PDF download Download Article PDF download Download Article

Sweaters are warm and cozy, but they don't last forever. Instead of throwing an old sweater out, why not turn it into something new? With a simple pattern and a few minutes' time, you can have a pair of warm, cozy gloves to wear throughout the season!

Part 1
Part 1 of 2:

Making Basic Mittens

PDF download Download Article
  1. Place your hand onto a sheet of paper. Keep your fingers together and your thumb sticking out at an angle. [1] Trace around your hand, leaving a 1-inch (1.27-centimeter) space around it. [2] Don't make the base too narrow, or you will have troubles slipping the mitten on and off. Cut the pattern out when you are done.
    • Use regular scissors to cut the pattern, not your fabric scissors.
    • You are adding the extra space for wiggle room and seam allowance.
    • Keep your lines and curves smooth. You don't have to make the little bumps for the fingers. Think: basic mitten shape.
  2. Place the sweater into a pillowcase. Wash it in the washing machine using hot water. [3] Dry it in the dryer using a high temperature. Repeat this 3 to 4 times for best results. [4] This will felt the wool, making it cozier and easier to work with.
    • The sweater will shrink. Don't worry, this is fine.
    • Choose a sweater that is at least 80 percent wool; 100 percent would be even better. [5]
    Advertisement
  3. Align the bottom, palm part of your pattern with the top edge of the ribbed hem. The ribbed hem will make a cuff around your wrists. This will make it easier to tuck your mittens into your coat while you are wearing them, and lock in the warmth.
  4. When you are done, flip the pattern over, pin it in place, then cut out the other mitten. This will give you a left and right mitten. When you are done, you should have four pieces.
  5. Flip the mitten pieces over. Pin them together with the right sides facing in and the wrong sides are facing out. You do not have to pin across the bottom edge.
  6. Use a small zigzag stitch and follow the lines that you drew. This will allow the fabric to stretch without snapping the thread. [6] Backstitch a few times at the start and end of your sewing. Do not sew across the bottom edge.
  7. This will help reduce bulk and make the mittens more comfortable to wear. [7] If you'd like, you can go over the edges with a small zigzag stitch.
  8. Tuck your hand into it and wiggle your fingers. This will help push out the seams and fill it out.
  9. You can decorate it with embroidery thread and buttons. [8] Here are some ideas to get your started:
    • Use embroidery thread in a contrasting color to make a blanket stitch around the bottom hem of your mitten. Keep the stitches loose, or your mitten won't stretch.
    • Add simple embroidery to the top/front of each mitten.
    • Braid some yarn, then weave it around the wrist of your mitten to make a tie cord. Attach a matching pompom to each end of the cord.
    • Fold the cuff over to shorten it, then sew a wood or plastic button on top.
  10. Advertisement
Part 2
Part 2 of 2:

Adding a Lining (Optional)

PDF download Download Article
  1. Fold your lining in half. Pin the pattern ½ inch (1.27 centimeters) away from the bottom edge of your lining. The lining will stop at the wrist. You are adding the extra ½ inch (1.27 centimeters) for the hem.
    • Great lining choices include: flannel, fleece, and jersey/t-shirt fabric. You can buy it from the fabric store, or reuse old shirts or blankets.
  2. When you are done, flip the pattern over, and cut out another set of lining pieces. You should have four pieces when you are done.
  3. Make sure that you are pinning the mittens with the right sides facing in and the wrong sides facing out.
  4. Use a simple straight stitch for this. Be sure to backstitch at the start and end of your sewing and to remove the pins as you sew. Do not sew across the bottom of the mittens.
    • If you are using jersey or t-shirt material, use a small zigzag stitch instead.
  5. Try to get them down to about â…› to ¼ inch (0.32 to 0.64 centimeter). This will help reduce bulk and make your mitten more comfortable to wear. For a neater finish, go back over the edges with a small zigzag stitch.
  6. Fold the bottom edges up by ½ inch (1.27 centimeters) all the way around each mitten lining. Pin them in place.
  7. Use a simple straight stitch if you are using flannel or fleece, and a small zigzag stitch if you are using jersey or t-shirt material. If you wish to add an elastic, do the following:
    • Leave a ½-inch (1.27-centimeter) gap in the hem.
    • Thread a piece of elastic through the gap with a safety pin.
    • Pull the elastic until the hem gathers slightly.
    • Cut the excess elastic, then stitch the ends together.
    • Tuck them into the gap. Sew the gap shut.
  8. Do not turn your lining inside out. This way, your lining will be smooth on the inside. The raw hems will be covered by the mittens.
  9. Set your lining down on the table with the matching mitten piece across from it, hems overlapping. Stitch the two thumbs together at the hems. Stitch the two finger pieces together at the top center, also at the hems. This will help keep the lining in place when you pull the gloves off.
    • Repeat this step for the other mitten and lining piece.
  10. Tuck your hand into the lining. Roll the mitten over your hand, like a sock. Adjust it until the seams match up and the fit is comfortable.
  11. If you added an elastic to the hem, keep the elastic pulled taut while you sew and use a larger zigzag stitch. Alternatively, you can stitch it by hand with a loose running stitch
  12. Advertisement


Community Q&A

Search
Add New Question
  • Question
    Where is the link to download this pattern?
    MoJo 422
    Community Answer
    This article does not supply a pattern. It tells you how to make your own.
  • Question
    Can I use a sweater that is 85% wool and 15% nylon?
    MoJo 422
    Community Answer
    Yes. The higher the wool content, the warmer and drier they will be, but 85% is great.
Ask a Question
      Advertisement

      Tips

      • If you have small hands, you can make your mittens from the sleeves of the sweater instead.
      • You can use a sweater vest instead of a regular sweater.
      • If you cannot find a wool sweater, you can use one that is acrylic or a lower wool content. You will not be able to felt it, however.
      Show More Tips
      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Thanks for submitting a tip for review!
      Advertisement

      Things You'll Need

      • Wool sweater (at least 80% wool, preferably 100%)
      • Paper
      • Pen or pencil
      • Regular scissors and fabric scissors
      • Sewing machine (or needle if hand sewing)
      • Thread (or embroidery thread if hand sewing)
      • Sewing pins
      • Buttons and embroidery thread (optional, for decorating)
      • Lining fabric, such as fleece, flannel, or jersey (optional)
      • Thin elastic, optional


      Expert Interview

      Thanks for reading our article! If you’d like to learn more about sewing and tailoring, check out our in-depth interview with Shaelynn Haning .

      About This Article

      Thanks to all authors for creating a page that has been read 134,232 times.

      Did this article help you?

      Advertisement