Download Article
Download Article
Whenever a project calls for a hard, permanent binding material, most professional and independent builders use cement. Before using cement, you need to mix it with sand and stone. While this process can seem overwhelming, it's fairly simple with the right tools. You can mix your cement in a wheelbarrow using a spade or shovel before applying it to the area you're paving.
Steps
-
Purchase the right amounts of cement, sand, and stone. The precise ratios will vary depending on the type of cement, so make sure to check your bag or the instructions that came with your cement. However, as a general rule of thumb, you will need one part cement, two parts sand, and four parts stone.- Always follow the instructions that came with the cement since adding too much sand, gravel, or cement can cause the concrete to break. [1]
X
Expert Source
Gerber Ortiz-Vega
Masonry Specialist & Founder, GO Masonry LLC Expert Interview. 10 March 2020.
- Always follow the instructions that came with the cement since adding too much sand, gravel, or cement can cause the concrete to break. [1]
X
Expert Source
Gerber Ortiz-Vega
-
Put on safety equipment. Cement will admit dust and debris that can be dangerous without the right safety equipment. Wear a dust mask, as well as safety glasses and long jeans. [2] X Expert Source Gerber Ortiz-Vega
Masonry Specialist & Founder, GO Masonry LLC Expert Interview. 10 March 2020. You should also wear a thick pair of gloves when mixing cement. [3] X Research sourceAdvertisement -
Assemble your supplies. Mixing cement is a messy process that requires a lot of attention. Assemble your supplies ahead of time. You will need your cement, sand, and stone, as well as a bucket, a wheelbarrow, and a shovel or similar tool for mixing [4] X Research source -
Dump your ingredients into a wheelbarrow. Use your small spade to shovel a ratio of one part cement, two parts sand, and four parts gravel into the wheelbarrow. Make sure you're wearing your dust mask, as dust and debris will get into the air during the process.
- To prevent the cement from drying out before you use it, don’t mix more than half a wheelbarrow at a time. Once you’ve used it up, you can create another batch.
-
Mix the ingredients together. Though they'll be mixed later, it's a good idea to have the dry mix thoroughly incorporated before adding the water. After pouring your cement, sand, and stone into the wheelbarrow, use a shovel or similar tool to mix the ingredients together until you have an even, uniform mixture. [5] X Research source
Advertisement
-
Make a crater in the pile of cement. Use your shovel to dig a small crater in the center of your cement mixture. The crater should be about half the diameter of the pile. When you're done, your pile should resemble a volcano.
-
Add a small amount of water. There is no precise amount of water to add to your cement. You merely need to add enough that you form a smooth paste with the consistency of peanut butter. Start small to avoid creating cement that's too soupy. Pour a small amount of water, like half a bucket, into the crater you made. Then, mix in the water with your shovel until it's completely absorbed. [6] X Research source
- If you're using the cement for something that will have a concrete finish, 3 parts concrete to 1 part water is usually best. If you're using the cement for a concrete foundation, it's OK if you use more water since the finish won't matter. [7]
X
Expert Source
Gerber Ortiz-Vega
Masonry Specialist & Founder, GO Masonry LLC Expert Interview. 10 March 2020.
- If you're using the cement for something that will have a concrete finish, 3 parts concrete to 1 part water is usually best. If you're using the cement for a concrete foundation, it's OK if you use more water since the finish won't matter. [7]
X
Expert Source
Gerber Ortiz-Vega
-
Test the mixture. Drag a shovel through the center of the cement. If the mixture is too dry, the sides of the groove you created will crumble. This means the mixture needs more water. [8] X Research source
Advertisement
-
Adjust the mixture as necessary. It will take some trial and error to get the right consistency. Add water a little at a time until you have a firm, spreadable paste. If you accidentally get the paste too wet, to the point the cement is soupy, add a little more of the dry mixture to fix this issue. [9] X Research source
-
Pour the mixed cement immediately into your project's area. This step needs to be completed as soon as possible. This prevents the cement from drying before you can complete your project. Tilt the wheelbarrow over the area where you're applying cement and pour the cement mixture in.
-
Clean up your supplies as soon as possible. That way the cement won't dry on anything. [10] X Expert Source Gerber Ortiz-Vega
Masonry Specialist & Founder, GO Masonry LLC Expert Interview. 10 March 2020. Pour water into the wheelbarrow as soon as you empty out the cement. Submerge your tools in the wheelbarrow. Then, scrub the wheelbarrow and tools with a stiff-bristle brush until it has been completely freed of any cement. [11] X Research source
Advertisement
Expert Q&A
Search
-
QuestionWhat is the ratio for cement mix?Gerber Ortiz-Vega is a Masonry Specialist and the Founder of GO Masonry LLC, a masonry company based in Northern Virginia. Gerber specializes in providing brick and stone laying services, concrete installations, and masonry repairs. Gerber has over four years of experience running GO Masonry and over ten years of general masonry work experience. He earned a BA in Marketing from the University of Mary Washington in 2017.It depends on the application. If you're going to do something with a concrete finish, you'll generally use three parts concrete and one part water. When you're mixing and pouring the concrete, you’re gonna have to add more water or it's not going to mix properly. If you're doing a concrete foundation for a retaining wall or a post, the concrete can be more wet because the finish is not going to matter.
-
QuestionHow do you keep concrete from sticking to tools?Gerber Ortiz-Vega is a Masonry Specialist and the Founder of GO Masonry LLC, a masonry company based in Northern Virginia. Gerber specializes in providing brick and stone laying services, concrete installations, and masonry repairs. Gerber has over four years of experience running GO Masonry and over ten years of general masonry work experience. He earned a BA in Marketing from the University of Mary Washington in 2017.Clean your tools as soon as you finish mixing or pouring concrete. Don't let it sit! This can help you prevent damaging your tools.
-
QuestionWhat safety precautions should be taken when mixing and placing concrete?Gerber Ortiz-Vega is a Masonry Specialist and the Founder of GO Masonry LLC, a masonry company based in Northern Virginia. Gerber specializes in providing brick and stone laying services, concrete installations, and masonry repairs. Gerber has over four years of experience running GO Masonry and over ten years of general masonry work experience. He earned a BA in Marketing from the University of Mary Washington in 2017.Put on safety glasses, a protective mask, and long jeans when you're going to be mixing and pouring concrete. This will protect you from the fine dust particles.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Video
Tips
- If your project requires more than one or two wheelbarrows of cement, consider renting a portable concrete mixer from your local hardware supplier.Thanks
- Consult the manufacturer's instructions on the cement bag before mixing. There may be some specific requirements of your brand that you will need to follow.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Things You'll Need
- Protective gear
- Heavy-duty wheelbarrow
- Cement mix
- Sand
- Stone
- Water source
- Small shovel or spade
References
- ↑ Gerber Ortiz-Vega. Masonry Specialist & Founder, GO Masonry LLC. Expert Interview. 10 March 2020.
- ↑ Gerber Ortiz-Vega. Masonry Specialist & Founder, GO Masonry LLC. Expert Interview. 10 March 2020.
- ↑ https://wedc-knowledge.lboro.ac.uk/resources/e/mn/056-How-to-make-concrete.pdf
- ↑ https://www.realsafety.org/2014/08/cement-safety-guidelines-for-protecting-your-skin/
- ↑ https://wedc-knowledge.lboro.ac.uk/resources/e/mn/056-How-to-make-concrete.pdf
- ↑ https://dot.ca.gov/-/media/dot-media/programs/engineering/documents/structureconstruction/ctm/sc-ctm-chpt3-a11y.pdf
- ↑ Gerber Ortiz-Vega. Masonry Specialist & Founder, GO Masonry LLC. Expert Interview. 10 March 2020.
- ↑ https://dot.ca.gov/-/media/dot-media/programs/engineering/documents/structureconstruction/ctm/sc-ctm-chpt3-a11y.pdf
- ↑ https://www.youtube.com/watch?v=Ftj8NvSJ1oE
- ↑ Gerber Ortiz-Vega. Masonry Specialist & Founder, GO Masonry LLC. Expert Interview. 10 March 2020.
- ↑ https://www.youtube.com/watch?v=Ftj8NvSJ1oE
About This Article
Article Summary
X
To mix cement, start by combining 1 part cement, 2 parts sand, and 4 parts gravel in a large bucket or wheelbarrow. Next, make a small crater in this mixture and add half a bucket of water. Mix the cement with a shovel and add more water until it’s formed a smooth paste similar to peanut butter. Then, use the cement for your project and clean your supplies as soon as possible so the cement doesn’t dry on your tools. For tips from our Home Improvement reviewer on what to do if your cement turns out too soupy, read on!
Did this summary help you?
Thanks to all authors for creating a page that has been read 693,870 times.
Reader Success Stories
- "Thanks for such a thorough explanation of how to mix cement. As a DIY'er, I needed to repair a concrete step and found this to be extremely useful and helpful!" ..." more
Advertisement
91%
of readers found this article helpful
.
Click a star to add your vote
% of people told us that this article helped them.
"Thanks for such a thorough explanation of how to mix cement. As a DIY'er, I needed to repair a concrete step and found this to be extremely useful and helpful!"
..."
more
"Liked the dry materials ratio to water. Nothing worse than putting time and money into a small project only to have a poor result."
..."
more
"I wasn't sure what the right amount of cement, sand and gravel was, as this is my first time doing anything like this!"
..."
more
"The whole process is useful, this will help me start my small house in my yard. Thanks for your help."
"I wanted to know about making cement. I have read important information. Thank you!"
