PDF download Download Article PDF download Download Article

Prostrate spurge ( Euphorbia maculata ), also called spotted spurge, is a tricky annual weed that grows during the summer months in sunny, hot areas. Once spurge takes root, it can spread fast and be tough to get rid of! Give soil solarization or mulching a try to get rid of spurge without using chemicals. Different types of herbicides can also be effective, although you have to be careful where and when you apply them. Frequent mowing and regular lawn maintenance can help you keep spurge in check!

Method 1
Method 1 of 4:

Solarizing the Soil

PDF download Download Article
  1. Solarization is most effective when the sun is at its brightest and the sky is cloudless. Spring is often rainy and the other months are too cool for solarization. [1]
    • Spurge will usually take root and set seed after 5 weeks of warm weather.
    • If you live somewhere cool and foggy, like some coastal regions, solarization may not work for you.
  2. Loosen up the dirt by pushing a shovel into the soil and spreading the loose dirt around the area. Make sure the dirt is level by smoothing the dirt with a shovel. [2]
    • A good rake can also be useful for leveling.
    Advertisement
  3. Test the water depth by pushing a long screwdriver or spade into the dirt. If it does not sink easily down to 12 in (30 cm), keep watering and test again. [3]
    • The water allows the sun's rays to go deeper into the soil in order to kill and prevent the spurge seeds from growing.
  4. Lay the tarp as close to the soil as possible to get the most out of the sun’s heat. Anchor the corners with rocks or soil so the tarp does not come loose during wind or storms.
    • Be sure you get a clear tarp so the sunlight can get through it.
    • You can buy clear tarps at most home improvement stores and online.
    • A black tarp will also work, since it will soak up the sun’s heat and warm the ground underneath it.
  5. Avoid leaving it any longer than that, since the plastic will start to break into pieces and become ineffective. Once you remove the tarp, you can resume gardening as you usually would in that area. [4]
    • Use caution when using this method, since any other plants that are already growing in the covered area will die.
  6. Advertisement
Method 2
Method 2 of 4:

Applying Herbicides

PDF download Download Article
  1. Choose an herbicide with oryzalin, dithiopyr, pendimethalin, prodiamine, benfluralin, isoxaben or trifluralin. Apply the herbicide following the manufacturer’s instructions before the outdoor temperature reaches 60 °F (16 °C). Make sure to wear gloves and eye protection. [5]
    • If you're a home gardener, you will be able to buy pendimethalin, trifluralin, dithiopyr, and oryzalin. The other types are only available to landscape professionals.
    • Do not use pre-emergent herbicides on a home vegetable garden, since the chemical residue lasts for months after application.
  2. Corn gluten also works as a pre-emergent herbicide, with the advantage of being safer for you and the environment than harsh chemical herbicides. Sprinkle the granules on any weed-infested areas before the weeds have a chance to sprout. Apply according to the directions on the package.
  3. Choose an herbicide with Glyphosate 2,4-D. Wear eye protection and gloves and follow the manufacturer’s instructions closely. Once the spurge dies, remove it from the area. [6]
    • Pick a non-selective herbicide with glyphosate to kill all the plants in the area where it is applied.
    • Use a selective 2,4-D broadleaf herbicide if you want to protect grass and plants that may be underneath the spurge.
  4. Choose 20% acetic acid options, which you can buy at home improvement stores. Put the herbicide in a spray bottle or other applicator and spray the spurge thoroughly. Use these herbicides when the plants are young for best results. [7]
    • These herbicides are not selective and will kill or damage any plant they come into contact with, including grass.
    • These herbicides are non-toxic when used appropriately.
  5. Advertisement
Method 3
Method 3 of 4:

Removing Small Patches

PDF download Download Article
  1. Grip the weed in the middle between the top and the ground and pull upward. This helps remove the taproot, which will prevent the same plant from regrowing. [8]
    • If the soil is not moist, water the area you want to weed for several minutes before starting to hand weed.
  2. It's best to pull weeds out when the plants are young. This usually occurs during spring months (April-May), depending on your region.
    • Make sure to bag up and dispose of the weeds after you pull them out. Leaving them behind can allow their seeds to spread and grow.
  3. Put 3 in (7.6 cm) to 6 in (15 cm) of coarse mulch on top of the weeds you want to kill. The mulch will starve the plants of oxygen and sunlight. [9]
    • Keep in mind that mulch breaks down over time. Check it occasionally and replace it when it starts looking thin.
    • Maintaining a thick and even layer of mulch on bare ground will also prevent weed seeds from growing.
  4. Cover the spurge with several layers of newspaper and stamp down on top of the newspaper to flatten it on top of the weeds. Dampen the newspapers with water and cover them with a thick layer of mulch.
  5. Advertisement
Method 4
Method 4 of 4:

Preventing Prostrate Spurge

PDF download Download Article
  1. Use a reel mower to keep the grass short where the weeds tend to grow. The spurge will not be able to move in as easily if you keep your lawn dense, short, and healthy. [10]
  2. Before the grass and weeds start to grow, fertilize your lawn and water for 30 minutes afterward. Fertilizing the lawn will help produce healthier grass, which is a way to prevent weeds from spreading. [11]
    • If you are trying to control spurge in an area outside of a lawn or turf area, do not fertilize. The grass will probably not be maintained and fertilizing the area will only help the weed grow faster.
  3. Maintaining a healthy lawn or mulched area is the first defense against controlling spurge. Water the lawn for 30 minutes. Test to make sure the grass has enough water by trying to push a screwdriver into the dirt. If it sinks easily to 6 in (15 cm), do not continue to water it. If not, water for another 10 minutes and retest. [12]
    • Depending on the type of grass you have, it may be more heat and drought-resistant than others.
    • Also, if you live a dry climate, you will need to water your grass more often.
  4. Advertisement

Expert Q&A

Ask a Question
      Advertisement

      Tips

      • Wear gloves to protect your skin from the irritating sap that comes out of the spurge stems.
      • When applying herbicides, do not allow the chemical to drift onto nearby desirable plants and grasses. Follow all directions on the label and avoid spraying when it is too hot out.
      • If you are not confident in your ability to apply herbicides correctly, do a search for a certified herbicide applicator in your area, or ask at a local garden center.
      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Thanks for submitting a tip for review!
      Advertisement

      About This Article

      Thanks to all authors for creating a page that has been read 44,204 times.

      Did this article help you?

      Advertisement