PDF download Download Article PDF download Download Article

Furniture made from bamboo can give your home an exotic look and it’s relatively cheap to buy. If you want to make your piece stand out or restore your old furniture, you can easily spray paint it within a weekend. Bamboo has a smooth surface that doesn’t hold paint well, so be sure to rough up the surface and apply primer before you add your color. While you can try using a brush to apply the color, spray painting it will get into hard-to-reach areas and give it an even coat that will last. You can even use this method on rattan furniture, too!

Part 1
Part 1 of 3:

Sanding and Cleaning the Surface

PDF download Download Article
  1. Check for any screws or fasteners holding the cushions or upholstery in place. Use a screwdriver or pair of pliers to pull the fasteners out from the furniture and set them aside while you’re working so you don’t lose them. Put the cushions and upholstery in an area where they won’t get dirty. [1]
    • If you’re working on a desk or dresser, remove the drawers and take off any handles or hardware on the exterior surface.

    Tip: Reupholster the cushions with a different fabric or pattern if you want them to match the furniture’s new color.

  2. Apply slight pressure as you rub the entire surface with the sandpaper. Be careful not to press too hard since you could crack the bamboo if it’s old or weak. Work in circular motions to strip the outer protection from the bamboo so the primer and paint adhere to it. Try to evenly sand the bamboo as best as you can so the color looks consistent. [2]
    • If the furniture was previously painted, be sure to sand the paint off completely. [3]
    • Avoid using an electric sander since you could break the bamboo.
    • Bamboo has a slippery surface, so your paint won’t stick to it unless you sand the furniture.
    Advertisement
  3. [4] Use a soft-bristle hand brush to wipe the surface of the furniture clean. Focus on small crannies or areas that have intricate details where sawdust is most likely to get stuck. Shake the brush off into a trash can every few minutes so you don’t reapply the sawdust to the surface. [5]
    • You can buy hand brushes from hardware stores, or you can use the one that came with your dustpan if you have one.
    • Avoid using a stiff-bristled or abrasive brush since you could scratch the bamboo and leave marks on the furniture.
  4. Put the brush attachment on your vacuum’s hose and run it over your furniture. Pay close attention to areas where sawdust could get caught, such as carved detail or seams between pieces. Rub the brush attachment back and forth over the furniture so the bristles lift up any dust that’s still stuck on the surface. [6]
    • The brush attachment will wipe off the sawdust without damaging or scratching the bamboo.
    • If your vacuum doesn't have a brush attachment, you can buy one online or try using a crevice attachment.
  5. Wet a microfiber cloth with warm water and wring it out so it isn’t dripping wet. Go over the entire piece with the rag to get rid of residual sawdust so your furniture is clean. Rewet the cloth as it dries out and continue working. After wiping the furniture down, leave it to air-dry completely so it doesn’t feel damp to the touch. [7]
    • Avoid getting the bamboo dripping wet since it could cause lasting damage.
  6. Advertisement
Part 2
Part 2 of 3:

Priming the Bamboo

PDF download Download Article
  1. Find a work area that’s outdoors or in a well-ventilated space, such as a garage, for priming and painting. Fold a drop cloth in half and lay it down on the ground to protect the area underneath from overspray. Set your piece of furniture in the middle of the drop cloth. [8]
    • You can buy drop cloths from your local hardware store.
    • If you don’t have a drop cloth, you can set the piece of furniture on a large sheet of cardboard instead.

    Warning: Avoid working in a poorly-ventilated area since spray paint produces harmful fumes.

  2. Wear wraparound safety glasses that cover your eyes completely. Then put on a face mask that goes over your nose and mouth so you don’t breathe in any fumes or overspray. Wear your safety equipment any time you start priming or painting. [9]
    • You can buy safety glasses and face masks from your local hardware store.
    • If you’re working in an indoor area, opt for a full respirator instead of a face mask since it will protect you from fumes better.
  3. Shake the can of primer thoroughly to ensure it’s properly mixed before you use it. Hold the can upright so it’s about 6–8 inches (15–20 cm) away from the piece of furniture so it doesn’t apply too thick or overspray. [10]
    • Oil-based spray primer is similar to spray paint, but it creates a base coat so the paint adheres better and has a solid color. You can buy it from your local paint supply or hardware store.
  4. Press the button down on the can to start spraying your piece of furniture. Keep moving the can back and forth across the piece of furniture so you don’t apply too much primer to a single area. Continue working across the entire piece until there’s a thin, even coat of primer. [11]
    • Test spraying the primer on your drop cloth or a piece of cardboard first to ensure it sprays evenly. Sometimes, the primer may clog and spray unevenly the first time you use it.
    • If you don’t apply primer before you start painting, the color won’t stick on your furniture as well and the surface will look uneven. [12]
  5. Leave the piece of furniture in an area where it won’t get disturbed so the primer has time to set. After about 30 minutes, lightly tap the surface with a finger to see if any of the primer lifts up. If the primer feels dry, then you can move on. Otherwise, allow it to sit for another 30 minutes before checking it again. [13]
    • Primer drying time may vary, so check the can you’re using to see how long you should wait.
  6. Work in circular motions to smooth out any raised areas of primer so you have a smooth painting surface to work with. Replace the piece of sandpaper as it gets dirty with dust from the primer. [14]
    • You can also use a sanding sponge instead if you have trouble getting a good grip on the sandpaper.
  7. Dip a microfiber cloth in warm water and wring it out. Lightly rub the primed surface with the cloth to pick up any dust left on the surface from sanding the primer. Work your way over the entire piece of furniture until you don’t lift up any more dust. [15]
    • You may also brush or vacuum the dust if you want.
  8. Advertisement
Part 3
Part 3 of 3:

Painting the Furniture

PDF download Download Article
  1. Pick a color that matches or complements the other pieces of furniture in your home so it doesn’t clash. Get 1–2 cans of the color to ensure you have enough to coat the entire piece. [16]
    • You can buy enamel spray paint from a hardware or paint supply store.
    • Enamel spray paint works for both indoor and outdoor bamboo furniture.

    Tip: Avoid using acrylic spray paint if you plan on keeping the furniture outdoors since it could get damaged from water.

  2. Leave the cap on the can and shake it for about 15 seconds to properly mix the paint. Position the can upright and hold it about 6 inches (15 cm) from the piece of furniture to help prevent overspray. [17]
  3. Press the button down that’s on top of the can to start spraying the paint. Keep moving the can back and forth over the surface so you don’t apply paint too thickly to one area. Work your way around the entire piece until you have an even coat of color. [18]
    • It’s okay if you can still see some of the primer through the first coat of paint.
    • Always work in thin layers since they’ll dry faster and make the color look consistent across the entire piece of furniture.
  4. Leave the furniture alone so it doesn’t get disturbed while it’s drying. After about 30 minutes, check if the paint feels dry to the touch. If it does, then continue working. Otherwise, wait another 15 minutes before checking the paint again. [19]
    • Drying time between coats may vary depending on the kind of spray paint you have, so always check the can you’re using to find out how long they recommend you wait.
  5. Start your next coat of paint and work over the entire surface of your furniture. Move the can around while you’re spraying to keep the layer thin or even. Allow the coat to dry completely before checking if you need another one. Continue adding coats of paint and allowing them to dry until the furniture has a consistent color. [20]
    • Usually, it will take 2–3 coats of spray paint to finish your piece.
  6. Once the paint dries, set the cushions or upholstery back on the furniture. Use a screwdriver or a hammer to reattach the fasteners so the upholstery doesn’t move around or shift. [21]
  7. Advertisement

Expert Q&A

Search
Add New Question
  • Question
    How do you get spray paint off your skin?
    Andres Matheu
    Residential Painter
    Andres Matheu is the Owner of Hömm Certified Painting Systems, an Interior and Exterior Residential painting business based in the Washington, DC Metro area. Andres specializes in interior and exterior residential painting, color consultations, cabinet refinishing, wallpaper removal, and epoxy flooring among other services. An EPA Lead-safe Certified Firm, Hömm Certified Painting Systems has been awarded the Best of Houzz 2019 Service, Angie's List Super Service Award 2019, and Northern Virginia Magazine's 2018 Best Home Experts (painters) award.
    Residential Painter
    Expert Answer
    If it's a water-based spray paint, all you will need is soap and water. If it's oil-based, a hand-cleaner will work well.
Ask a Question
      Advertisement

      Tips

      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Thanks for submitting a tip for review!

      Warnings

      Advertisement

      Things You’ll Need

      • Screwdriver
      • 150-grit sandpaper
      • Brush
      • Vacuum with brush attachment
      • Microfiber cloth
      • Drop cloth
      • Safety glasses
      • Face mask
      • Oil spray primer
      • 220-grit sandpaper
      • Enamel spray paint

      About This Article

      Thanks to all authors for creating a page that has been read 64,611 times.

      Reader Success Stories

      • Connie Spiegel

        Apr 3, 2021

        "You answered all of my questions beforehand, and I really appreciate the detail, explanation and excellent drawings ..." more
      Share your story

      Did this article help you?

      Advertisement