PDF download Download Article PDF download Download Article

Vinyl is a durable, easy-to-clean material that is often used for vehicle upholstery. However, whether new or old, vinyl tends to develop unsightly wrinkles that make it look stretched out. Luckily, you can easily shrink up the vinyl to remove these wrinkles in a few different ways, including using a steamer, applying hot, wet towels, or using a heat gun. No matter which method you choose, you’ll have smooth, wrinkle-free upholstery in just a few minutes!

Method 1
Method 1 of 3:

Using a Steamer

PDF download Download Article
  1. Tap and well water contain minerals, which could clog up the steamer or leave deposits on your upholstery. It’s best to use distilled water when steaming anything, but especially when working with vinyl upholstery. [1]
    • Though you can use a steamer made for car upholstery, a regular handheld steamer will work just fine.
    • Steamers are super useful tools. Not only can you use them on clothes (say good-bye to ironing!), but you can also use them to remove wrinkles from items that are hard to wash, like curtains.
  2. Turn on the steamer and hold it so it’s just barely touching the upholstery. Use long strokes to apply the steam to the vinyl using light pressure. Work on a single panel of the upholstery at a time (or a 1 square foot (0.093 m 2 ) section) and be sure to steam every last inch for a smooth, even result. [2]

    Tip: Move the steamer in the same direction as the wrinkles to help remove them completely.

    Advertisement
  3. Vinyl is often most wrinkled near the seams. Hold the steamer directly over the seam to force steam into the foam underneath the vinyl. Repeat the process for the length of each seam. This will help plump it up, making your seats look brand new! [3]
  4. Run a clean microfiber cloth over the vinyl to remove excess water. If you’re working on upholstery that’s already in a vehicle, leave the windows down to allow air to flow through the interior.
    • Don’t close up the car until the upholstery is completely dry, or it may develop mildew as well as an unpleasant smell.
  5. Advertisement
Method 2
Method 2 of 3:

Applying Hot, Wet Towels

PDF download Download Article
  1. Select several clean, small towels or cloths. Roll them up and put them in a small microwave-safe bucket or large bowl. Fill the bowl with water so that the towels are completely submerged. [4]
    • Hand towels, washcloths, or even clean rags will do.
  2. The heat and steam will smooth out the vinyl, removing wrinkles and shrinking it to the seats. Be very careful when you remove the bucket from the microwave—it will be hot! [5]
  3. Put on a pair of clean heat-resistant gloves, carefully unroll the towels, and lay them on the wrinkled upholstery in a single layer. Be sure to completely cover all the parts you want to shrink or smooth out. Press the towels into the vinyl. [6]
    • You can use this same process to remove wrinkles from leather upholstery as well.
  4. After 10-15 minutes, take the towels off of the vinyl. The wrinkles will have disappeared, leaving you with smooth upholstery! [7]
    • Let the vinyl dry completely before closing up the car to prevent bad odors and the development of mildew.
  5. Advertisement
Method 3
Method 3 of 3:

Using a Heat Gun

PDF download Download Article
  1. Heat guns are useful tools with many applications, including drying, softening, and shrinking different types of materials. Pick one up from your local hardware store to easily shrink vinyl upholstery in a matter of minutes. [8]

    Variation: In a pinch, you can use a hair dryer on the highest heat setting instead of a heat gun.

  2. Turn on the gun and hold it at least 6 inches (15 cm) from the vinyl to keep from melting or otherwise damaging it. Work on a single 1 square foot (0.093 m 2 ) section at a time. Move the heat gun from side to side and work from the top to the bottom of each section to evenly heat the upholstery. [9]
    • Keep the gun moving at all times so you don't scorch the vinyl.
  3. As the vinyl heats and shrinks, you’ll be able to see the wrinkles disappear. If you encounter any stubborn spots, smooth them out with your hands, but be careful—the vinyl will be hot! [10]
    • If you're using the heat gun on a seat, let the vinyl cool completely before sitting in it.
  4. Advertisement

Expert Q&A

Ask a Question
      Advertisement

      Tips

      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Thanks for submitting a tip for review!

      Things You’ll Need

      Using a Steamer

      • Steamer
      • Distilled water
      • Microfiber cloth

      Applying Hot, Wet Towels

      • Small towels
      • Bucket or bowl
      • Microwave
      • Heat-resistant gloves

      Using a Heat Gun

      • Heat gun

      About This Article

      Thanks to all authors for creating a page that has been read 33,774 times.

      Did this article help you?

      Advertisement