Download Article
Download Article
Correction fluid is for "whiting-out" ink mistakes on paper. From lack of use or forgetting to put the cover or cap on, the fluid will dry-up. You can prolong the life of your white-out products by hydrating the liquid.
Steps
-
Add a little water. Add water or correction fluid thinner to the bottle it dries up. Put on the cap and shake it. -
Try using some non-acetone nail polish remover. Open your bottle of correction ink. Use an eyedropper to add three drops of a non-acetone nail polish remover into the bottle. Close the bottle and shake it to mix everything up. Open the bottle and test the ink. [1] X Research source- If the ink is still too thick, add two more drops of the nail polish remover.
Advertisement -
Try using a white-out thinner. You can buy it in an office supply store. Use an eye dropper to add three drops of the thinner into the bottle of correction ink. Close the bottle and shake it to mix everything up. Test the ink on a sheet of paper. [2] X Research source- If it is still too thick, add two more drops of the thinner. Be sure to close the bottle and shake it before testing the ink again.
- You may also find the thinner labeled as "correction ink thinner" or "correction fluid thinner."
Advertisement
-
Check the nib first. Sometimes, it's just a thin layer of ink that has dried over the nib, and the ink inside the pen is just fine. -
Try scratching dried ink off of the nib. [3] X Research source If there is dried ink covering the nib, use your fingernail to gently scratch the ink off. A thin layer of dried ink can prevent fresh ink from flowing out. -
Give the pen a shake and test it out. This will help dislodge any blockage that is inside the ink. Once you have given the pen a few shakes, try drawing with it and seeing if any ink comes out. [4] X Research source -
Take the pen apart if the blockage is inside the tube. This may require you to remove the top and bottom sections, depending on how the pen is designed. Use something long and thin, such as a knitting needle or a chopstick to remove the clot. -
Consider thinning the ink out inside. You can use a few drops of water or a non-acetone nail polish remover. -
Consider refilling the ink with fresh ink. If the ink inside the pen has mostly dried out and you can't restore it, you can try pouring in fresh correction ink. Get a bottle of white correction ink, and pour a little bit into the pen capsule. -
Put the pen back together and give it a shake. If necessary, seal any parts that don't stay together with super glue. -
Know what to do if the ball point is simply stuck. Sometimes, a correction ink pen won't write simply because the little ball in the tip is stuck. You can loosen it in two ways:- Draw circles with it in a small puddle of olive oil or baby oil.
- Soak the tip in a cup of warm water for about 10 minutes.
Advertisement
-
Keep the lid on the bottle when you are not using it. Any air that gets into the bottle will cause the ink to harden and dry. The longer you leave the bottle open, the thicker the ink will become. -
Keep a correction pen capped. [5] X Research source Even though the ink is inside the pen capsule, you'll still want to keep the cap on. Not only will this prevent the pen from leaking, but it will also keep ink from drying out on the nib too fast. It the ink dries on the nib, you might end up with a blockage. -
Consider wiping the inside neck of the bottle with nail polish remover. From time to time, you might want to open up your bottle of correction fluid, and wipe the neck part, right where the threads are. Soak a folded paper towel with some nail polish remover and wipe it around the neck. This will remove any excess ink that might have dried up on the neck of the bottle. It will help keep the cap tightly closed and prevent any air from getting inside. -
Consider cleaning the nib of a correction ink pen from time to time. Every so often, run the pen across some paper. You can also scratch off any ink that is starting to dry on the ball point with your fingernail. This will help prevent any blockages. -
Store correction ink pens upright in a jar. The tip should be pointing upward. If you store it on its side or upside down, the ink may flow into the nib and dry out. -
Keep the correction fluid in a cool, dry place. Keep it out of sunlight and heat, as both can cause the ink to dry and harden.
Advertisement
Community Q&A
Search
-
QuestionHow do I remove White-Out from clothing?Community AnswerFirst, scratch off as much as you can with your fingernail. Then, dab at it with a paper towel soaked in nail polish remover before washing the clothing normally.
-
QuestionWhat happens if I get correction ink on my skin? Is it harmful?Community AnswerNothing bad happens, and it doesn't cause permanent damage. You can simply remove it using soap or alcohol.
-
QuestionHow do I restore dried gel in colored pens?Community AnswerDip the tip in hot water for 1-3 minutes. If that doesn't work, take the ink cartridge out and blow on it.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Tips
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Warnings
- Sometimes, dried up correction ink is beyond salvaging. If the ink has completely dried out, you might have to replace it.Thanks
Advertisement
References
- ↑ https://careertrend.com/how-2063096-thin-out-thick-correction-fluid.html
- ↑ https://careertrend.com/how-2063096-thin-out-thick-correction-fluid.html
- ↑ https://office-ink.ontimesupplies.com/helpful-hints/how-to-revive-dried-out-pens-5-tips/
- ↑ https://careertrend.com/how-to-fix-a-roller-ball-pen-13649106.html
- ↑ https://www.uhubostik.it/images/uploads/uhu/st-D8791.pdf
About This Article
Article Summary
X
If your correction ink, or white-out ink, has dried up, you can still rehydrate it to get some use out of it. Try adding a few drops of water, putting the cap on, and shaking the bottle up. If it’s still too thick, add 2-3 drops of non-acetone nail polish remover and shake it up. If you want to fix a correction ink pen, scratch any dried ink off the nib of the pen, which should allow fresh ink to flow again. If this doesn’t help, give the pen a shake to dislodge any blockage inside the pen. To learn how to prevent your correction ink from drying out, read on!
Did this summary help you?
Thanks to all authors for creating a page that has been read 165,465 times.
Reader Success Stories
- "I've been trying to look this answers up for a day because I need to reuse my dried up liquid eraser in the bottle, I usually use liquid pen eraser now. Thank you for your help." ..." more
Advertisement
"I've been trying to look this answers up for a day because I need to reuse my dried up liquid eraser in the bottle, I usually use liquid pen eraser now. Thank you for your help."
..."
more
"It is good to know the thinner and nail polish remover can be added to whitener."
"Only place I found clear tips of long-term storage of correction fluid pen."
"This article helped me a lot."
