Q&A for How to Make Soda in a SodaStream Machine

Press the carbonation button more times! My SodaStream came with a little sticker on top advising that the best carbonation was three buzzes (the buzzes come a little while after you push the button) but...you can press as many times you want.

My SodaStream has a snap lock system. Just push the bottle in - no screwing is needed.

Add more flavoring, sugar, honey, or any other sweetener you like.

For a sodastream bottle that is 1 liter, it's around 10 seconds of holding down the button on a new CO2 cylinder. It takes longer as the CO2 cylinder gets older.

After it's been carbonated, sure. But you'll want 100% liquid water in there for the carbonation process. A little bit of ice inside wouldn't hurt, but it's a good general rule to avoid it.

Yes, this can happen. If your getting a little, then it may be not full. Contact customer service to get a replacement.

You can, but it may make a terrible mess as the drink you are mixing will over-fizz due to the contents of the syrup mix.

It should be on top of the SodaStream. (That is, if you have a traditional SodaStream machine.)

When the cylinder is empty, it will stop producing any gas. You will be able to hear nothing is going in.

Yes, as that is what carbonates the soda.

You generally do not need to add bicarbonate of soda to make soda water with a SodaStream machine. Just use plain water, and the machine will carbonate it for you.

Check if the power cord is plugged in, and ensure the fuse isn't blown. Unplug the machine, wait 20 seconds, and then plug it back in.

If you are not getting carbonation, it may be empty. Generally, if you use the SodaStream daily, the cylinder will last 3 to 4 months.

For a half-liter bottle, use 3 to 5 carbonation pumps.

As long as you don't open the cap too often, the fizz should last throughout your drinking experience.

Turn the bottle counterclockwise slowly to start fizzing, and then quickly turn it clockwise to stop the fizz.

No, you should do repeated quick pushes within 10 seconds, not three separate 10-second pushes. Always check the instructions.

Look for syrup at your local store that is compatible with SodaStream. It comes in a small bottle and should have the SodaStream logo on it.

Most CO2 tanks have a lifespan of about 3-5 years, but this can vary based on how often they are used and refilled. The longevity also depends on the storage conditions.

You should add the flavoring after the water has been carbonated. Adding flavoring first can contaminate the carbonation tube.

Your bottle might be damaged. Check for any chips and replace it if necessary. Also, if you've washed your bottle in a dishwasher, it might have shrunk or warped from the heat, causing the issue.

You can technically use any liquid, but using juice will contaminate the carbonation tip, so it's best to use only water.

Remove the bottle top and then reattach it. It might have been placed crookedly, causing it not to fit. If that doesn't work, the bottle may be defective due to a factory error.

The SodaStream primarily makes carbonated water, and you can add flavors to it. If you use the SodaStream flavor syrups, you can create drinks that taste similar to traditional soda. However, it doesn't exactly replicate the formula of store-bought soda. It's more like flavored sparkling water, but with the right flavor mix, it can come pretty close to "real" soda!

Turn off and unplug the machine, unscrew the bottle from the base, locate the carbonator cylinder, and turn it counterclockwise to loosen. Carefully pull the empty cartridge out and replace it with a new one by inserting it and turning it clockwise until secure.

To identify the model of your SodaStream, check for a label or sticker on the back or bottom of the machine, refer to the user manual, or visit the official SodaStream website for images of different models.

Yes, you can just wash out the bottle afterwards and you should be all set.

Most likely this is happening because the seal on the bottle is not connected properly or a cane is damaged. You can push the bottle upwards to seal it better or contact customer service for a replacement.

Check to make sure that the bottle is screwed in properly because if it isn't, then the CO² will escape and you'll get the flat liquid.

This can be solved by pushing the buttons a few more times. If this is not the case, it may indicate that you cylinder is empty or running low. You may need to buy another one or take the cylinder to a seller of the SodaStream for a discount.