Steps
-
Make sure lantern is cool before removing the fuel cap. The tank (fount) may be under pressure so open slowly.
-
If needed, add fuel using a small funnel. A funnel that has a filter will ensure the cleanliness of the fuel. If the lantern is capable of using unleaded gasoline, then it can be used. If the lantern is for use with Coleman liquid fuel, then this is the only type that should be used. Coleman fuel is preferred due to the cleaner burning as compared to unleaded gasoline. [1] X Research sourceAdvertisement
-
Check the mantles. If the lantern does not have mantles installed or the old ones have a hole in them, they will need to be installed or replaced. Tie the mantle(s) on the burner tube and cut off the excess string. The instructions should be on the package. With a match or lighter, hold just beneath the mantle and it will burn. Allow the mantle to burn until it turns into a white ash. Once it turns into a white ash, it will be fragile so if it gets touched or bumped, it will break. Never use a mantle that has a hole in it. This will let a jet of hot gas shoot out of the hole and could burn the glass globe. Reinstall the glass globe and reassemble the lantern. [2] X Research source
-
Find the pump handle and turn it to the left a turn or two. What you are doing is unlocking the check valve so air can flow through it. With your thumb over the hole in the pump handle, give it 30-40 full strokes. This will build up air pressure inside the tank (fount). After pumping is complete, turn the valve to the right until it closes all the way. [3] X Research source
-
Check for the cleaning lever and rotate it'. The lantern, if it's older should have some sort of small lever sticking either out of the back or out the side of the frame. This could resemble a small brass wire either bent over or bent into a small loop. Rotate this lever in a circle, either direction, for a couple of turns. This is clearing the generator tip where the fuel/air mixture will come out of. If it's a newer lantern, rotate the main valve wheel fully open and closed several times, this also is clearing the generator tip.
-
Open the main fuel valve slightly until you hear a gurgling sound. This is the fuel/air mixture being released from the generator tip into the mantle. If you just hear air, you may have a fuel air tube problem.
-
Get ready with your match or lighter and open the main fuel valve while applying the flame inside the lantern just below the mantle. It should light on fire. Flames may be visible inside the globe and may go up into the vent hood. This is normal. Once the mantle produces enough heat, the generator, the small brass tube behind or near the mantle, will heat to the point when the fuel is converted to a gas. Once this happens, the flames will subside and a bright glow will appear. Open main fuel valve fully.
-
After several hours of use if lantern the starts to dim, rotate the cleaning lever several times again to clear the generator tip and/or add more air pressure using the pump. The lantern should remain bright for several hours with a clear tip and the initial air pressure that was applied. If the lantern dims after a short time, a half hour or so, it may be leaking pressure.
-
Close fuel valve fully to shut off lantern. The lantern may burn for up to a minute or so while the remaining fuel is burned off.
-
Make sure lantern is fully cool before placing in any container or opening the cap on the fount.
Advertisement
Expert Q&A
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Video
Tips
- The liquid fueled lanterns and stoves can be used much more cheaply than the propane types.Thanks
- The older Coleman lanterns and stoves can be rebuilt and can easily last 50 years or more. There are many online resources for parts and collectors with vast experience.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Warnings
-
- Use only the recommended fuel, preferably fuel that isn't too old.
Thanks - Never use a mantle that is damaged or has a hole in it.Thanks
- Never open the fuel cap while lantern is hot.Thanks
- Make sure lantern is cool before placing in any sort of container.Thanks
- Never use indoors. The lantern puts off a lot of CO gas that is deadly.Thanks
Advertisement
References
About This Article
Thanks to all authors for creating a page that has been read 87,871 times.
Reader Success Stories
- "Thanks. Been so long since I camped, I'd forgotten how to use the old thing. Just love the smell, the sound, the pulsating light from the mantles. Propane's too sterile." ..." more
Advertisement