PDF download Download Article PDF download Download Article

Maps and posters are hard to put on the wall when they refuse to lay flat. By rerolling the item in the opposite direction of the curl, you can fix a curling problem. Lay your map or poster down on a clean surface, roll it up, and hold it in place with rubber bands. Gentle humidification can also help loosen delicate maps and posters. Store them above water in a sealed tub for a few hours. The moisture absorption loosens the curl so you can unfold your item and lay it flat.

Method 1
Method 1 of 3:

Uncurling by Rerolling

PDF download Download Article
  1. A table, desk, or even a bed can be used to flatten the map or poster. Provide enough space for the item to lay flat when unrolled. Sweep off any debris before you begin. You wouldn’t want to fix a poster of your favorite musician only to see a crumb lodged in their face!
  2. Slide the item out of any wrapper or container. Set the roll on one side of the flat surface. Feel for the end of the map or poster on the outside of the roll. Don’t pinch the the outside border or else you’ll crease it. Roll out the item until it is spread out on the table.
    • Usually you will need to place the item facedown. Posters for example are rolled up so the image is on the inside. You will have to unroll it and place the image side down.
    • If your item ever feels resistant to opening, don’t force it. Instead, try humidifying it.
    Advertisement
  3. Posters are shipped through the mail in tubes that can also be used for flattening. Toilet paper rolls are smaller but still work very well. Paper towel or wrapping paper rolls also work. Align the tube in the center of one end of your item.
    • It’s possible to try flattening without using a tube. Simply roll up the map or poster as tight as you can and bind it with rubber bands. It’s best though to use a tube so the item doesn’t get dented.
    • Keep in mind that you need to roll your item in the direction opposite the curl. Flip your map or poster to the correct side before placing the tube.
  4. Hold the end of the item tight to the tube as you begin to roll it towards the opposite side. Work slowly and gently. Start loose and tighten the roll as you go to avoid creases. Sometimes this will be enough to flatten a map or poster. [1]
  5. Rubber bands are a good binder since they’re not likely to cause damage to your map or poster. Place one around each end of the roll. Tape can work, such as the tape often used to roll a new poster, but some tapes can lead to ugly rips.
    • If you’re worried about the rubber bands or tape damaging your item, lay the map or poster flat and cover it with heavy objects.
  6. A new poster will need to stay in this rolled up position for about an hour. More curled items may need longer. Don’t overdo it though. You don’t want your item to curl in the opposite direction!
  7. Take off the rubber bands, being careful not to squeeze the edges of your item. Lay the unrolled map or poster flat. Adjust it so that the side it curls towards is facing up. Your item should be in better shape. If it still curls too much, roll it up again or try flattening it with weight.
  8. Advertisement
Method 2
Method 2 of 3:

Flattening with Weight

PDF download Download Article
  1. Find a spacious, out of the way area and clean it off first. Lay your item flat. Keep the curling side facedown. Typically maps and posters are rolled so they curl inwards and over the image. That’s the side that should be facedown.
  2. Any heavy object you have around your home is useful here. Books are always a good choice since they distribute weight evenly over a decent amount of space. Get as many as you can to cover the map or poster. Remember to make sure the objects are clean before you place them.
  3. It’ll take some time for the weight to be effective. Curling can take a day or more to correct. You’ll have to keep your map or poster in a safe spot as you weight. If you tried rolling the item previously, the curling may be fixed within a couple of hours.
  4. With any luck, the item won’t try to wrap itself into a tube again. You can safely hang your favorite heartthrob on your wall. Some maps and poster will need longer, so repeat treatment as much as needed.
  5. Advertisement
Method 3
Method 3 of 3:

Flattening by Humidifying

PDF download Download Article
  1. It’s important to clean off the map or poster before humidifying. Newer items won’t have much debris and you can wipe off spots with your finger or a soft, dry cloth. Dirtier items should be treated with a soft, natural brush like those made of animal hair or feathers. Any dirt left on the item during humidification can lead to stains.
    • Avoid using synthetic fiber brushes like nylon scrub brushes. These are too harsh to be used on delicate items.
    • If your item is very dirty, you may be able to have someone restore it. For example, a paper conservator may save your paper map.
  2. The map or poster must not be rolled up with rubber bands. Any other fastening objects, including staples and clips, should be set aside. If your item is not completely rolled, roll it up in the direction of the curl.
  3. Add about two inches (5.08 cm) of room temperature water to a large plastic tub. Make sure the container is big enough to hold a second container. A plastic storage tub or large trash can are common choices. [2]
    • More water will provide more moisture, which speeds up humidification. This can be risky if you don’t monitor your map or poster carefully.
    • Misting near the map or poster with a spray bottle is an alternative treatment that can uncurl your item quickly. However, it is very difficult to get the perfect amount of water exposure.
  4. The rack needs to lay flat and stay above the water. Instead of a wire rack, you may set a smaller plastic container or trash can in the water. Make sure the rack or container is secure enough to stay in place. [3]
  5. Lay the item out on the rack or inside the smaller container. Double-check that you used room temperature water before sealing the container. Warm water can condense on the container lid and drip onto your map or poster. Keep the humidification system in a temperature-controlled room where it won’t be disturbed.
  6. Once the lid has been sealed on the plastic container, you must let the map or poster absorb moisture. This takes about four to six hours. Come back after one hour to check on the system. Make sure water isn’t dripping from the lid. Check back again after four or five hours to see how your item has changed. It should feel softer and more relaxed. [4]
  7. Remove your item from the humidifier. Gently try to unroll it. It should not curl up at all. In case the item feels resistant and ready to tear, leave it alone. Place it back in the humidifier and let it absorb more moisture.
  8. Cotton archival paper can be ordered online or at craft stores. You may also use cotton towels or blankets. Lay one piece of cotton flat on a table. Place the uncurled map or poster on top of it. Cover it with the second piece of cotton. Now weigh down your item so it stays flat.
    • Try setting a wood cutting board over the cotton and topping it with a couple of heavy books. The weight can help prevent the item from curling again.
  9. The cotton should be left in place overnight. If your paper feels dry by then, great! Often it takes a few days. Continue to check on your map or poster from time to time. Whenever the cotton feels damp, replace it.
  10. Humidification is best done with maps and posters you are willing to risk. Valuable or brittle items should be taken to a professional. Search in your area for paper conservators. Museums in your area may also be able to refer you to a conservator they trust.
  11. Advertisement

Community Q&A

Search
Add New Question
  • Question
    Can you iron a poster to help flatten it and get it ready for framing?
    Community Answer
    It's not recommended, since it can quickly damage the poster. If you want to try it, place a cotton sheet or towel over it. Turn the iron to the lowest heat setting. This may remove wrinkles. Another method to try is to mist the poster. Stand back and lightly spray the wrinkled area or spray in the air and pass the poster through the mist. Dry the poster between cotton and under weights. It'll take a day or two for the poster to dry, but it's easier to control the water exposure than it is the heat from the iron.
  • Question
    I am trying to flatten artists/ drawing paper that is currently in a tight roll. How do I do this?
    Community Answer
    Try the methods above. You can first try unrolling it and flattening it. If it feels delicate and about to break, you should leave it alone and try humidifying it. If you can unroll it safely, you may be able to fix it by rolling it in the opposite direction and weighing it down. If you have to humidify it, either spray it from afar with a little water or make a humidification chamber out of two tubs or trash cans.
Ask a Question
      Advertisement

      Video

      Tips

      • Only weigh down the map or poster when it’s on a hard, solid surface. Soft surfaces can cause crinkling.
      • Make sure the area you use for flattening or humidifying is out of the way.
      • Work gently when unrolling maps and posters. It’s very easy to bend the edges. In addition, some older ones can be very brittle.
      Show More Tips
      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Thanks for submitting a tip for review!
      Advertisement

      Warnings

      • Do not use rubber bands that have ink stamps on them, as they may stain your paper.
      • If you want to laminate a poster, flatten it first.
      • Ironing is risky for flattening maps or posters. At the very least, keep cotton between the item and iron. Don’t iron your map or poster directly.
      • If you want to flatten a vintage items that is valuable or feels brittle, take it to a professional.
      Advertisement

      About This Article

      Article Summary X

      To flatten a rolled map or poster, start by unrolling it facedown on a flat surface and placing a cardboard tube at 1 end of it. Next, roll your map or poster around the tube with the image facing out. Once the item is wrapped around the tube, image facing out, place rubber bands around it so it won’t unravel. After 1 hour, remove the rubber bands and unroll the item. If it’s still rolling up on the ends, lay it flat and weigh down the corners with books or other heavy objects for a few hours. To learn how to flatten a map or poster using humidity, keep reading!

      Did this summary help you?
      Thanks to all authors for creating a page that has been read 417,931 times.

      Reader Success Stories

      • Shirley Wittering

        Sep 1, 2017

        "I had a poster from the National Gallery which had been rolled up for several years. It was made of quite stiff ..." more
        Rated this article:
      Share your story

      Did this article help you?

      Advertisement