Download Article
Download Article
You will require a lot of 2" by 4" pieces of wood, at least 8 as long as you want a side of the pool, and a lot of other ones for the bracing, at least 20 braces will be needed depending on height of pool.
Steps
-
Build braces for the side of the pool by placing two pieces of wood the length of the pool on the floor. find out what height you want the pool and then cut wood to that length minus the width of the 2" by 4".
-
Screw the pieces into the wood at minimum 1" distances and maximum 2" distance.Advertisement
-
Repeat step 1 and 2 until you have 4 braces like this.
-
Cut 4 pieces of plywood to the height and length of the braces. Attach them on the front side of the bracing.
-
Now you need to build side bracing to hold the water in. You can either design your own bracing or use this one. Build a box of 2" by 4" the height of the pool with another piece of 2" by 4" on the inside going diagonally. Try to make sure the wood on the inside goes from the top of the pool wall to the ground at the bottom of the base.
-
Build at least 4 for each side, and attach them to the 2" by 4" on the inside of wall bracing.
-
Attach the walls together by either putting them together and screwing the sides in, or you can use a block on the corners and connect them. The first one is the simpler and easier one, you just require long screws.
-
Screw the pool walls into the floor from the braces and from the pool walls itself, use many, many, many screws.
-
Put the pool liner inside the pool walls you have connected, and then screw 1" by 4" or 1" by 3" into the top of the pool walls to secure the plastic.
-
Fill it with water.
-
Finished.
Advertisement
Community Q&A
Search
-
QuestionAll I can find is oval and round pool liners. Where can I find a square one?Community AnswerAny pool supplier will provide liners built to fit any pool you build. Try Doheny's Pool Supplies.
-
QuestionWhat thickness of plywood is needed?Community AnswerIt all depends on what size the pool is going to be. For any pool larger than 6 foot, use plywood between 25-40mm.
-
QuestionWhat is the black stuff shooting out of the pipe on step 9? Black cement?EeshmaCommunity AnswerThat was the water. It was drawn as black to make the water pops out for your eyes because the background is blue.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Video
Tips
- You do not need to set up a pump to fill the pool, but it would help to keep it clean.Thanks
- If you don't put chemicals into the pool or use the new UV method, then the pool will get disgusting over only a few days at max, possibly a day at minimum.Thanks
- You can line the floor of the pool with plywood to try to help it, but it doesn't matter.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Warnings
- The deeper the pool is, the greater the water pressure pushes the walls out. Be prepared for catastrophic failure of the walls.Thanks
- Water will leak out, you'll have to clean it up or the floor could be warped depending on how much.Thanks
Advertisement
About This Article
Thanks to all authors for creating a page that has been read 216,016 times.
Advertisement