How to Shrink a Bathing Suit

PDF download Download Article
Tips to shrink swimsuit bottoms, tops, & one pieces
PDF download Download Article

Whether your bathing suit is too large because you lost weight, bought the wrong size, or stretched out the material over time, you may want to shrink the suit rather than investing in a new one. Bathing suits are most often made of materials like lycra, spandex, polyester, and nylon, which make it harder to shrink the fibers, but it’s not impossible! Try using boiling hot water to soak your suit and then put it through a hot cycle in the dryer, or try ironing a damp suit on low heat to gradually shrink the material. It may require a couple of attempts, but you should be able to shrink your suit down to the size you prefer.

How to Shrink a Swimsuit

  1. Turn your swimsuit inside out and hand wash it in cool water.
  2. Soak your swimsuit in a pot of boiling water to shrink the fibers.
  3. Let your swimsuit simmer in the water for 15 to 20 minutes.
  4. Remove your swimsuit, then place it in the dryer on the highest setting.
  5. Repeat this process 2 to 3 times to shrink your swimsuit gradually.
Method 1
Method 1 of 3:

Shrinking Your Swimsuit in the Dryer

PDF download Download Article
  1. Before washing, boiling, and drying your suit, make sure it’s turned inside out. Doing so will keep the colors from running and your suit should maintain its original hues. [1]
    • If there are any bra inserts, go ahead and remove them at this time.
  2. Fill up the sink with cool water, and use a mild laundry detergent that doesn’t have any bleach or dyes in it. Wash the bathing suit in the soapy water, then drain the sink and use fresh water to rinse the suit until there are no more suds. If there is residual sunscreen, sweat, oil, sand, or grime on your suit when it goes into the dryer later, that could get baked into the material and make your suit hard and inflexible, so it’s important to clean it beforehand.
    • Avoid putting your suit in the washing machine, as the rough tumbling could stretch out the fibers in the suit.
    • You can give your swimsuit for dry cleaning.
    • A dry cleaner uses different products to wash them, like fabric softeners and brighteners, and the detergent quality is much better.
    • This type of washing is not as abrasive as washing in your home washer.
    Advertisement
  3. Soak the suit in boiling water until the water cools to room temperature. Use a kettle, the microwave, or a pot on the stove to boil water (make sure to use a large pot or dish that won’t break from the heat). Submerge the suit completely in the boiling water and let it sit in there until the water cools down, which should take about 15 to 20 minutes. [2]
    • The heat from the boiling water should start to shrink the fibers in the suit and prepare it for further shrinkage once it goes into the dryer.
  4. For optimum shrinkage, use the highest setting and the longest time that you can choose. Avoid drying the suit with a full load of laundry, as you want it to receive the highest blast of heat so that it can shrink down as much as possible. [3]
    • Most dryers can run for 60 to 70 minutes before they shut off.
  5. Instead of taking the hot garment right out of the machine and putting it on, set it to the side to let it cool off. The elastic can hold a lot of heat and might burn you if you were to put it on right away. [4]
    • It shouldn’t take more than 10 minutes for the suit to cool off.
  6. Try the suit on after it has dried completely to see if it’s at the right size yet. If so, that’s great and you’re ready to enjoy your improved suit! If it’s still too big, go ahead and repeat the boiling and drying process a few more times (there’s no need to wash the suit again as it’s already clean). [5]
    • If the suit doesn’t shrink enough after 3 washes, it may be time to consider getting it tailored or perhaps just investing in a new suit.

    Warning: Don’t use this method too often, as the high heat will eventually dull the color of the suit and can make it less durable.

    7. Advertisement
Method 2
Method 2 of 3:

Ironing Your Swimsuit

PDF download Download Article
  1. Use cool water and mild laundry detergent that’s free of bleach and added dyes to wash your suit if it isn’t already clean. Fill the sink with cool water and apply the soap directly to your suit. Massage the material in the water to create suds and clean away any grime. Drain the sink, then use fresh water to rinse the suit until no more suds are visible. Squeeze the suit by hand until the suit is just damp instead of drenched. [6]
    • If you iron a dirty suit, you are essentially baking in any residual salt, sand, sweat, sunscreen, or lotions you may have come into contact with the last time it was worn.
  2. If you don’t have a cotton cloth specifically for ironing, you could also use a handkerchief or some other kind of scrap fabric, just as long as it is clean and made of cotton. Never put the iron directly onto the damp bathing suit, as that will damage the material. [7]

    Tip: Even an old pillowcase or sheet will work in a pinch, so don’t feel you need to go out and buy a new cotton cloth if you don’t have one at home.

  3. To avoid damaging the swimsuit, avoid using high heat. It’ll take a little longer to iron and dry the suit, but in the end, your suit will be in better condition. [8]
    • You don’t need to fill the steamer basket in the iron for this process. Because the suit is already wet, you won’t need to add moisture to it.
  4. Because you’re using a low-heat setting, be prepared to iron your suit for upwards of 10 minutes. Work systematically from the top to the bottom of the suit, using long, even strokes. Press down with force so that the heat of the iron penetrates through the protective cloth and hits the swimsuit. [9]
    • Even though the iron isn’t exuding a ton of heat, still be careful to not catch your fingers or grab the bottom of the iron with your bare hands. It’ll still be hot enough to burn you!
  5. Make sure to work both sides of the suit so you don’t end up with one side that shrunk and one side that is still the original size. Try flipping the suit over after going from top to bottom completely. [10]
    • You may also want to wipe off the ironing board with a clean, dry towel when you flip the suit over. If there is excess moisture on the board, you don’t want it getting absorbed back up into the side you were just working on.
  6. It may take 10 minutes or more, so settle in at the ironing board. Continue using adequate pressure and alternating sides so that the suit dries as quickly as possible. Once the majority of the water is gone and the suit is almost completely dry to the touch, you can stop. [11]
    • If you dread the idea of ironing for that long, watch a show or listen to some music while you work—it’ll help the time pass more quickly.
  7. Avoid putting your suit into the sun as the heat could mutate the colors and weaken the elastic. Leave it on the ironing board, or hang it up on a clothesline to let it finish drying. Once it is completely dry to the touch, go ahead and try it on. If it isn’t as small as you’d like, go ahead and repeat the ironing method another 1 to 2 times. If it isn’t shrunken enough after those efforts, it may be time to take it in by hand or invest in a new suit. [12]
    • You could pop the suit into the dryer on high heat for about 20 minutes to finish drying it. This could help the material to shrink even more, but letting it air dry will be gentler on the material.
    8. Advertisement
Method 3
Method 3 of 3:

Preventing Stretching

PDF download Download Article
  1. Sunscreen, lotions, oils, sand, and sweat all need to be washed away on a regular basis to keep your suit in tiptop condition. You may think if you didn’t go into the water and there’s no chlorine or salt on your suit that it doesn’t need to be washed, but the fibers and elastics will be in much better condition for a longer time if you give the suit a quick wash after every use.
    • Build-up of grime can cause the elastic fibers to deteriorate more quickly over time.
  2. Avoid using the washing machine if at all possible, as the tumbling motion can stretch your suit and damage the elastic fibers. Use your sink or a bucket to scrub your suit by hand with a mild laundry detergent that is free of bleach and dyes. Once it has been washed, use clean water to thoroughly rinse the suit until all the suds are gone.

    Warning: Never use bleach on your suits. You don’t want to get bleach on your skin, plus the bleach will discolor your suit and will also weaken the fabric, making it more likely to tear.

  3. After your suit has been washed, go ahead and lay it out somewhere to dry. Avoid putting it over a metal pole, like what you might have in your bathroom, as the metal could react with the material and stain it. Instead, use a clothesline and clothespins to hang the suit by its straps.
    • A dryer is a great way to shrink a suit, but at the same time, it can also weaken the fibers because of the tumbling and the high heat. It’s something that shouldn’t be used very often so that your suit stays in the best condition possible.
  4. It may be super tempting to lay your suit out in the sun to let it dry naturally once you’re finished wearing it, but avoid doing this if you can. In addition to fading the color of your suit, the sun can also weaken the elastic and make your suit less durable over time.
    • If on occasion you can’t avoid using the sun to dry your suit, that is okay. Just make it a point to not do it every time.
  5. Concrete, pool chairs, and other materials that are often around swimming areas can snag the fibers of your suit, break them, and cause them to weaken over time. Avoid this by laying a towel down before you sit on a chair or on the ground.
    • If you don’t have a towel available, pull on a coverup or something similar before you sit down so that your suit doesn’t come into contact with any rough materials.
    6. Advertisement

Expert Q&A

Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
      Advertisement

      Video

      Tips

      • If these options don’t work for your suit, you may want to consider having the suit tailored or taking it in yourself, especially if it’s still in good condition.
        Thanks
        Helpful 0 Not Helpful 7
      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Submit
      Thanks for submitting a tip for review!
      Advertisement

      Things You’ll Need

      Using the Dryer

      • Mild soap
      • Clean bucket or sink
      • Teakettle or microwave
      • Dryer

      Ironing Your Suit

      • Mild soap
      • Cotton cloth
      • Ironing board
      • Iron

      You Might Also Like

      How to
      Put on a Bikini
      How to
      Change Into Your Bathing Suit if You Aren't in a Stall (Girls)
      How to
      Look Good in a Speedo
      How to
      Stop Goggles from Fogging Up: DIY & Commercial Options
      How to
      Make a Bikini
      How to
      Try on a Bikini
      How to
      Look Slim in a Swimsuit
      How to
      Measure Your Swimsuit Size
      How to
      Wear a Bikini Confidently
      How to
      Make a Swimsuit
      Advertisement

      References

      1. ↑ https://youtu.be/gMmskYJqVPg?t=259
      2. ↑ https://youtu.be/gMmskYJqVPg?t=240
      3. ↑ https://youtu.be/gMmskYJqVPg?t=348
      4. ↑ https://swimzip.com/blogs/beach-life/how-to-shrink-a-swimsuit
      5. ↑ https://swimzip.com/blogs/beach-life/how-to-shrink-a-swimsuit
      6. ↑ https://swimzip.com/blogs/beach-life/how-to-shrink-a-swimsuit
      7. ↑ https://swimzip.com/blogs/beach-life/how-to-shrink-a-swimsuit
      8. ↑ https://homequicks.com/how-to-shrink-polyester
      9. ↑ https://homequicks.com/how-to-shrink-polyester
      1. ↑ https://homequicks.com/how-to-shrink-polyester
      2. ↑ https://homequicks.com/how-to-shrink-polyester
      3. ↑ https://homequicks.com/how-to-shrink-polyester

      About This Article

      Article Summary X

      Before you try to shrink a bathing suit in the dryer, turn it inside out, so the colors are less likely to run. If there are bra inserts, take them out as well. Wash the suit by hand in cool water to remove any dirt or grime. Once your suit is clean, submerge it in a pot of boiling water, turn off the heat, and leave the suit to soak until the water cools to room temperature. This will begin to shrink the suit and prepare it for further shrinkage. After 15 to 20 minutes, place the suit into your dryer, and set it to the highest setting and longest time possible. When the dry cycle finishes, let the suit cool off for 10 minutes, then consider repeating the process if it's still too big. For more tips, like how to shrink a bathing suit by ironing it, scroll down!

      Did this summary help you?
      In other languages
      Thanks to all authors for creating a page that has been read 220,827 times.

      Did this article help you?

      Advertisement