Q&A for How to Frame a Puzzle

Return to Full Article

Search
Add New Question
  • Question
    Can I glue a 3D puzzle?
    Community Answer
    Yes, just do one side at a time using puzzle glue or Modge Podge. Make sure each side dries thoroughly before gluing another side.
  • Question
    How can I flip the puzzle over?
    Community Answer
    You can use a puzzle mat (purchased from Amazon) that's designed to flip puzzles. You can also glue the front of the puzzle, let it dry, and then flip it over to the back.
  • Question
    Can I cover the face of a puzzle twice with the puzzle glue?
    Community Answer
    Yes. It is okay to give it several coats with puzzle glue or Mod Podge.
  • Question
    What do I use to fill in the cracks on my puzzle?
    Community Answer
    You could brush it with glue.
  • Question
    What if I have a puzzle that is like a hologram? Can I still use glue on it?
    Community Answer
    Make a decoupage glue. You just mix water with glue until it is a paste and spread it. It will dry clear, so it shouldn't mess up the puzzle.
  • Question
    Can I use the same clear glue on the back of the puzzle?
    Community Answer
    Yes, you can.
  • Question
    Can I glue a 3-D puzzle?
    Community Answer
    You can glue the front of the puzzle, but some glues will not adhere to the foam in the back. I think it is easier to do each side individually, reassemble the puzzle, and glue the corners.
  • Question
    How do I make a tray using my jigsaw puzzle?
    Community Answer
    Your jigsaw puzzle alone is not steady enough to use as a tray, so you must glue it to a harder surface, like a plank of wood. Once you've done that, you can buy handles to attach to the side of the wood plank, making it easier to hold your tray.
  • Question
    How do I hang a framed puzzle?
    Community Answer
    Put it inside a poster/picture frame and use a nail or two to hang it on the wall.
  • Question
    Is there a special way to frame a puzzle made of wooden pieces?
    Community Answer
    If it's flat, you could just frame it normally with the methods here, but if it's three-dimensional, get a strong, double sided sticker you can use to stick it onto the wall.
  • Question
    What is a trick that can be used as a backing material to frame a puzzle? Where can I buy this?
    Community Answer
    If you buy a poster frame approximately the same size as your puzzle (for about $15), it will come with a piece of cardboard the same size as the poster frame. Use this cardboard to glue your puzzle onto. If there is a small bit of cardboard showing after you glue your puzzle to it, it usually blends in with the puzzle quite nicely and will still look good.
  • Question
    How do I trim about 1/2" off the edges of a finished and glued puzzle that is just a little too big for my frame?
    Tina Aquilino Klein
    Community Answer
    If you must trim it, use an X-ACTO blade and a straight edge. You may have to score it several times. The best solution, to be honest, is a bigger frame or custom framing.
  • Question
    Where can I buy glue and a frame?
    Community Answer
    Your local craft store, like Jo-Ann's or Michael's, will have the glue, and both places also do framing and have ready-made frames as well.
  • Question
    I glued my puzzle twice to get the edges, but now it shines in some areas and is dull in others. What can I do to make it all shine before I frame it ?
    Community Answer
    Put corn oil on top like a glaze. You can also buy non-stick oil like Pam or use coconut oil.
Ask a Question

      Return to Full Article