PDF download Download Article PDF download Download Article

Removing ethanol from gasoline is easier than it sounds. Ethanol is more soluble in water than it is in gasoline. Therefore, if you add water to the gasoline and vigorously shake it, the ethanol will attach itself to the water. After it sits for a while, the gasoline and water/ethanol will make 2 distinct layers, and you can drain off the ethanol/water in a variety of ways.

Method 1
Method 1 of 2:

Separating the Ethanol and the Gas

PDF download Download Article
  1. For your safety, put on nitrile gloves and place the empty gasoline container on the ground in a ventilated area -- outdoors is best. Pour the gas into the container first, followed by the water. Pour slowly to avoid splashing. [1]
    • While working to separate the gasoline, make sure to use a container designed for storing gasoline, which should create a tight seal when closed. Also, don't fill the container more than 95% full, as the gasoline needs room to expand.
    • If you try to hold the container while pouring, you can cause the vapors to ignite from static electricity. [2]
    • If you want, you can add a few drops of food coloring to the water first to make it easier to see the layers of water/ethanol and gasoline when you're done. [3]
  2. Place the cap on the container, ensuring it's tightly sealed. Shake the mixture together thoroughly. You want to shake it for a good 15 to 30 seconds to make sure the water and gasoline are thoroughly incorporated. [4]
    • Do not be anywhere near an open flame when performing this maneuver. Vapors can ignite.
    Advertisement
  3. Once you shake the mixture, pour it into the Ethanator to sit. When the water has settled out, use the valve at the bottom of the bottle to drain off the water and the ethanol into a container. [5]
    • When you're done, remove your gloves, and wash your hands thoroughly.
    • You'll need to leave the mixture to settle for at least 3 to 4 hours, but you may want to leave it overnight or as long as 12 hours. Once the mixture is ready, it will be perfectly clear without cloudiness, and you'll see 2 distinct layers. The gasoline will settle on top and the water and ethanol mixture will settle on the bottom. [6]
  4. If you don't have an Ethanator, you can carefully pour the ethanol-free gasoline layer into another fuel-safe container, after it's been left to separate for several hours. Tip the container over another one to pour off the gasoline. This will be easier to do if you added the food coloring to the water, as you'll be able to see the layers better.
    • This method probably won't be quite as easy or as safe as the Ethanator, as it's easier to spill gasoline this way. You may also waste a bit more fuel (by leaving it behind with the ethanol) than with the other method.
  5. Advertisement
Method 2
Method 2 of 2:

Using a Separatory Funnel

PDF download Download Article
  1. Separatory funnels are used in chemistry to separate liquids. It needs to be double the size so the liquid has room to move around. [7]
  2. The valve, called the stopcock, should be in a closed position so liquid can't come out. [8] Use a ring stand to hold the funnel in the air, so you don't have to hold it. [9]
  3. Take the stopper off the top, and add the gasoline to the funnel. Pour the water in after the gasoline, and replace the stopper. [10]
    • Use about 1 part water to 16 parts gasoline.
    • Ensure there are no open flames around, as gasoline vapors can ignite.
  4. Put your finger on top of the stopper. Turn the funnel upside down, and shake the solution. With the stopper facing downward, turn the stopcock to open to vent any pressure. Close the stopcock, and shake the solution some more. Repeat 2 or 3 times. [11]
  5. The stopcock should be facing downward in the ring stand. Let the mixture sit until the gasoline isn't cloudy anymore and you have a clear separation between the 2. It will take at least a couple of minutes. [12]
  6. Place a container under the funnel. Open the stopcock to let the ethanol and water come out the bottom. Be careful to stop right where the mixture is separated, and close the stopcock. [13]
  7. Take the stopper off, and tip the funnel upside down to pour the gasoline into a container approved for gasoline storage. Make sure to label both the gasoline and the ethanol clearly. [14]
    • Do not fill the gasoline container more than 95% full so the gasoline has room to expand. [15]
  8. Advertisement

Community Q&A

Search
Add New Question
  • Question
    Will ethanol hurt my 2008 altima?
    Crumbar1
    Community Answer
    E85 or 85% Ethanol (highest amount of ethanol sold in large quantities in the United States) can hurt the performance of your motor if it is not specifically designed for it. The best way to tell is if your fuel cap is yellow. However, most gasoline sold in America is regulated at E10 or 10% ethanol and has been that way since 2008 (unless specifically designated rec fuel). Your factory fuel lines and injectors are able to withstand that amount of ethanol as it doesn't have a terribly large effect of the stoichiometric ratio at which it burns (i.e., E 10 Stoich AFR = 14.1 versus pure gasoline, which is around 14.7).
  • Question
    What do you do with the leftover ethanol infused water? Dump it down the drain? Pour it onto plants? Is there an environmentally safe way of disposing of it?
    Community Answer
    Some mechanic shops have safe containers for disposing of gas and oil. Autozone stores (among others) offer free disposal of fuels and oil. Avoid pouring them into the general environment.
  • Question
    How do I dispose of the remaining ethanol? What can be done with it?
    James Anderson
    Community Answer
    All liquid fuels should be properly stored or taken to a safe disposal place such as an auto parts store or a mechanics shop.
See more answers
Ask a Question
      Advertisement

      Tips

      • Take the ethanol to a hazardous waste disposal center. Some cities allow highly diluted ethanol to be poured down the drain, but it's better not to take chances. Go to a hazardous waste disposal center to get rid of your ethanol/water mixture. [16]
      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Thanks for submitting a tip for review!
      Advertisement

      Warnings

      • Draining off the ethanol will likely lower the octane level, usually by about 3. Start with a higher gasoline level if you need a standard octane level.


      Advertisement

      About This Article

      Article Summary X

      To remove ethanol from gasoline, first find out how many gallons of gas you have. Then, in a well-ventilated area, pour the gasoline into a safe container and then pour 1 cup of water for every gallon of gasoline into the same container. Tightly seal the container and then shake it vigorously for about 30 seconds. Shaking causes the ethanol to mix with the water, which it is more soluble in. Leave the container alone for a few hours so the ethanol has time to separate from the gasoline. Once the ethanol has separated, slowly tip the container over another safe container to pour out the ethanol-free gasoline, leaving behind the ethanol and water mixture. To learn how to do this process with an Ethanator device or with a separatory funnel, keep reading.

      Did this summary help you?
      Thanks to all authors for creating a page that has been read 117,620 times.

      Reader Success Stories

      • Anony Mous

        Mar 16, 2021

        "The separating funnel technique worked well. Now my generator starts after months of sitting."
      Share your story

      Did this article help you?

      Advertisement