Download Article
Download Article
Drivers rely on car seats to keep babies and children safe, but some experts report that only 15% of car seats are properly installed. To install one, first recognize if you have a rear facing seat or a front facing one. Then, look at its parts to see if it is held in place by the vehicle’s seat belt, anchor belts attached to the car seat itself, or both. Always read the manufacturer’s instructions for full and precise instructions and safety recommendations. You can also watch installation videos to do so.
Steps
-
Separate the carrier from the base. Most rear-facing seats consist of two parts: the base and the infant carrier. You will install the base, the part that remains in the car. Follow the manufacturer’s instructions for removing the carrier from the base. Usually, there is simply a lever or button to activate.
-
Anchor the base to your car's back seat. Many car seat bases include an attached belt with two hooks that can latch onto designated spots near your car’s seat belt area. If your car manufacturer included these, snap the hooks onto the metal bars at those designated spots. [1] X Trustworthy Source National Highway Traffic Safety Administration U.S. government agency responsible for writing and enforcing Federal Motor Vehicle Safety Standards Go to source
- Tighten the anchor belt attached to the base until the base is snug against the seat.
- Check the manufacturer's instructions if you aren't sure if your car or seat has this option, or how to use it.
- There may also be a place to feed the car’s seat belt through the base for added security.
Advertisement -
Thread the seat belt through the base, alternatively. If your car seat does not use the anchor system, it will be best if you secured to the backseat with the car’s seat belt. Feed the belt through designated openings in the base and buckle it. The seatbelt should fit cleanly, and not be twisted or bunched up. [2] X Trustworthy Source National Highway Traffic Safety Administration U.S. government agency responsible for writing and enforcing Federal Motor Vehicle Safety Standards Go to source
- Read the instructions to study where you are supposed to put the belt if you aren't sure.
- Every vehicle and seat is different, so it's important to get this right.
- Not latching the seat belt correctly can increase the risk of the child getting injured in an accident.
-
Pop the infant carrier into the base. Set it onto the base so that the child would face the rear. It should click when it's in the right position. You can then practice taking the carrier out (by activating the lever or button) and setting it back into get a feel for things. And also, read your instructions manual to find the correct travelling position for the carrying handle.
-
Double check the base angle. Rear facing car seats usually have bases that can rest at different angles. The youngest infants will need to be in the more reclined position. This helps them breathe properly. [3] X Trustworthy Source National Highway Traffic Safety Administration U.S. government agency responsible for writing and enforcing Federal Motor Vehicle Safety Standards Go to source
- Most infant carriers have level indicators on either location. Once yours is in place, read this level to see if the seat is at the correct angle for the babies’ weight/height/age.
- Check the manufacturer’s instructions for how to properly read the level if it isn't clear.
- Change the base angle if the level is not correct or your child. Usually, this involves turning the base over and rotating a piece.
- If this feature is not supported, a rolled towel or pool noodle may be placed under the seat crease if permitted by the manufacturer.
- Remember to change the angle later on (or switch to a different seat) if the baby outgrows one setting.
Advertisement
-
Thread the seat belt through the car seat. The back and/or bottom of the forward-facing car seat should have openings where a back seat belt should pass through so it can be buckled on the other side. After pulling the belt through and buckling it, push down on the car seat and pull on the belt so that it locks.
- Make sure that the belt is not twisted or bunched up as you pull it through.
-
Anchor the seat with the tether. Many forward-facing car seats include an attached tether that feeds over the top of the vehicle’s seat and latches onto a metal anchor on the back. Locate this anchor and latch the tether belt to it, tightening it afterwards.
- Consult your vehicle’s manual if you can’t find an anchor. Top tethers reduce the amount of head movement in a crash.
-
Attach the car seat to the vehicle’s seat with latches, alternatively. Your forward-facing seat may instead use the latch system. Two buckles with metal hooks attached to the bottom of the car seat should latch onto designated spots where the back and bottom of the vehicle’s seat meet. Pull on the belt of the buckles to tighten.
- A forward-facing car seat with the latch system may also include a tether and/or place to feed the seatbelt through. If so, use these in addition to the latch system to make the seat as secure as possible.
Advertisement
-
Select a car seat based on your child’s age, weight, and height. To provide the most protection, newborns should always be in a rear facing seat. Until they're at least a year old and potentially up to age three, a rear facing seat is an option. Move up to a forward facing seat for older infants and toddlers.
- How long to keep your child in a rear facing seat will depend on its height and weight, as well as the manufacturer’s specifications.
- Experts recommended keeping your baby in a rear-facing seat for as long as possible. A rear-facing car seat reduces impact on a baby’s delicate head and neck in an accident. [4] X Research source Use one until your child reaches the upper height or weight limit set by the manufacturer.
- Some car seats are all-in-one, starting out in the rear facing position and converting to forward facing when your child is available. Check the owner’s manual for specific instructions on how to convert your seat.
-
Pick a spot in the backseat. Child car seats should always be positioned in the backseat, never the front seat. Many drivers like to set them behind the drivers seat to make it easy to check on them from the rear view mirror, without turning their head. [5] X Trustworthy Source National Highway Traffic Safety Administration U.S. government agency responsible for writing and enforcing Federal Motor Vehicle Safety Standards Go to source
-
Check the seat's fit. Once installed, the car seat base should not move more than 1 inch (2.5 cm) in any direction. Whichever kind of car seat you are using, always pull on it a bit in all directions before placing your child inside. If it seems to move too much, tighten any straps or belts that are too loose. [6] X Trustworthy Source National Highway Traffic Safety Administration U.S. government agency responsible for writing and enforcing Federal Motor Vehicle Safety Standards Go to source
-
Secure your child in the seat. After placing your child in the car seat, place the two straps over their shoulders and buckle them at the lap harness. Buckle the chest clip and make sure it stays at armpit level. Tighten the straps until you cannot pinch any extra material on them at the child’s shoulders.
- Make sure the straps are flat and not twisted.
- The correct way to tighten the straps will depend on your model of car seat. Most have a place to pull on and latch the strap. Check the manufacturer’s instructions if you aren’t sure.
- For safety reasons, do not place extra material (such as a blanket) underneath the straps. If you want to cover your child, buckle them in first, then add the cover.
Advertisement
Community Q&A
Search
-
QuestionI disassembled the straps and washed the cover. How do I thread the straps?Community AnswerDepending on which one you are talking about, usually they are fastened to the back of the car seat. Just retrace your steps from un-threading them.
-
QuestionWhy do I have to turn off the passenger airbag?Community AnswerThe force that the airbag deploys is so great that it could kill your child (even if the accident was a simple fender bender).
-
QuestionShould the shoulder straps be below the shoulders or just above the shoulders?Community AnswerThe shoulder straps should be above their shoulders.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Video
Tips
- An extended rearward facing child car seat allows a child to travel rear facing for longer. Most will be designed for use up to 18kg/40 pounds (about 4 years old), some to 25kg/55 pounds (around 6 years old). [7] X Research source Experts suggest children should ride in a rear-facing car safety seat for as long as possible, up to the limits of their car safety seat. This includes virtually all children under 2 years of age and most children up to age 4. [8] X Research source
- In some European countries, it is now law that children must travel rear-facing until they reach four years of age. [9] X Research source
Thanks - Once your child has outgrown the top height and/or weight limit of a front-facing car seat, it will be the best time to transition into a booster seat . Watch the booster seat installation video to learn how.Thanks
- As your child grows, you will need to move the car seat’s shoulder straps and lap harness to different positions. Check the car seat manufacturer’s instructions for guidelines.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Warnings
- The back seat in the middle position is usually the safest place for children 12 and below. Do not install a baby or child car seat in the front seat near a frontal airbag. This is especially dangerous (and possibly illegal in your country) for rear-facing seats. It could cause serious injuries or paralysis. It's always safer for children to travel in the back of the car. [10] X Trustworthy Source National Health Service (UK) Public healthcare system of the UK Go to sourceThanks
- Check the expiration date on either location. Discontinue use of this car seat and throw it away from 6 to 10 years after the date of manufacture (DOM).Thanks
- Purchasing used car seats is not recommended, as those may have missing parts and/or an unknown history.Thanks
- Without using the top tether, the child’s head and torso will move forward during a crash.Thanks
Advertisement
References
- ↑ https://www.nhtsa.gov/car-seats-and-booster-seats/how-install-rear-facing-only-infant-car-seat
- ↑ https://www.nhtsa.gov/car-seats-and-booster-seats/how-install-rear-facing-only-infant-car-seat
- ↑ https://www.nhtsa.gov/car-seats-and-booster-seats/how-install-rear-facing-only-infant-car-seat
- ↑ https://childcarseats.org.uk/media/1022/extended-rearward-facing-child-car-seats.pdf
- ↑ https://www.nhtsa.gov/car-seats-and-booster-seats/how-install-rear-facing-only-infant-car-seat
- ↑ https://www.nhtsa.gov/car-seats-and-booster-seats/how-install-rear-facing-only-infant-car-seat
- ↑ https://childcarseats.org.uk/media/1022/extended-rearward-facing-child-car-seats.pdf
- ↑ https://publications.aap.org/aapnews/news/12188/New-child-passenger-safety-seat-guidance-advises?autologincheck=redirected
- ↑ https://childcarseats.org.uk/media/1022/extended-rearward-facing-child-car-seats.pdf
About This Article
Article Summary
X
If you want to install a rear-facing car seat, start by separating the base from the carrier. Then, fix the base to your car's back seat by connecting the hooks provided through the loops next the seatbelt buckle. If your model doesn't have hooks, thread the car's seatbelt through the base instead to secure it. Next, set the carrier into the base. Lastly, adjust the seat if necessary by turning the base over and rotating part of it. For tips on how to install a front-facing car seat, keep reading!
Did this summary help you?
Thanks to all authors for creating a page that has been read 340,834 times.
Reader Success Stories
- "It was just a very helpful article. I really enjoyed it a lot. Thanks for helping me out. I really appreciate it."
Advertisement
"It was just a very helpful article. I really enjoyed it a lot. Thanks for helping me out. I really appreciate it."
