PDF download Download Article PDF download Download Article

The whipstitch is a simple stitch used in both sewing and crocheting. In both practices, it is usually used to sew together two separate pieces of material with flat edges. When used on crocheted works, the whipstitch is nearly invisible. For sewn works, the stitch is a more visible, but can be masked. [1]

Method 1
Method 1 of 2:

Using Thread (Sewing)

PDF download Download Article
  1. Thread the needle . Feed one end of the thread into your sewing needle and draw the thread halfway through. Tie both ends together into a knot.
    • If you want to camouflage the whipstitch, use thread in a coordinating color. If you want the whipstitch to stand out, use thread of a contrasting color.
    • Embroidery thread works well for this stitch, but any thick thread can be used.
    • To tie the knot, try moistening your forefinger. Wrap the thread around your forefinger once. Then use your thumb to push the thread off your finger, twisting it in the process. Finally, pull the end of the thread to tighten the knot. [2]
  2. Watermark wikiHow to Whipstitch
    Make sure that the edges you intend to sew together are evenly aligned. The sides of the fabric which you intend to be the backend should face out so as to be visible during the process. The thread you use here will be more visible.
    • Pin or baste the layers together to hold them in place.
    Advertisement
  3. Watermark wikiHow to Whipstitch
    While looking at the two layers of fabric from the side, draw the needle up through the bottom of the top layer, leaving the bottom layer untouched. [3]
    • Start your stitch about 1 8  in (0.32 cm) from the end. [4] Also note that each stitch you make should be 1 8  in (0.32 cm) away from your sewn edge, as well.
    • By only piercing through the top layer, you will draw the knot between the two layers, thereby hiding it from sight.
  4. Watermark wikiHow to Whipstitch
    Circle the needle around to the bottom layer of fabric and pierce through the fabric directly under your first hole. [5] Draw it straight through both layers of fabric, making sure that it comes out in nearly the same position as your first half-stitch.
    • This is your first full stitch since it connects both layers together.
    • When you complete this step, the thread should be wrapped around the edges of both layers in an even stitch, forming a loop around the outside of the fabric. [6]
    • Make sure that the stitch is secure, but not so tight that it causes the fabric to bunch up.
  5. Watermark wikiHow to Whipstitch
    Bring the needle back to the bottom of the fabric and poke it up through both layers of fabric. Angle the needle so that it comes out roughly 1 2  in (1.3 cm) away from the first stitch. [7]
    • This second stitch will essentially cover the first stitch.
    • Pull the thread tight. When done, you should only be able to see what appears to be one stitch, but the thread should come out from fabric in a blank spot next to the stitch.
    • Each stitch should be approximately 1 2  in (1.3 cm) from one another and from the edge of the fabric, so that each stich is parallel.
  6. Watermark wikiHow to Whipstitch
    Position the needle beneath the bottom side of the fabric. Poke it up into both layers of fabric, beginning just beneath the spot at which the thread is coming up. Angle the needle so that it comes out through the top another 1 2  in (1.3 cm) away from the previous stitch.
    • The stitch itself should not appear angular, however. It should run straight up and down over the edge, parallel to the first stitch.
  7. Watermark wikiHow to Whipstitch
    Continue making stitches that mimic the previous one. Draw the needle up through both layers, starting at a point beneath the previous stitch and ending at a position 1 2  in (1.3 cm) away. Do this until you reach the end of the edge.
    • Note that the majority of your stitches will follow this pattern, but your last full stitch and half stitch will be different and will mimic the stitches you made at the beginning of the process.
  8. Watermark wikiHow to Whipstitch
    For your final full stitch, pierce the needle through the bottom layer and draw it straight up through both layers instead of stitching at an angle. This stitch should be made 1/8 inch (3.175 mm) away from the edge of the fabric, just as the first one was.
  9. Watermark wikiHow to Whipstitch
    Poke the needle up through the bottom layer again, in the same spot as your previous stitch. Only bring the thread through the bottom layer, however, and not the top layer.
    • In this step, you are mirroring the initial half stitch you created at the beginning of the process. This stitch will be hidden in between both layers of fabric.
  10. Watermark wikiHow to Whipstitch
    Draw the needle through the back of the last stitch you made. Pull the layers apart slightly to reveal the backside of your stitches. Open up the pieces of fabric like two leaves of a book. Wrap the needle through your last stitch, creating a loose loop in the process. Thread the fabric back around, twisting it around the original loop. Then pull tight.
    • This knot should also be hidden in between the two layers of fabric.
    • After creating the knot, cut your thread to free it from the needle. Trim it short so that it cannot be visible from the front side.
  11. Watermark wikiHow to Whipstitch
    Gently pull the two layers apart, causing the stitches to flatten evenly against the fabric. This step completes the process.
  12. Advertisement
Method 2
Method 2 of 2:

Using Yarn (Crocheting)

PDF download Download Article
  1. Watermark wikiHow to Whipstitch
    Ideally, you should already have a tail of yarn, remaining from the crochet. If not, tie a new strand of yarn to the bottom stitch of one edge.
    • The yarn you use for this stitch should be three to four times longer than your finished edge. [8]
    • Use the same color yarn as one or both pieces of crochet work you intend to join. Unlike the whipstitch used in sewing, the whipstitch used in crocheting is meant to be far less visible, so you will usually want to hide the stitch further by using one of the colors already in the pattern.
  2. Watermark wikiHow to Whipstitch
    Insert the yarn through the eye of your yarn needle. Do not knot the ends of the yarn together. Pull at least 3 to 4 inches (3.75 to 10 cm) of yarn through the eye of the needle. You will need this long starting portion to ensure that the needle remains threaded throughout the process.
    • You will also need to monitor this non-working length of the yarn as you make your whipstitch. If it starts to get short, tug a little more yarn through the eye of the needle to prevent it from falling out. Should the yarn fall out during the process, simply re-thread it.
  3. Watermark wikiHow to Whipstitch
    Make sure that the two edges you want to stitch together are evenly aligned side by side.
    • The back sides of both pieces should face out during this process.
  4. Watermark wikiHow to Whipstitch
    Draw the needle up through the front loop on the edge of one crochet through to back loop of the edge of the other piece of crochet, not yet threaded.
  5. Watermark wikiHow to Whipstitch
    Take the yarn back through the last two loops. Pull the yarn tight to create a knot to hold the pieces together tight. [9]
    • The yarn needs to be pulled tightly enough to draw the two pieces of crochet snugly together. Do not pull it too tight, however, since doing so can cause bunching or similar distortions to occur in your work.
  6. Watermark wikiHow to Whipstitch
    Draw the needle through the next loop on the top crochet. then poke the needle through the following loop of your opposite edge. The pattern should look like a spiral, moving up the edge of the crochet.
    • Start with the piece of crochet your yarn is connected to and end the stitch through the opposing piece. [10]
    • You can pull the yarn through either one or two loops on each of the crochet pieces, depending upon what type of pattern you want. [11]
  7. Watermark wikiHow to Whipstitch
    Insert the needle through the next set of loops on both edges, drawing the yarn taut through both sets. Continue this pattern, moving upward one set of loops at a time, until you reach the end of both edges.
    • Make sure that each stitch passes through the front and back loops of both sides.
    • Each stitch should be about as tight as your first one was. The edge should be secured well enough so that no space remains between both pieces, but do not allow the pieces to bunch up as you work. [12]
  8. Watermark wikiHow to Whipstitch
    Wrap the yarn through the last loop of your opposing edge and then back through the same set of loops again. Pull this end and draw the loop closed, creating a knot. [13]
    • Weave the tail along the back side of your crochet work to hide it.
    • If you have an excess longer than 1 inch (2.5 cm), you can trim some of it off.
  9. Watermark wikiHow to Whipstitch
    Flip the joined pieces over to the front side. The whipstitch should be nearly invisible front the front.
  10. Advertisement

Expert Q&A

Search
Add New Question
  • Question
    What is a whipstitch?
    Margo West
    Professional Tailor
    Margo West is a Professional Tailor and the Owner of Margo West Bridal Alterations in Dallas, Texas. She is renowned for her expertise in bridal alterations, custom wedding gowns, wedding-related design, and pattern making. Her 44 years of bridal experience has earned her the prestigious WeddingWire Brides Choice Award, Couples Choice Award 2013-2019, and The Knot Best of Weddings 2018-2020. Margo was also featured in House of Diffa 2018 Jacket Collection and Modern Luxury Brides Magazine 2020. She will launch her new bridal gown collection for fall 2021.
    Professional Tailor
    Expert Answer
    A whipstitch is an efficient way of hemming or mending with a needle and thread. It's typically not hidden from view.
  • Question
    How do you do a whipstitch?
    Margo West
    Professional Tailor
    Margo West is a Professional Tailor and the Owner of Margo West Bridal Alterations in Dallas, Texas. She is renowned for her expertise in bridal alterations, custom wedding gowns, wedding-related design, and pattern making. Her 44 years of bridal experience has earned her the prestigious WeddingWire Brides Choice Award, Couples Choice Award 2013-2019, and The Knot Best of Weddings 2018-2020. Margo was also featured in House of Diffa 2018 Jacket Collection and Modern Luxury Brides Magazine 2020. She will launch her new bridal gown collection for fall 2021.
    Professional Tailor
    Expert Answer
    When whipstitching, push your needle into the top and pull it out from the top, evenly spacing your stitches approximately 1/2" apart.
  • Question
    In the crocheting section, why do your pictures show knitted fabric?
    Jenny Marie
    Community Answer
    The person who wrote the article is using a "generic" drawing, which I've seen in many, many books. It is a drawing intended to represent both knit and crochet. Just for basic info, this "knitted" look can be achieved using a crochet hook and the slip stitch.
See more answers
Ask a Question
      Advertisement

      Video

      Tips

      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Thanks for submitting a tip for review!

      Things You'll Need

      Using Thread (Sewing)

      • Embroidery thread or similarly heavy thread
      • Pins
      • Sewing needle
      • Scissors

      Using Yarn (Crocheting)

      • Yarn
      • Yarn (darning) needle
      • Scissors

      References

      1. http://newstitchaday.com/how-to-crochet-the-whip-stitch-seam/
      2. http://www.makeit-loveit.com/2009/04/hand-stitching.html
      3. Margo West. Professional Tailor. Expert Interview. 7 December 2020.
      4. https://www.youtube.com/watch?v=pG86hhrDdzQ
      5. Margo West. Professional Tailor. Expert Interview. 7 December 2020.
      6. Margo West. Professional Tailor. Expert Interview. 7 December 2020.
      7. Margo West. Professional Tailor. Expert Interview. 7 December 2020.
      8. http://newstitchaday.com/how-to-crochet-the-whip-stitch-seam/
      9. http://newstitchaday.com/how-to-crochet-the-whip-stitch-seam/

      About This Article

      Article Summary X

      If you want to whipstitch, start by feeding an end of thread through your needle and pulling it halfway through. Place 2 layers of fabric on top of each other, then push your needle through the top layer. Next, circle your needle around to the bottom and poke it up through both layers of fabric directly under the first hole. Bring the needle up through both layers again, but this time at an angle so that it comes out 1/8 inch away from the stitch. Continue the pattern until you reach your final stitch, then bring the needle straight up through both layers. To learn how to whipstitch with yarn for a crochet project, read on!

      Did this summary help you?
      Thanks to all authors for creating a page that has been read 477,077 times.

      Reader Success Stories

      • Hope C.

        Nov 5, 2016

        "I thought I knew what how a whip stitch is done, but wasn't sure, and I wanted to verify that I had the right ..." more
      Share your story

      Did this article help you?

      Advertisement