Download Article
Download Article
So you've experimented with making bracelets with loom bands and making bracelets with beads; now you want to bring the two together to make loom band with beads. Follow these steps to learn how to make loom bands with beads.
Steps
-
Get your materials together. You will need:
- Loom bands- it's easiest to use one colour at first.
- Beads- if you have a bead kit it's perfect, but you just need some beads with a hole big enough to fit a piece of string through.
- String- coloured is best, the best is the string you get in a bead kit. Make sure that it is long enough to fit around your wrist.
- Your fingers.
-
Start stringing your loom bands as you would in a fishtail loom. Start by putting one band in a figure of 8 position on your middle finger and index finger. Then put another band normally on your middle finger and index finger above the first band. [1] X Research sourceAdvertisement
-
Put an 'S' clip on the figure of 8 band. Then take your string, thread it through the second band and tie it on to the figure of 8 band.
- Next, hook the figure of 8 band on to the second band, like you would in a fishtail band.
-
Take a third loom band and place it on your middle finger and index finger. Thread the string through the middle of this band. Then take a bead and slide it to the bottom of the string.
- Take the second band and hook it on to the third band. Don't worry if the bead pops out- you can rectify this at the end.
-
Repeat until you reach the end of the bracelet and it is long enough to go around your wrist. Remember, put each band on your middle finger and your index finger, thread the string through, slide the bead on the string, hook the band onto the bead, then put another band on your fingers. Continue doing this to the end. [2] X Research source
- Remember, don't let go of the string when a bead is on it or the bead will slide off of the end.
- Get plenty of bands and beads- you don't want to run out halfway through.
-
At the end, put a last band on but don't put a bead on. Then hook the end to the 'S' clip. Poke the beads that have popped out into the bands if you want, but it looks good either way. Cut the loose end off the string. Your loom band with beads is now finished.
Advertisement
Community Q&A
Search
-
QuestionHow do you make a name in loom beads?PoohbearfanaticCommunity AnswerBuy an Alpha loom. It's like a rainbow loom, but it's for making loom bracelets with names.
-
QuestionCan you make this without the string?Top AnswererYes. Instead of placing beads on the string, you can squeeze a band through the center of the bead and make the bracelet that way.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Tips
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Warnings
- Do not pull the bands off of your fingers at any time whilst you are making it, or you will not be able to recover it. [3] X Research sourceThanks
Advertisement
References
About This Article
Thanks to all authors for creating a page that has been read 36,753 times.
Reader Success Stories
- "This article helped me because it taught me about making loom bands with beads."
Advertisement