Download Article
Download Article
Coaxial cable, commonly referred to as coax, guards against interference from outside noise by wrapping a single conductor with a tube of metal foil and mesh. This tube runs coaxially over the signal conductor. Maintaining the integrity of this shielding tube requires a special crimp termination method for coax. Use this wikiHow guide to learn how to crimp coax.
Steps
-
Create a termination point.
- Cut off the end of the coax. Use small, sharp wire cutters. Create a squared off surface, rather than a beveled surface.
- Mold the end of the coax using your fingers. The cylindrical cable will be distorted by the pressure of making the square cut. Mold the end of the cable back into a cylinder.
-
Insert the coax into a coax stripper tool. These tools are available at hardware and electrical stores. Make sure that the end of the coax is flush against the wall or guide on the stripping tool. This will ensure proper strip length.Advertisement
-
Clamp the stripper tool closed around the coax. Smoothly spin the tool around the coax 4 or 5 times, or until you no longer hear the sound of metal being scored. Keep the rotation in 1 place on the cable. Do not apply any force that would pull on the cable insulation coating.
-
Remove the coax stripper tool. This strips the insulation to expose the wire. The tool will have made 2 cuts. Use your fingers to gently pull off the material nearest the end of the cable. This will expose the bare center conductor. Use your fingers to gently pull off the outer insulation that has been cut free. This will expose a layer of foil.
-
Tear off the exposed foil. This will expose a layer of metal mesh.
-
Bend back the exposed metal mesh with your fingers. Do not tear the layer of foil that is under the metal mesh. The foil must be left in place around the inner insulation. Bend the mesh all the way back so that it is molded over the end of the outer insulation.
-
Press the end of the coax into the back of an F connector. F connectors are available at hardware and electrical stores. Make sure that the white inner insulation can be seen pressing against the front flange of the connector. If you can't see the insulation, jiggle and continue to push the coax and the connector together. Use straight pressure only. Do not twist the coax in the body of the connector.
-
8Crimp the connection with a crimper. Place the F connector into a coax crimping tool. Coax crimping tools are available at hardware and electrical stores. Fully squeeze the tool handle and release. Remove the finished crimp connection from the tool.
- Gently pull on the wire to make sure it holds within the connector.
Advertisement
Community Q&A
Search
-
QuestionWhat is the length of the insulation I need to remove from the end of the cable?Community AnswerIf it is a normal wire, then maybe 1/2 inch.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Video
Tips
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Things You'll Need
- Wire cutters
- Coax cable stripping tool
- F connector
- F connector compression tool
About This Article
Thanks to all authors for creating a page that has been read 147,292 times.
Reader Success Stories
- "I am very familiar with electronics and coaxial cables, but never have made a coax connector. The simple explanation, and the clear pictures made me comfortable about embarking on this procedure." ..." more
Advertisement