipe
- ↑ https://www.canncentral.com/clean-glass-pipe
- ↑ https://spoonpipe.com/how-to-clean-spoon-pipe/
- ↑ https://www.canncentral.com/clean-glass-pipe
- ↑ https://youtu.be/wMJDl--MXlM?t=470
- ↑ https://spoonpipe.com/how-to-clean-spoon-pipe/
- ↑ https://theweedblog.com/guides/how-to-clean-your-pipe-or-bong
- ↑ https://marijuana-science.com/how-to-clean-a-pipe/
- ↑ https://www.slyng.com/blog/how-to-clean-a-glass-pipe
- ↑ https://revelandrouse.com/lifestyle/methods-to-clean-your-glass-pipe/
- ↑ https://www.slyng.com/blog/how-to-clean-a-glass-pipe
- ↑ https://youtu.be/LbwAub4Uz8k?t=208
About This Article
Article Summary
X
To create a pipe cleaning solution, fill a resealable plastic bag with rubbing alcohol and kosher salt. Before cleaning your glass pipe, hold the bowl upside down and tap it to remove any loose debris. Then, submerge your pipe in the solution and let it sit for several hours, shaking the bag vigorously when your first put the pipe in and before you remove it. Once the pipe looks clean, take it out of the solution and rinse it under hot water. To learn how to clean your pipe in boiling water, scroll down!
Did this summary help you?
Thanks to all authors for creating a page that has been read 2,613,230 times.
Reader Success Stories
- "I clean with alcohol, but didn't know to use salt or remove resin by freezing! I was given a pipe in bad shape: resin build-up, hard plaster Iick, ect. With your help it's sparkling clean in less than 3 hours, thanks! (Freeze, Scrape, Soak, Wipe/Clean, Rinse, Wipe/Dry)" ..." more
Advertisement
90%
of readers found this article helpful
.
Click a star to add your vote
% of people told us that this article helped them.
"I clean with alcohol, but didn't know to use salt or remove resin by freezing! I was given a pipe in bad shape: resin build-up, hard plaster Iick, ect. With your help it's sparkling clean in less than 3 hours, thanks!
(Freeze, Scrape, Soak, Wipe/Clean, Rinse, Wipe/Dry)"
..."
more
"I used this site to see how to make a water pipe. It was useful, and I love my bong. I did make a few tweaks of my own to it, though. I used glass and metal as much as I could. I don't like smoking anything from plastic, even if covered by tinfoil."
..."
more
"I do weekly cleaning with alcohol and salt. To save time, I store my Ziploc bag of solution in a small mason jar in a drawer, which can last a good number of uses if the pipe is cleaned regularly."
..."
more
"What was surprising was the denture tablets, never even thought that those would be used to clean a pipe with. I am gonna try the denture solution to see how it does. Thank you for all the tips!"
..."
more
"This gave easy to follow directions, I used the boiling water method because I wanted to save my resin this time and I had read that boiling water was the best way to do that."
..."
more
