Download Article
Download Article
Toenailing is driving a nail at an angle through a board. It is an essential carpentry skill. Toenailing not only makes a strong joint but also is a great way to coax stubborn boards into position. Once you master a few tricks for positioning and driving the nails and get some practice under your belt, it’ll be as easy as regular nailing.
Steps
Download Article
-
Position the board in front of the layout line and place your toe against the back. Start the nail by tapping it about 1/4 inch (6.35 mm) straight in, not at an angle. Position the board about 1/4 inch from your mark so the nail will drive it to the right spot. -
Pull the nail to about a 50-degree angle and set it with a couple of hammer taps. Then let go and drive it in. Brace your toe against the back of the board as you set the nail. It’s okay if the board moves slightly past the layout line. Driving a toenail requires greater hammer control and precision than regular nailing. Hold the hammer at the end of the handle with a firm but relaxed grip. Swing from your elbow with a little wrist snap at the end of the stroke for extra oomph. Luckily, you don’t have to worry about leaving hammer marks when you’re rough framing walls and floors. As the nail gets close to fully driven, adjust your swing ever so slightly away from you so the face of the hammer will contact the nail head off center. Catching the head of the nail with the edge of the hammer face allows you to drive the toenail completely. [1] X Research sourceAdvertisement -
Drive toenails into the opposite side to complete the toenailing, and at the same time drive the board back to the layout line. If the board is twisted, toenail the side that needs to be forced back. [2] X Research source -
Toenails have an amazing power to move lumber. This power is especially handy when you’re working with framing lumber or decking that’s not as straight as you’d like. Use big nails with big heads like 16d sinkers for these jobs. In fact, if one nail doesn’t do the job, drive another alongside to move the board even farther. [3] X Research source
Advertisement
Expert Q&A
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Tips
- Cut a block (14-1/2 inch (36 cm) long for 16-inch (40.5 cm) on-center studs) to fit between studs when you’re toenailing walls. The block acts as a spacer and backer to support the stud while you toenail it.Thanks
- Drive the nails until the points barely protrude through the end of the first board before you position it, then position the board and drive the nails home.Thanks
- See the external links below for more detailed instructions.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
References
About This Article
Thanks to all authors for creating a page that has been read 211,035 times.
Advertisement
91%
of readers found this article helpful
.
Click a star to add your vote
% of people told us that this article helped them.
