PDF download Download Article PDF download Download Article

Tired of clumsily plucking your eyebrows with tweezers or damaging the fragile skin around your eyes with wax? Perhaps it’s time to try threading, where you use thread to remove unwanted eyebrow hair. You can try threading at home with a few supplies. Before you start threading, make sure you prepare your eyebrows properly so the threading is quick and easy to do. With the right approach, you can have beautiful, well shaped eyebrows in no time.

Part 1
Part 1 of 3:

Gathering the Necessary Supplies

PDF download Download Article
  1. To thread your eyebrows, you will need high-cotton sewing thread. Measure out a piece of thread that is as long as your forearm, plus three inches. It should be around 14 inches or 35 cm long. [1]
    • Using high-cotton sewing thread will ensure your eyebrow hairs do not snap off between the thread. High-cotton thread tends to grip hair better than synthetic thread.
    • Thread is the best thing to use for threading. Do not use floss or string as this will not be as effective as thread.
  2. You will use the eyebrow scissors to trim your eyebrows before you thread them. You can also use small hair shears or small sewing scissors. You want scissors that will be small enough to trim your brows and sharp enough to get at the hairs. [2]
    Advertisement
  3. You will use the brush on your brows to prepare them for the threading. You can use a standard eyebrow brush or a fine toothed hair comb. Make sure the brush or comb is clean as you do not want to get bacteria or dirt in your brows before you thread them. [3]
  4. You will use the pencil to draw the shape you want for your eyebrows. This will help to guide you as you thread your eyebrows. Go for an eyebrow pencil that is the same shade as your brows or slightly darker than your brows. [4]
    • You should also check that the eyebrow pencil will wash off with water or makeup remover so you can get rid of the outline once you are done threading your eyebrows.
  5. You will use the aloe vera or the ice pack to soothe your brows after you are done threading them. The aloe vera or ice pack will also help with any redness or irritation that develops due to the threading. You can use aloe vera from a bottle or a standard ice pack, wrapped in a clean towel. [5]
  6. Advertisement
Part 2
Part 2 of 3:

Preparing Your Eyebrows for Threading

PDF download Download Article
  1. To prepare your eyebrows for threading, sit in front of a mirror with your supplies spread out before you on a table. Make sure the room has good lighting so you can clearly see your eyebrows in the mirror. This will make it easier to prepare and thread your brows.
    • Do not use a magnifying mirror, as this can lead to over threading. A standard mirror with good lighting will be fine.
    • Make sure you know your face shape before shaping your eyebrows. [6]
  2. Watermark wikiHow to Thread Your Eyebrows
    Take the eyebrow brush and sweep your eyebrow hair straight upward. Then, hold one section in place with the comb. Use the small eyebrow scissors to trim a very small amount of the tall hairs that stick out from the comb. Then, sweep your eyebrow hair downward with the comb and hold it in place again. Snip any long, standout hairs with the scissors. [7]
    • Make sure you do not cut the hairs too short or trim too many of the hairs. You simply want to remove any overly long strands of hair so it is easier for you to thread your brows.
    • Repeat these motions on the other eyebrow so both eyebrows have been trimmed. Comb the hair back in place when you are done trimming them. They should appear more groomed and clean.
  3. Watermark wikiHow to Thread Your Eyebrows
    Once you have trimmed your eyebrows, take the eyebrow pencil and carefully draw out the eyebrow shape you’d like to have. If your goal is to have full, clean looking brows, you may draw out a thicker arch and a higher brow line so you can follow the outline when you thread. Start from the inside of your brow and draw outward in a sweeping motion. Try to make the outline for each brow as even and symmetrical as possible. [8]
    • Customize the outline based on your existing eyebrow shape. If you have thin arches to your eyebrows, for example, you may not draw a thinner arch outline. If you have a lot of extra hair growth around your eyebrow arches, you may draw a thinner arch outline so you can remove these extra hairs when you thread them.
  4. Advertisement
Part 3
Part 3 of 3:

Threading Your Eyebrows

PDF download Download Article
  1. Watermark wikiHow to Thread Your Eyebrows
    Hold the thread against your forearm and make sure it is long enough. Then, tie the two ends together to form a loop. Make sure the thread is tightly knotted together. Trim off any loose ends so you have a clean loop of thread. [9]
  2. Watermark wikiHow to Thread Your Eyebrows
    Hold one end of the loop with your thumb and forefinger. Let the other end hang motionless between your other thumb and forefinger. Twist the loop four to five times while holding one end of the loop with your thumb and forefinger. [10]
    • You should eventually have a twisted section in the middle of the loop with the loop taunt between your thumb and forefinger on each hand. It will look like an hourglass or bow tie shape.
  3. Watermark wikiHow to Thread Your Eyebrows
    Before you start threading your eyebrows, practice the threading motion with your hands. Open one hand with your thumb and forefinger positioned in the loop. Then, close the other hand. The loop’s center twist should move back and forth as you increase and decrease the distance between your thumbs and forefinger. This twisting motion will be what you will use to remove your eyebrow hairs.
    • You may need to practice this motion several times to get the hang of it. If you find the loop is too hard to control, you may try making a new loop that is shorter in length. You may find a shorter thread loop is easier to manipulate between your fingers.
    • You can also use your other fingers to help gain control of the loop. You can use the middle finger and ring finger of your dominant hand in addition to your thumb and forefinger to help you get the hang of manipulating the twisted center of the loop.
  4. Make sure you position the twisted center over your eyebrow, directly over the hairs you want to remove. Your fingers should be firmly positioned in the loop with your thumb and forefinger on one end and your thumb and forefinger on the other end.
  5. Watermark wikiHow to Thread Your Eyebrows
    As you do this, open your other hand. Slide the twisted center against your skin slowly and firmly. The corners of the twisted center will grab your hairs and remove them as you open and close your hands. [11]
    • Always thread your eyebrow hairs in the opposite direction of their growth. This will ensure the hair comes out easily and reduces your risk of developing ingrown hairs.
    • Do not tug too hard on your skin or press the twisted center too deep into your skin as this can lead to irritation and pain. Instead, glide the twisted center across your skin to remove the hairs.
  6. Watermark wikiHow to Thread Your Eyebrows
    Once you finish one stroke and remove a section of hair, place the twisted center back to the starting position and do another stroke, removing another section of hair. Make sure you also remove any hair between your eyebrows with the thread, making sure you move the thread in the opposite direction of the hair’s growth.
    • You can remove a small amount of hair or a larger amount of hair depending on how quickly you glide the twisted center over the hair. You may start with a slow glide until you get the hang of the movements and can move more quickly.
  7. Watermark wikiHow to Thread Your Eyebrows
    Once you finish threading both eyebrows, you may have some redness or irritation on your skin. Place some aloe vera or an ice pack wrapped in a towel over your brows to soothe them. The redness around your eyebrows should go away after about an hour. [12]
    • After an hour, you should examine your eyebrows and check for any stray hairs you may have missed. You may use the threading to remove the stray hairs or pluck them out .
    • You can also fill in any gaps in your eyebrows with an eyebrow pencil to make them look fuller and more uniform.
  8. Advertisement

Expert Q&A

Search
Add New Question
  • Question
    How do I align my eyebrows with my face shape?
    Shipra Taneja
    Makeup Artist
    Shipra Taneja is a Makeup Artist and the Founder of Taneja's Bride, a lifestyle, beauty, and fashion blog. She specializes in creating bold, colorful makeup looks. Shipra is passionate about making colorful makeup comfortable for everybody.
    Makeup Artist
    Expert Answer
    Find pictures and get inspiration, and if you don’t understand the shape you need, get feedback from a professional before handling your brows.
  • Question
    Can I use the threading method to remove hair between my eyebrows?
    Laura Martin
    Licensed Cosmetologist
    Laura Martin is a Licensed Cosmetologist based in Milledgeville, Georgia. She has been working as a hair stylist since 2007, and began a career as a cosmetology teacher in 2013. She worked as a teacher at Arrojo Cosmetology School, teaching cosmetology practices, hairstyling, and hair color application. She also brought her cosmetology expertise to her work as a staff writer for fashion blog Style Noted, writing pieces related to hair and fashion. She received an MFA in Creative Writing from Georgia College & State University, where she was also an English Teaching Fellow. Additionally, she received a BA in Creative Writing and Literature from New York University.
    Licensed Cosmetologist
    Expert Answer
    Absolutely! Just be careful not to remove the brow hair by mistake.
  • Question
    How do I control the thread?
    I like sushi
    Top Answerer
    It takes some practice and adjusting, but once you find what works for you, it's very easy.
See more answers
Ask a Question
      Advertisement

      Video

      Reader Videos

      Tips

      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Thanks for submitting a tip for review!

      Things You'll Need

      • 14 inches (35 cm) of high cotton sewing thread
      • An eyebrow brush
      • Small scissors
      • An eyebrow pencil
      • Aloe vera or an ice pack

      About This Article

      Article Summary X

      To thread your eyebrows, start by measuring out a piece of thread that’s about 14 inches long and tying the ends together to form a loop. Next, hold 1 end of the loop with your thumb and forefinger, and use the other hand to twist the loop 4 to 5 times so you have a twisted section in the middle. Then, place the twisted section over your eyebrow where you want to remove the hair. Finally, slide the twisted section slowly and firmly against your skin to pull away the hairs. To learn more, including how to soothe redness and irritation after removing your eyebrow hairs, read on!

      Did this summary help you?
      Thanks to all authors for creating a page that has been read 1,404,006 times.

      Reader Success Stories

      • Kelly Miles

        Apr 4, 2017

        "This story was extremely helpful in teaching me how to thread my eyebrows. It is so much faster than tweezing, and ..." more
        Rated this article:
      Share your story

      Did this article help you?

      Advertisement