Download Article
Download Article
An aneroid manometer is a device used by medical professionals to measure blood pressure, which is the force exerted on the walls of the arteries as the heart pumps blood around the body. The aneroid manometer is one of three main types of sphygmomanometer; both aneroid manometers and mercury manometers must be read manually and are used pretty much the same way, while the third, a digital sphygmomanometer, is automatic. Digital manometers are easier to use, but mercury and aneroid manometers are more accurate, though aneroid manometers need to be calibrated more often. [1] X Research source Blood pressure is recorded in millimeters of mercury (or mmHg) and varies depending on the patient's age, activity, posture, medication or any pre-existing diseases.
Steps
-
Check to make sure the aneroid manometer is calibrated correctly. When you look at the dial, make sure it is at the zero baseline before starting. If it isn't, you need to calibrate it using a mercury manometer. Connect it with a Y connector, and once you move the dial over, check the pressure at several readings on both meters to make sure the aneroid manometer matches the mercury manometer. [2] X Research source
-
Pick a cuff that is an appropriate size. Larger patients will need larger cuffs; otherwise, their blood pressure will read higher than it actually is. Similarly, smaller patients will need smaller cuffs; otherwise, their blood pressure will read lower than it actually is. [3] X Research source
- To pick the right size cuff, measure the bladder of the cuff against your patient's arm. The bladder is the part of the cuff where the air enters it. The bladder should go at least 80 percent of the way around the patient's arm.
Advertisement -
Tell the patient what you are doing. You should perform this step even if you think the patient can't hear you due to unconsciousness. Tell the patient that you are going to use a cuff to take his blood pressure, and that he will feel some pressure from the cuff. [4] X Research source
- Remind the patient that he should not talk while you are taking his blood pressure.
- Try to calm down an anxious patient by asking about his day or something he enjoys. You can also ask him to take a few deep breaths to relax him. If you take the reading while he is still anxious, it can give a falsely high reading.Nonetheless, some patients will always be nervous in a doctor's office.
- If the patient is very anxious, try giving him five minutes to relax and calm down.
-
Ask the patient questions. Ask if the patient has had an alcoholic beverage or smoked a cigarette in the 15 minutes prior to the test. Those two actions can affect the reading. Also ask the patient if she is on any medications that may affect blood pressure readings. [5] X Research source
-
Get the patient into position. The patient can be standing, sitting, or lying down. If the patient is sitting, the arm should be bent at the elbow and his feet should be flat on the floor. Ensure that the arm is resting at the same level at the heart. If the patient supports his own arm, it can lead to a false reading. [6] X Trustworthy Source Centers for Disease Control and Prevention Main public health institute for the US, run by the Dept. of Health and Human Services Go to source
- The patient's arm should be bare of restrictive clothing with the sleeves of any clothing comfortably rolled up. However, ensure that the rolled-up clothing isn't cutting off the blood supply.
- The arm should be slightly flexed at the elbow, and supported throughout the reading on a flat, stable surface.
- Make sure the patient is comfortable in this position. If he's not, it can give a falsely high reading.
-
Center the cuff over the brachial artery. Find the middle of the bladder by folding it in half.Make sure it doesn't have air in it already. [7] X Trustworthy Source PubMed Central Journal archive from the U.S. National Institutes of Health Go to source Palpate the brachial artery (the large artery on the inside of the elbow) with your fingers. Place the center of the bladder directly over the brachial artery.
-
Wrap the cuff around the patient's arm. Wrap the cuff of the manometer snugly around the patient's exposed upper arm. The bottom edge of the cuff should be approximately one inch above the bend of the elbow. [8] X Research source
- The cuff should be fairly tight to get an accurate reading. It should be tight enough that it should be hard for you to get two fingers under the edge of the cuff.
Advertisement
-
Feel for a pulse. Put your fingers over the brachial artery. Hold them there until you can feel a pulse, called the radial pulse. [9] X Research source
-
Pump air into the cuff. This step should be done quickly. You should let the cuff reach a point where you can't feel the radial pulse anymore. Note the pressure in mmHg.That pressure is a general guide for the systolic pressure. [10] X Trustworthy Source PubMed Central Journal archive from the U.S. National Institutes of Health Go to source
-
Take the air out of the cuff. Release the air from the cuff. Add 30 mmHg to your previous reading. That is, if you lost the pulse at 120 mmHg, add 30 to reach 150 mmHg.
- If you don't want to take it twice, a standard recommendation is to inflate to 180 mmHg.
-
Place the stethoscope bell on the brachial artery. You should hold the bell of the stethoscope on the patient's skin just below the edge of the cuff. It should center on the brachial artery so that you can hear the blood flow. [11] X Research source
- Never use your thumb to hold the head of the stethoscope in place. The thumb has a pulse of its own which can interfere with your ability to hear the patient's pulse. Hold the stethoscope in place with your index and middle fingers instead.
-
Re-inflate the cuff. Add air into the cuff rapidly, until it reaches the number you found by adding 30 mmHg. Once you've hit that number, stop adding air. [12] X Research source
-
Slowly let the air out. Let the air deflate from the cuff at a rate of 2 to 3 mmHg a second. While it is deflating, make sure you are listening in the stethoscope. [13] X Trustworthy Source Centers for Disease Control and Prevention Main public health institute for the US, run by the Dept. of Health and Human Services Go to source
-
Note when the sound begins. You should hear a knocking or beating sound, called "Korotkoff" sounds. When that sound begins, note the reading on the dial. That reading is the systolic pressure. [14] X Research source
- The systolic number represents the pressure that blood exerts against the walls of an artery following a heart beat or contraction.
-
Note when the sound stops. After the beating starts, at some point you'll hear a rushing or "whooshing" noise. Once you can't hear that sound anymore, that reading is the diastolic pressure. Note that number, too. Release the rest of the air. [15] X Research source
- The diastolic number represents the pressure that blood exerts on the walls of an artery when the heart relaxes between contractions.
-
Record the measurements. Write down the high and low numbers, as well as what size cuff you used. Also, write what arm was used and the position the patient was in. [16] X Research source
-
Take the pressure again if it's high. You should take the blood pressure an additional two times if it's high; wait a couple of minutes between readings. Take the average of the last two readings as the final reading. If the final reading is high, you will want the patient to monitor her blood pressure to determine if she may have hypertension. [17] X Research source Keep in mind that two to three tests are not enough to determine hypertension.
- The patient should record her blood pressure for two to three weeks and record the results and bring this information to her physician for a proper diagnosis.
Advertisement
-
Understand the dial. The dial runs from 0 mmHg up to about 300 mmHg. You shouldn't need numbers much past 200, as even systolic pressures over 180 constitute an emergency. [18] X Trustworthy Source PubMed Central Journal archive from the U.S. National Institutes of Health Go to source
-
Know how to write blood pressure. Blood pressure is written with the systolic pressure first. Generally, it's followed by a slash and the diastolic pressure. [19] X Trustworthy Source FamilyDoctor.org Family-focused medical advice site run by the American Academy of Family Doctors Go to source For instance, a normal blood pressure would read 115/75. [20] X Trustworthy Source American Heart Association Leading nonprofit that funds medical research and public education Go to source
-
Know what constitutes high blood pressure. Stage 1 high blood pressure (also called hypertension) is 140 to 159 in systolic pressure and 90 to 99 in diastolic pressure. Stage 2 high blood pressure is 160 or above in systolic pressure and 100 or above in diastolic pressure. If you're taking your own blood pressure, go to the emergency room if your systolic pressure is over 180 or your diastolic pressure is over 110. [21] X Trustworthy Source American Heart Association Leading nonprofit that funds medical research and public education Go to source
- Prehypertension runs from 120 to 139 in systolic pressure and 80 to 89 in diastolic pressure. A normal blood pressure range is anything under that, though your blood pressure can be too low. [22] X Trustworthy Source American Heart Association Leading nonprofit that funds medical research and public education Go to source
- Doctors do not have an exact range for low blood pressure. Generally, low blood pressure is only a problem if you're having symptoms. Symptoms include dizziness, an inability to concentrate, thirstiness, tiredness, nausea, fast breathing, and blurry vision. [23] X Trustworthy Source American Heart Association Leading nonprofit that funds medical research and public education Go to source
Advertisement
Expert Q&A
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Tips
Submit a Tip
All tip submissions are carefully reviewed before being published
Thanks for submitting a tip for review!
References
- ↑ http://www.practicalclinicalskills.com/sphygmomanometer.aspx
- ↑ http://www.steeles.com/catalog/takingBP.html
- ↑ http://www.steeles.com/catalog/takingBP.html
- ↑ https://www.nursingtimes.net/clinical-archive/assessment-skills/blood-pressure-monitoring-21-06-2007/
- ↑ https://www.nursingtimes.net/clinical-archive/assessment-skills/blood-pressure-monitoring-21-06-2007/
- ↑ https://www.cdc.gov/bloodpressure/measure.htm
- ↑ https://www.ncbi.nlm.nih.gov/books/NBK279251/
- ↑ http://www.practicalclinicalskills.com/blood-pressure-measurement.aspx
- ↑ https://www.nursingtimes.net/clinical-archive/assessment-skills/blood-pressure-monitoring-21-06-2007/
- ↑ https://www.ncbi.nlm.nih.gov/books/NBK279251/
- ↑ http://www.practicalclinicalskills.com/blood-pressure-measurement.aspx
- ↑ https://www.nursingtimes.net/clinical-archive/assessment-skills/blood-pressure-monitoring-21-06-2007/
- ↑ https://www.cdc.gov/bloodpressure/measure.htm
- ↑ https://www.ausmed.com/cpd/explainers/korotkoff-sounds
- ↑ http://www.practicalclinicalskills.com/blood-pressure-measurement.aspx
- ↑ http://www.steeles.com/catalog/takingBP.html
- ↑ http://www.steeles.com/catalog/takingBP.html
- ↑ https://www.ncbi.nlm.nih.gov/books/NBK279251/
- ↑ http://familydoctor.org/familydoctor/en/diseases-conditions/high-blood-pressure/diagnosis-tests/blood-pressure-monitoring-at-home.html
- ↑ http://www.heart.org/HEARTORG/Conditions/HighBloodPressure/AboutHighBloodPressure/Understanding-Blood-Pressure-Readings_UCM_301764_Article.jsp
- ↑ http://www.heart.org/HEARTORG/Conditions/HighBloodPressure/AboutHighBloodPressure/Understanding-Blood-Pressure-Readings_UCM_301764_Article.jsp
- ↑ http://www.heart.org/HEARTORG/Conditions/HighBloodPressure/AboutHighBloodPressure/Understanding-Blood-Pressure-Readings_UCM_301764_Article.jsp
- ↑ http://www.heart.org/HEARTORG/Conditions/HighBloodPressure/AboutHighBloodPressure/Low-Blood-Pressure_UCM_301785_Article.jsp
About This Article
Thanks to all authors for creating a page that has been read 47,444 times.
Reader Success Stories
- "Helped give me a good introduction."
Advertisement
85%
of readers found this article helpful
.
Click a star to add your vote
% of people told us that this article helped them.
"Helped give me a good introduction."
