PDF download Download Article
Solve why your car's warning light is on with our troubleshooting guide
PDF download Download Article

If your Honda Accord has a Check Fuel Cap light on the dashboard, it may mean there’s an issue with the EVAP emissions system. While the most common culprit is a loose fuel cap, other damaged parts may cause the error. Keep reading, and we’ll walk you through what’s making the Check Fuel Cap message appear and how you can fix it on your own.

Things You Should Know

  • Turn off your car and open the fuel door. Screw the fuel cap on tightly and start your vehicle to make the light turn off.
  • Check the purge valve connected to the engine to see if it’s stuck open, and replace it with a new part if it’s damaged.
  • Inspect the vent valve connected to the gas tank on your Honda Accord, and replace it with a new one if it’s clogged or broken.
Section 1 of 3:

Causes for “Check Fuel Cap” Message

PDF download Download Article
  1. The Check Fuel Cap error on a Honda Accord usually appears when your vehicle’s EVAP system senses a leak near the fuel cap. It could mean the cap wasn’t properly screwed on, the rubber gasket is worn, or there’s damage preventing a tight seal. [1]
    • Other symptoms: strong gas smell, reduced fuel efficiency [2]
    • Diagnosis: Open the fuel door on your Honda Accord and unscrew the fuel cap. Inspect the cap for damage, and check the round rubber gasket for cracks or tears.
  2. The purge valve (or solenoid) is a cylindrical piece next to your vehicle's engine intake and prevents fuel fumes from escaping into the air when your engine is off. When the purge valve fails, it may get stuck open and trigger a Check Fuel Cap warning. [3]
    • Other symptoms: poor engine performance, rough idling, reduced fuel efficiency, and hard starting after adding fuel [4]
    • Diagnosis: Connect a vacuum pump to the intake on the purge valve and squeeze the handle. If the vacuum pressure goes down after pumping, then the purge valve is leaking. [5]
    Advertisement
  3. The vent valve is a small cylindrical piece on the side of your vehicle’s fuel tank, and it brings fresh air into the EVAP system while your engine is running. If the vent valve gets stuck open, your Honda may detect a leak and trigger the Check Fuel Cap message. [6]
    • Other symptoms: lit Check Engine light, strong fuel smell, gas pump clicks off when filling up [7]
    • Diagnosis: Disconnect the vent valve from your gas tank and connect the intake to a vacuum pump. If the pressure slowly drops after you squeeze the handle, then the vent valve has a leak. [8]
  4. Advertisement
Section 2 of 3:

Repairing a Check Fuel Cap Light

PDF download Download Article
  1. Turn off your vehicle and open the fuel door on your Honda Accord. Check that the fuel cap is tight by wiggling it around. Then, unscrew the fuel cap completely and inspect the threadings for damage. Put the fuel cap back on and turn it clockwise until you hear it click and restart your vehicle. [9]
    • After tightening your fuel cap, it may take a few drives for the warning message to turn off. If you still see the message after 2 days, then there may be another issue.
    • If you notice any dirt or dust built up on the fuel cap or where it connects to the gas tank, wipe it off with a clean lint-free cloth. The dirt or dust may have been preventing a tight seal. [10]
    • If your fuel cap is damaged or missing, then get a replacement cap . Typically, they only cost $10–15 USD, and you can install the gas cap on your own.
  2. Locate the cylindrical purge valve on the side of your engine near the fuel intake. Disconnect the electric connector and the hoses from the old valve, and unscrew the bolts to remove it. Install a replacement purge valve in its place and reconnect the hoses and wires. [11]
  3. Locate the vent valve underneath your vehicle connected to the side of the gas tank. Unplug the electrical connector and pry out the vent valve with a screwdriver. Slide the replacement vent valve into the port and screw it back on tightly. Reconnect the cord to finish your repair. [12]
    • Vent valves typically cost $20–50 USD.
  4. Typically, it takes a couple of days or drives for the EVAP system to reset. If the Check Fuel Cap message turns off within 1–2 days, then you’ve solved the issue. If it stays on, take your vehicle to a mechanic to check for other leaks or issues.
  5. Advertisement
Section 3 of 3:

FAQ

PDF download Download Article
  1. While you may burn through fuel a bit faster, you can still safely drive your Honda Accord. The EVAP system won’t damage your engine or release harmful fumes in your car. [13]
  2. It’s okay to drive without a fuel cap for the short term, but it will burn more fuel and cause warning lights to appear on your dashboard. If you need to have your vehicle tested for emissions, you’ll also need a working gas cap. [14]
  3. Advertisement

Expert Q&A

Ask a Question
      Advertisement

      Video

      Tips

      • If the Check Fuel Cap light stays on after repairs, reset the fuses to your EVAP and diagnostic systems by unplugging them from the fuse box. Reinsert them after 30 seconds to turn off the warning message. If it appears again, take your vehicle to a mechanic because there may be a larger issue.
      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Thanks for submitting a tip for review!
      Advertisement

      About This Article

      Thanks to all authors for creating a page that has been read 5,505 times.

      Did this article help you?

      Advertisement