Download Article
Download Article
RAID is a great way to add additional security and redundancy to a computer workstation. A RAID array is a setup of two or more hard drives that have been synchronized to provide protection against data loss due to a malfunctioning hard drive. Nowadays, most newer motherboards support RAID, and it is no longer as expensive or difficult to set up as it was in the past. In this article, you'll learn how to setup and how to configure RAID on your computer.
Steps
-
Keep in mind when you are handling the inner parts of any computer or its components make sure the power source is turned off and unplugged. Also, make sure you have yourself grounded to prevent damage from static electricity.- Making sure that the computer has been shut off and unplugged will prevent accidental damage to the computer parts as well as accidental injury to the user.
- Grounding yourself will prevent accidental shock damage generated by static electricity.
- When handling any electrical computer component, don't touch any of the metallic chips or circuitry. The oils on your hands and fingers can and will damage the parts from working correctly.
-
Install the RAID adapter in your PC. Install the adapter in an available PCI or PCI Express slot. You will need to consult the instructions in both your RAID adapter manual and your motherboard manual, as the directions will vary depending on the individual models involved. If your motherboard already came with RAID, then you can just skip this test.- You must set the controller mode to RAID. This is done in the system bios. During the start up of your system, a specific keystroke will bring you to this screen.
-
Configure the RAID adapter in your BIOS. During your PC's boot up sequence, press the key combination to bring up the configuration panel for your RAID adapter. You will find this information in the adapter's manual. Typically, the combination is either Ctrl+Ror Ctrl+A.- In some cases, depending on your computer hardware setup, you may be asked to run your computer's CMOS setup program in order to set up your hard drives for RAID.
-
Partition and format the array. Install the adapter in your operating system. During the boot-up sequence of your computer, keep your eyes open for any messages prompting you to install a third-party SCSI or RAID driver. If you see it, then you will need to press F6to initiate the installation process. In this case, you will be prompted to insert the floppy disk that came with your adapter, as this disk holds all of the third-party drivers.
Advertisement
Expert Q&A
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Tips
- Most motherboards already have a RAID controller, and newer motherboard chipsets offer integrated RAID, eliminating the need for an additional controller.Thanks
- Most RAID bios default to making the RAID array bootable. Restart the system and enter the system bios (not the raid bios) and make sure your array or your add-in card is listed as the boot drive/device. Save setting and exit.Thanks
- If your current install of Windows is working fine without problems, you can clone it to your RAID array. Acronis True Image is a good tool used for drive cloning.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Video
Things You'll Need
- RAID adapter
- RAID adapter drivers
About This Article
Thanks to all authors for creating a page that has been read 96,442 times.
Advertisement
