Download Article
Download Article
Impress your friends on your aviation knowledge. Landing a plane is the most important part of a flight. Fly safe! These instructions assume you are approaching a towered airport for landing in a left traffic pattern, and the winds are calm and visibility is good.
Steps
Download Article
-
Get the ATIS (Automatic Terminal Information Service) and tell the control tower what happened (if it's an emergency) 10 miles (16 km) out from entry into the airspace. [1] X Research source ATIS will give you a code such as "Information alpha" to give to tower. Contact the control tower or approach control for that airport, and state the following:- " tower/approach name, aircraft tail number, location, altitude,
Landing with information whatever "ATIS" code you received above." The tower will give you instructions. This guide assumes they instructed you to take left (or right) traffic for Runway X and to report on 45 (45 degree downwind entry to runway being used). (This is a rough guideline, it's missing some specific information that tower sometimes asks for)
- " tower/approach name, aircraft tail number, location, altitude,
Landing with information whatever "ATIS" code you received above." The tower will give you instructions. This guide assumes they instructed you to take left (or right) traffic for Runway X and to report on 45 (45 degree downwind entry to runway being used). (This is a rough guideline, it's missing some specific information that tower sometimes asks for)
-
Do your pre-landing check with your checklist. Brakes checked, undercarriage down & locked, Mixture fully rich, Fuel selector on both, Flaps as required, (Propeller pitch fixed), Suction indicating, Oil Temps. and Press. (Ts&Ps) in green, Master on, Mags on both, (Carb. heat to HOT if RPM is below 1500RPM) Hatches & Harness' locked and latched, Landing lights on. PLANE CLEAR TO LAND. [2] X Research sourceAdvertisement -
Apply Carb. Heat and make your descent to where you reach pattern altitude for that airport by the time you reach the 45° entry leg. You can be a little higher on the 45. Let's assume the pattern altitude is 1,200 feet (365.8 m) MSL. Try to descend at 500 feet (150 m) per minute. That will be easier on your ear drums. -
Reach the 45 and tell the tower how many miles you are out on the 45 and your altitude. The tower might clear you to land or will acknowledge. -
When you reach 1 ⁄ 4 mile (0.4 km) from the runway, turn downwind. [3] X Research source By now the tower should have cleared you to land. You should have slowed the plane to 80 to 85 knots and powered the engine to around 2000 rpms. -
When you are abeam the downwind runway numbers, turn on your carburetor heat on, and power back to 1500 rpm. Hold the nose level until the airspeed drops into the white arc, then extend 10 degrees of flaps. Pitch for 75 knots using outside visual reference, then confirm with the airspeed indicator. Make sure you coordinate your turns with the rudder pedals. Be especially careful not to use excessive inside rudder however: skid + stall = spin! -
When the threshold of the runway is 45° behind you, turn left base, and apply another 10 degrees of flaps. This should bring your airspeed down to 70 knots. Do not add flaps while in the turn; only after turn is complete. You are now perpendicular to the runway. Be especially careful not to overshoot your final turn at an airport with parallel runways, because the parallel runway might have landing traffic. [4] X Research source -
Turn Final. When the field is made (you would reach it even if the engine were to quit), extend the next 10 degrees of flaps (again, after the turn is complete). The spot on the ground where you will land will appear stationary. Use pitch to maintain approach speed (usually 60-70KIAS). Use power to control altitude. Be careful to keep airspeed above 60KIAS, but do not fixate on the airspeed indicator. Use the ailerons to correct for any crosswind and the rudder pedals to keep the plane aligned with the runway center-line. -
When you are a few feet off the ground, gently power back and level off. Keeping level will require increasing amounts of back pressure on the yoke, and (increasing amounts of aileron in a crosswind). After touchdown keep the yoke pulled all the way back and to whichever side is needed for crosswind. Only apply the brakes if necessary (for field length or to avoid holding up other landing traffic). Continue on the runway centerline until you reach taxi speed (a fast walking pace), then turn off at the nearest taxiway and do not stop until you have passed the hold short line. [5] X Research source -
Complete your post landing checks, then call tower if they have not called you already. [6] X Research source
Advertisement
Community Q&A
Search
-
QuestionWhat is a standard turn?Community AnswerA standard turn is one with a bank angle, and one that will take you 2 minutes to complete a full 360 degree circle.
-
QuestionI took 5 yrs off after 220 hrs flight time. My check off instructor demonstrated an engine out (power to idle) on downwind. He put it into a slip and maintained it to landing, flared and a smooth landing. I tried it and my landing was not as smooth. Is this a safe maneuver?Community AnswerA slip landing should not be necessary if your approach is normal. Some use the slip to lose altitude when their approach is too high. A slip is dangerous because you could stall the aircraft. A go-around might be safer if you're too high.
-
QuestionHow do I note the AGL with the altimeter?Community AnswerThe altimeter, if properly adjusted for barometric pressure, indicates mean sea level altitude. AGL is the difference between the altimeter indication and surface elevation.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Video
Tips
- If you are overshooting the runway, don't be afraid to go around. Apply full power and push to keep the airspeed up and the nose from coming up too high. Establish a positive rate of climb and clean up the airplane, flaps in stages. The difference between a good pilot and a fool is the willingness to make a go around.Thanks
- If you don't have at least a student pilot certificate, you can only go up with a flight instructor. Even then, you will need endorsements from a flight instructor on the back of your certificate and in your logbook stating you are qualified to fly solo.Thanks
- Have fun.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Warnings
- If you don't know how to fly a plane, this can be dangerous.Thanks
- This is only a general guide. Ask your instructor about the specific procedures at your local airport.Thanks
- Flying a plane without a pilot certificate is illegal and dangerous.Thanks
- Don't fly under the influence of drugs or alcohol.Thanks
Advertisement
References
- ↑ https://www.experimentalaircraft.info/flight-planning/aircraft-performance-2.php
- ↑ https://web.cs.wpi.edu/~rich/courses/cs525u-s08/projects/mtavares/Cessna172.pdf
- ↑ https://www.boldmethod.com/learn-to-fly/maneuvers/how-to-fly-a-traffic-pattern-at-non-towered-airports/
- ↑ http://krepelka.com/fsweb/lessons/student/studentlessons06.htm
- ↑ https://www.youtube.com/watch?v=PlLwxj8fxlY
- ↑ https://leaviation.com/wp-content/uploads/2016/11/Cessna172N_Checklist_revised_11-2-12.pdf
About This Article
Thanks to all authors for creating a page that has been read 436,343 times.
Reader Success Stories
- "The whole chapter is very helpful, the landing procedures and all steps."
Advertisement
83%
of readers found this article helpful
.
Click a star to add your vote
% of people told us that this article helped them.
"The whole chapter is very helpful, the landing procedures and all steps."
