PDF download Download Article PDF download Download Article

A well-organized closet should, ideally, include a stout, straight rod that allows you to space your clothing evenly, keeping it tidy and not wrinkled, and allowing plenty of airflow. However, if you've overloaded your closet rod by squeezing too many clothes into too small a space, or if it's simply too thin for the job, it could sag in the middle. Aside from the common-sense solution of replacing it with a sturdier rod--as simple as lifting the old rod out of the hooks and dropping the new one into place--you have a few possible solutions for holding that sagging closet rod up.

Method 1
Method 1 of 3:

Fix the Cause

PDF download Download Article
  1. Possible ways of doing this include:
    • Shift items to another closet entirely.
    • Unpack hanging closet storage racks and multiple garment hangers, and hang each item individually. This distributes the weight more evenly across the closet rod. Or at the very least, hang heavy storage rocks near the ends of the rod where it's less likely to sag.
    • Stack shoes on the closet floor, or store them in an over-the-door holder, instead of in a holder suspended from the closet rod.
    • Store out-of-season clothes, especially heavy sweaters, under the bed or on closet shelves instead of hanging from the closet rod.
    • Sort through your closet and donate unwanted clothing to friends or a charity; this might lessen the stress on the closet rod.
  2. Advertisement
Method 2
Method 2 of 3:

Add Extra Brackets

PDF download Download Article
    • The easiest way to do the latter is to measure how long the current brackets are.
  1. [1]
    • If you don't have a stud finder, tap gently across the wall. The drywall will sound hollow between studs, and firmer as you're knocking over the stud itself.
  2. Hold the new brackets in place over the studs, supporting the rod so it lays flat, and mark the location of the mounting holes on the drywall with a pencil.
  3. Remove the rod and screw-mount the new brackets in place. [2]
  4. The new brackets will help support it along its length, preventing or at least reducing sag.
  5. Advertisement
Method 3
Method 3 of 3:

Prop It Up

PDF download Download Article
  1. [3]
  2. The bottom edge of the hole should intersect the mark you just made. [4]
  3. This leaves a cylinder-shaped socket in the top end of the dowel.
  4. Advertisement

Expert Q&A

Search
Add New Question
  • Question
    Can I install the brackets anywhere in the closet?
    Lui Colmenares
    Licensed Contractor
    Lui Colmenares is a Licensed Home Improvement Contractor and Handyman for Mr. Handy NYC based in New York City, New York. Lui is trained and educated as an industrial engineer and specializes in carpentry, painting, and general handyman work such as mounting TVs, doorknob and deadbolt installation, furniture assembly, tile repair, and grouting. Mr. Handy NYC prides itself on quality work performed with speed, skill, and punctuality.
    Licensed Contractor
    Expert Answer
    No, closet rods tend to hold a lot of weight, so you need to mount the brackets in studs. Use a stud finder to identify the locations of your studs.
Ask a Question
      Advertisement

      Tips

      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Thanks for submitting a tip for review!

      Things You'll Need

      • Measuring tape
      • Extra bracket for closet rod
      • Stud finder
      • Pencil
      • Power drill/screwdriver
      • Wooden dowel
      • Spade bit
      • Saw

      About This Article

      Thanks to all authors for creating a page that has been read 108,756 times.

      Did this article help you?

      Advertisement