PDF download Download Article PDF download Download Article

Knee flexion is the degree to which you can bend your knee. Knowing your knee flexion limit can help you to assess your range of motion, which may be helpful if you’re recovering from an injury or surgery. [1] You can assess your knee flexion and extension at home using a goniometer or a phone app meant to simulate a goniometer. If you don’t have either of these tools, you can also estimate your knee flexion and extension using your fingers and a measuring tape.

Method 1
Method 1 of 2:

Using a Goniometer

PDF download Download Article
  1. Find a carpeted patch of floor to lie down on, or place a yoga mat on a hard floor before you lie down. You could also place a folded blanket or a couple of towels on the floor and lie down there.
    • Avoid lying on a bed or sofa as these will not be firm enough to keep your body aligned.
  2. Ensure that the circular disc at the center of the goniometer is against the side of your knee. Position the stationary arm of the goniometer along your outer thigh so it’s in line with your greater trochanter, or the bone at the end of your femur that connects to your hip. Position the other arm of the goniometer with the lateral malleolus, which is the protrusion on the outside of your ankle.
    • Goniometers can be easily purchased on Amazon, and are essentially two rollers joined end to end. [2]
    • You may find it easier to have a friend do this for you.
    • If you’re using a phone app, check the app’s instructions for how to use it first. Phone apps work by identifying the angle of your phone when held against your thigh and then against your calf, so you’ll be instructed to position it along your thigh first and then along your calf.

    Tip : Goniometer phone apps are available for free in the app store for your device. The accuracy of these apps is comparable to an actual goniometer. [3]

    Advertisement
  3. Start by checking to see if you can extend your knee. Straighten out your leg so the back of your knee is against the floor or as close as you can comfortably get it to the floor. Check the goniometer or phone app’s angle to see your reading. Then, repeat for the other knee.
    • If your knee is fully extended, the goniometer will be at 0 degrees.
    • Your knee is hyperextended if it’s -5 degrees or lower, and it’s under-extended if it’s 5 degrees or more.
  4. Keep going until you reach the maximum point of your knee flexion abilities. Look at the reading on the goniometer or phone app to see what angle your knee can flex to. Then, repeat the measurement on your other knee.
    • Keep in mind that normal knee flexion varies depending on the medical organization. For example, the American Academy of Orthopedic Surgeons defines normal knee flexion as 141 degrees plus or minus 5.3 degrees, while the American Medical Association defines it as 150 degrees.
    • Loss of flexion over time is usually due to arthritis in the knees, which causes there to be a loss of space between the thigh and shin bones. [4]
  5. Advertisement
Method 2
Method 2 of 2:

Estimating Range of Motion

PDF download Download Article
  1. You can either lay on a carpeted floor or place a yoga mat or folded towel or blanket on a patch of hard floor before you lay down. However, don’t use a bed or sofa to do this as they are not firm enough to keep your body in a straight line.
    • You can also sit up with your legs stretched out in front of you if you prefer.
  2. Place your palm flat on the ground beside your knee and then try to slide your fingers under your knee starting with your index finger. Keep your knee pressed as flat against the ground as possible as you do this. Use the number of fingers you can fit under your knee to determine the approximate angle of your knee when it’s extended. The approximate angles are as follows: [5]
    • 2 fingers: 0 degrees
    • 4 fingers: 5 degrees
    • Whole hand: 10 degrees
    • Can’t get any fingers under your knee: -5 degrees or hyperextension
  3. To estimate the flexion of your knee, bend it as far as it will go comfortably while keeping your foot flat on the ground. Inch your heel closer and closer to your buttocks until it won’t go any further.
  4. Repeat for the other knee when you finish measuring the first knee’s flexion. Note that this will not give you an angle, but it can provide a starting point to help track your progress. For example, if you can get your heel within 3 in (7.6 cm) of your buttocks, then you likely have full knee flexion, which is 155 degrees. [6]
    • If the distance between your heel and buttocks decreases over time, your knee flexion is improving.

    Tip : It might be easier to have a friend measure the distance for you, or you can place a piece of paper under your buttocks and mark it with a pencil where your buttocks and heel are located. Then, measure the distance after you get up.

  5. Advertisement

Expert Q&A

Search
Add New Question
  • Question
    How do you measure knee flexion?
    Jonathan Frank, MD
    Sports Orthopedic Surgeon & Joint Preservation Specialist
    Dr. Jonathan Frank is an Orthopedic Surgeon based in Beverly Hills, California, specializing in sports medicine and joint preservation. Dr. Frank's practice focuses on minimally invasive, arthroscopic surgery of the knee, shoulder, hip, and elbow. Dr. Frank holds an MD from the University of California, Los Angeles School of Medicine. He completed an orthopedic residency at Rush University Medical Center in Chicago and a fellowship in Orthopedic Sports Medicine and Hip Preservation at the Steadman Clinic in Vail, Colorado. He is a staff team physician for the US Ski and Snowboard Team. Dr. Frank is currently a scientific reviewer for top peer-reviewed scientific journals, and his research has been presented at regional, national, and international orthopedic conferences, winning several awards including the prestigious Mark Coventry and William A Grana awards.
    Sports Orthopedic Surgeon & Joint Preservation Specialist
    Expert Answer
    The best way to measure flexion is with a mirror and a goniometer. Put the articulating arm of the goniometer at the hinge of your knee, with one arm going down along the shaft of your shin bone. The other arm should go along the side of your thigh. Then, stand sideways to a mirror, bend your knee back, and see how far it goes.
Ask a Question
      Advertisement

      Tips

      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Thanks for submitting a tip for review!

      Things You’ll Need

      Using a Goniometer

      • Goniometer or goniometer phone app

      Estimating Range of Motion

      • Measuring tape
      • Paper (optional)
      • Pencil (optional)

      References

      1. Jonathan Frank, MD. Sports Orthopedic Surgeon & Joint Preservation Specialist. Expert Interview. 31 July 2020.
      2. Jonathan Frank, MD. Sports Orthopedic Surgeon & Joint Preservation Specialist. Expert Interview. 31 July 2020.
      3. https://www.ncbi.nlm.nih.gov/pubmed/23499407
      4. Jonathan Frank, MD. Sports Orthopedic Surgeon & Joint Preservation Specialist. Expert Interview. 31 July 2020.
      5. https://bonesmart.org/forum/threads/rom-range-of-motion-information.3730/
      6. https://bonesmart.org/forum/threads/rom-range-of-motion-information.3730/

      About This Article

      Thanks to all authors for creating a page that has been read 100,289 times.

      Did this article help you?

      Advertisement