Q&A for How to Make a Network Cable

Return to Full Article

Search
Add New Question
  • Question
    Can Cat5e cables be wired in series, or should they be parallel for different jack locations?
    Community Answer
    Cat5e for network purposes is used in point-to-point topology. Simple: one socket or jack equals one wire.
  • Question
    How do I strip the cable ends?
    Community Answer
    You should use a wire stripper. However, it is possible to do it with scissors, with a bit of force and hassle.
  • Question
    What is the difference between cut five and cut six?
    Community Answer
    The wire thickness and the procedure of making a custom cable is a tad different.
  • Question
    I would like to wire to a guitar-plug for a stylish design. Is it possible to use only three cables for browsing?
    Community Answer
    No, this is not possible. You can't plug a guitar-plug into a Ethernet port. Also, in order to have a working connection, you need to use all cables.
  • Question
    Does the direction matter? Right to left or left to right?
    Audriusa
    Community Answer
    Surprisingly, not if you wire both plugs of the cable in the same direction. But if you wire one end in one direction and another in another, such a cable will not work.
  • Question
    How do you know which cable you're using (if it's 568 A or B)?
    Audriusa
    Community Answer
    The connector's housing is transparent. You can look through the connector inside to see the order of wires. This only matters if you need to replace one of the plugs.
  • Question
    How can you extend an Ethernet cable?
    Mark Ftth
    Community Answer
    Purchase an Ethernet coupler. This is a small device that connects two Ethernet cables together. Be sure you have an additional Ethernet cable of the same category (e.g., Cat5e, Cat6) as your existing cable. Plug one end of your existing Ethernet cable into one side of the coupler and the other end of the additional Ethernet cable into the other side. Once connected, check if your network connection is working properly. Alternatively, you can use a longer Ethernet cable directly if you prefer not to use a coupler.
Ask a Question

      Return to Full Article