How to Remove Caulk

PDF download Download Article
PDF download Download Article

When caulk has lost its effectiveness, it needs to be replaced. Before you can apply new caulk, though, you'll need to remove the old stuff. Some of the principles used in removing caulk can also be used to remove caulk stains. Keep reading to learn more about these techniques.

Method 1
Method 1 of 4:

Removing Caulk

PDF download Download Article
  1. Fresh caulk can usually be removed without softening it, but older caulk that has fully hardened may need to be softened first in order to make it pliable enough to remove. You can usually do this with water, vinegar, chemicals, or heat, depending on the type of caulk.
    • Commercial caulk remover is the simplest choice and may be your best option for silicone caulk. Apply the caulk remover by squeezing a wide bead along the caulk line, completely covering it from end to end. Let it sit for several hours as directed on the label. [1]
    • If you are dealing with non-acrylic water-based caulk, you can soak the caulk with saturated rags for 72 hours to soften the caulk effectively.
    • If dealing with water-based acrylic caulks or polyvinyl acetate resins, soak the caulk by dampening it with iso-propyl rubbing alcohol. [2]
    • To use heat on any form of caulk, apply heat from a hair dryer on the lowest setting for 30 to 40 seconds. Work in patches of about 8 inches (20 cm) at a time. [3]
  2. Use a small razor blade to cut through each end bead of caulk, exposing the edge of the line.
    • Alternatively, you can slice from end to end, spanning the full length of the caulk and cutting the line completely in half. Doing so can free up more edge and may even cause some of the caulk to fall out on its own.
    Advertisement
  3. Grab the exposed edge of the caulk with your fingers and pull out as much as possible. Pull toward the direction of the remaining line of caulk to lift it out.
    • If you cut along the full length of the caulk line, peel up the line starting on one end and pull in the direction opposite that end to remove as much as possible.
  4. Use a glass scraper to scrap out any remaining, visible caulk. Hold the scraper at a shallow angle, keeping it as flat as possible, to avoid scratching the surface.
    • You could also use a putty knife, plastic razor blade, or another similar tool. [4] Keep in mind that the tool you use should have a fairly flat “blade” with a somewhat dull edge. You do not need to cut more of the caulk out with this tool; you only need the tool for the sake of scraping away caulk from underneath.
  5. If you cannot reach some of the caulk with your scraper, use needle-nose pliers to pick and pull out any visible chunks.
    • Needle-nose pliers are preferable to other types of pliers since they tend to be narrower and are easier to maneuver in and out of small crevices.
  6. Use the hook end of a painter's five-in-one tool to scrape out any remaining caulk debris from the crevice. [5]
    • Scrape in one direction, pulling as much of the caulk away and out as possible. Hopefully, you should be able to get rid of the rest of the chunks after completing this step.
    7. Advertisement
Method 2
Method 2 of 4:

Removing Moldy Caulk Residue

PDF download Download Article
  1. Soak the abrasive pad in mineral water or mineral spirits before scrubbing with firm, even force along the surface from which the old caulk had been removed.
    • Rubbing the surface down with mineral spirits strips away any remaining caulk residue. Residue can prevent new caulk from sticking. Moreover, if there is mildew or mold caught in that residue, it poses a health hazard if it is not removed.
  2. Clean away soap scum by thoroughly scrubbing the surface with a cleaner and sponge.
    • Do not use ammonia or a cleaner that contains ammonia. You will be using bleach in the next step, and when combined, bleach and ammonia can create toxic fumes.
  3. Combine 1/3 cup (80 ml) bleach with 1 gallon (4 L) of water until well mixed. Apply this solution to the gap from which the caulk was removed.
    • Use paintbrush or foam brush too apply the bleach solution.
    • Let the solution sit on the caulk for about five minutes before disturbing it.
    • Scrub the bleach away with a toothbrush or firm plastic pad.
  4. Rinse the area with warm water and pat the surface and the gap with a clean, dry rag.
    • At this point, you can and should apply new caulk. Make sure that the surface is completely dry before doing so, however, since caulk may not adhere to wet surfaces.
    5. Advertisement
Method 3
Method 3 of 4:

Removing Silicone Caulk Stains from Hard Surfaces

PDF download Download Article
  1. Before applying any chemical solvent to a caulk stain on marble or any other hard surface, rinse the area with mineral water or distilled water to remove any residue.
  2. Choose a chemical solvent noted for effectiveness against silicone caulk. Dampen the stained area using a clean rag.
    • Note that you only need to use heavy solvents on silicone caulk stains. Other types of caulk stains, like acrylic and non-acrylic caulks, are less stubborn and can usually be removed with nothing but water and physical scraping.
    • Common, effective chemicals include Methylene Chloride, Dichloromethane, Methylene Bichloride, and Methylene Dichloride.
  3. Combine additional solvent with enough white absorbent material to form a thick paste.
    • Possible absorbent material options include molding plaster, untreated white flour, white tissue, white paper towels, powdered chalk, talc, fullers earth, or laundry whiting.
    • Note that you'll need about 1 lb (450 g) of paste for every square foot (30.5 square cm).
  4. Layer the paste on the caulk stain using a plastic or wooden spatula. Make sure that the paste is 1/4 inch (6.35 mm) thick or less.
    • This paste should cover the entire stain and extend a bit past the edges. If you do not let the paste extend past the stain, the stain could end up being forced onto clean patches of stone.
    • After applying the paste, make sure that the coating is free of any air pockets.
  5. Cover the paste with plastic sheeting and seal the edges off with masking tape. Let it set for 48 hours undisturbed.
    • If using a solvent with other instructions, however, follow the instructions provided on the solvent label.
  6. Doing so softens the hardened paste enough to help lift it off.
  7. Use a wooden or plastic spatula to gently scrape away the paste and the loosened caulk.
    • Do not use anything harder since many hard surfaces, like marble, can get scratched up as a result.
  8. Rinse the area once more with mineral water or distilled water to remove any residue. Blot dry with clean paper towels.
    • You might need to apply this treatment multiple times before all the caulk comes up. You can do so once the surface is completely dry.
    9. Advertisement
Method 4
Method 4 of 4:

Removing Caulk Stains from Cloth

PDF download Download Article
  1. If you catch the stain as soon as the caulk gets onto the material, you might be able to wipe most of it off with a clean, damp rag.
    • Gently rub at the stain. As you rub, use a slight upward motion to encourage the caulk to come off the material instead of rubbing it further into the fibers.
    • You could attempt to simply dab at the stain, but this may not be enough force depending on how much the caulk has already begun to set.
    • Use warm water instead of cold water since warmth encourages the caulk to stay soft.
  2. If the caulk got on your clothes or some other removable item of fabric, place the stained item in the freezer for 30 to 60 minutes or until well frozen.
    • You do not, of course, need to do this step or any of the following steps if the caulk came off simply by scrubbing it.
    • When ready, the fabric should be very stiff and the caulk should be hard to the touch.
  3. The solidified caulk should be easier to remove. You can scrape at it with a painter's chisel until the strip of caulk begins to peel up, then peel the rest away with your fingers.
    • It is not recommended for you to chisel or scrape away the entire caulk stain. Doing so could cause the fibers in the material to tear more than necessary.
  4. [6] If some of the caulk stain still remains, you can apply a small amount of an acetone-based cleaner directly to the stain before dabbing it out.
    • Before using the acetone, test it on a small part of the material hidden along the underside. Acetone can fade and ruin certain fabrics, so testing it is necessary if you do not want to risk further damage.
    • Apply the cleaner to the fabric using a cotton swab or cotton ball. Let it sit for five minutes or as directed on the label before rinsing out with warm water.
    • Launder the cloth as usual when done.
    5. Advertisement

Community Q&A

Search
Add New Question
  • Question
    What is mineral water?
    Community Answer
    Water that contains some minerals, such as salts. If you're looking for it at a store, it will be clearly labeled "mineral water."
    Thanks! We're glad this was helpful.
    Thank you for your feedback.
    If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
    Yes No
    Not Helpful 11 Helpful 6
  • Question
    How do I remove silicone caulking applied to a wood surface to stick ceramic tiles? The ceramic tiles have been removed, but the silicone is very much still there.
    Community Answer
    Acetone is a possible solution, but be careful of the fumes. Also use a good scraper.
    Thanks! We're glad this was helpful.
    Thank you for your feedback.
    If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
    Yes No
    Not Helpful 8 Helpful 7
  • Question
    How can I open a window that is stuck shut with caulk?
    Community Answer
    Cut into the caulk with a knife with a new blade. Score it all around the window. Try to scrape out as much of the caulk as you can. Gently pry the window between the stop and the sash until it starts to move freely. Keep scoring with your knife and prying. Use a putty knife to pry with. Eventually the window will work free. WD40 also helps to loosen the caulk.
    Thanks! We're glad this was helpful.
    Thank you for your feedback.
    If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
    Yes No
    Not Helpful 8 Helpful 2
See more answers
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
      Advertisement

      Tips

      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Submit
      Thanks for submitting a tip for review!

      Things You'll Need

      • Commercial caulk remover
      • Mineral water
      • Clean rags
      • Iso-propyl rubbing alcohol
      • Hair dryer
      • Razor blade
      • Glass scraper
      • Needle-nose pliers
      • Painter's five-in-one tool
      • Abrasive pad
      • Non-ammoniated bath cleaner
      • Bleach
      • Wooden or plastic spatula
      • Paintbrush
      • Bucket
      • White absorbent material
      • Caulk-removing chemical solvent
      • Plastic sheeting
      • Masking tape
      • Paper towels
      • Freezer

      You Might Also Like

      How to
      Get Mold Out of Shower Caulking
      How to
      Get Silicone Caulk Off Your Hands
      How to
      Remove Silicone Caulk: An Expert Guide, with Tricks
      The Best Way to Remove Silicone Caulk
      How to
      Caulk the Kitchen Sink
      How to
      Puncture the Seal on Caulk
      How to
      Apply Silicone Sealant
      How to
      Caulk Around a Toilet Base
      How to
      Keep Silicone from Drying Out
      How to
      Caulk a Bathtub
      How to
      Caulk a Shower Drain
      How to
      Remove Caulking Stains from Clothes
      How to
      Caulk
      How to
      Caulk Outside the House
      Advertisement

      References

      1. ↑ http://www.familyhandyman.com/tiling/how-to-remove-caulk-easily/view-all#step1
      2. ↑ http://www.askthebuilder.com/caulk-removal/
      3. ↑ http://www.homerepairtutor.com/easily-remove-silicone-caulk/
      4. ↑ Emily Fazio. Home Improvement & DIY Specialist. Expert Interview. 27 July 2021.
      5. ↑ http://www.popularmechanics.com/home/improvement/interior/4213124
      6. ↑ http://www.youtube.com/watch?v=o0BMXqbuZwM

      About This Article

      Article Summary X

      To remove old caulk, soften it first so it's easier to remove. You can apply a commercial caulk remover or soak the caulk with water-saturated rags for 72 hours. Once the caulk has softened, use a small razor blade to slice through it and create exposed edges, making it easier to remove. Next, pull out as much caulk by hand as you can and scrape away any remaining caulk using a glass scraper. If you need to remove moldy caulk residue, soak an abrasive pad in mineral water and scrub the residue away. Then, use a non-ammoniated bath cleaner to clean away any soap scum. For more information on removing caulk, like how to remove caulk from a cloth, read on!

      Did this summary help you?
      In other languages
      Thanks to all authors for creating a page that has been read 443,591 times.

      Did this article help you?

      Advertisement