How to Calibrate an Oven: Digital and Analog

PDF download Download Article
PDF download Download Article

It's frustrating to find that your oven is running too hot or too cold—signs that it's time to calibrate it. Ovens heat in cycles, so it's completely normal that the temperature fluctuates a little. It's when the temperature is off by more than 10 degrees that you need to make adjustments. In this article, we'll show you how to check your oven's temperature so you know how much you need to calibrate it and then walk you through how to calibrate both digital and analog ovens.

Things You Should Know

  • Calibrate a digital oven by holding the bake, broil, and/or settings buttons down to access the menu. See steps below for specifics based on oven type.
  • Once you have accessed the digital calibration menu, use the +/- or arrow keys to program the amount to offset.
  • For an analog oven, pull off the temperature knob. You should see some screws and a shaft—twist the shaft in the direction you wish to calibrate.
  • If your analog oven does not have a shaft, check the back of the knob for a dial—some models require you to twist that to calibrate instead.
Method 1
Method 1 of 3:

Checking Your Oven’s Temperature

PDF download Download Article
  1. Open your oven and look for a straight narrow rod extending from the back—this is the oven sensor rod that detects the temperature inside the oven. Check that it's not touching the sides or top of the oven because this could throw the temperature reading off. [1]
    • If the oven sensor is touching the oven walls, tighten the screws that hold the rod in place. If you can't move the sensor rod away from the walls, call an appliance repair person before you calibrate your oven.
  2. Place an oven thermometer in the oven and set the oven to 350 °F (177 °C). You don't need expensive tools or equipment to check the oven temperature—an inexpensive oven thermometer will do! Hang it or set it on the middle rack of the oven and turn the oven on to 350 °F (177 °C). [2]
    • Remove pots, pans, or sheets so the thermometer and oven racks are the only things in the oven.
    Advertisement
  3. Ovens heat in cycles, so the temperature fluctuates. Give your oven 20 minutes to come to temperature. Then, open the oven door and make a note of the temperature. [3]
  4. Keep the oven on and set to 350 °F (177 °C) after you take the first reading. Set a timer for 20 minutes and then write down the temperature again. [4]
    • For the most accuracy, repeat this for a full hour. This gives you a lot of data for determining if your oven temperature is off.
  5. Add up all of the temperatures and divide the number by the number of readings you took. The result should be within 10 degrees of 350 °F (177 °C). If it's off by more than 10 degrees, you'll need to calibrate your oven. [5]
    • For example, if your 3 oven readings were 378 °F (192 °C), 362 °F (183 °C), and 355 °F (179 °C), the average temperature is 365 °F (185 °C). Your oven's temperature is off by 15 degrees—this is the offset number.
    6. Advertisement
Method 2
Method 2 of 3:

Calibrating a Digital Oven

PDF download Download Article
  1. Although the process for calibrating a digital oven is pretty simple, the process can vary from brand to brand. Read your owner's manual to find the specific buttons you have to press to access the calibration menu. [6]
    • Can't find your owner's manual? No problem—just search online for the manual to your specific model.
  2. To start the calibration process, get into the calibration menu on your oven. Usually, you have to hold down 1 or 2 buttons to get into this menu. [7]
    • On a GE oven , push the "Bake" and "Broil" buttons for 3 seconds to access the special features (SF) menu.
    • On a Whirlpool oven , press the "Settings" button and keep pushing until the screen shows "Temperature Calibration."
    • To calibrate a Kenmore oven , press and hold the "Bake" button until you see 00 on the display screen.
    • On older Whirlpool and Frigidaire ovens , press and hold the "Bake" button until the display says "Calibration."
  3. Some digital ovens have "+" or "up" buttons while others use the up or down arrow. Once you're in the calibration menu for your model, push the arrow or +/- button by the amount you want to offset. For instance, if your oven is 20 degrees too hot, decrease the temperature by pressing the "-" or down arrow button until it reads "20." [8]
    • For a GE oven, press the "Save" button to lock in the new calibration settings and exit out of the menu.
    • Some models, like a newer Kenmore, might have you use the number pad to enter the amount you want to offset the temperature. Then, press "Save" to exit.
    • To save and exit on an older Whirlpool, press the "Enter" button. Sometimes this button is also labeled the "Save" button.
    4. Advertisement
Method 3
Method 3 of 3:

Calibrating an Analog Oven

PDF download Download Article
  1. On most ovens, you'll see screws on the side and a shaft in the center with directions printed around the dial. This is what you'll adjust so your oven's temperature is more accurate. [9]
  2. Take a pair of needle-nosed pliers and use them to hold onto the shaft on the back of the knob. Turn the shaft a few degrees to the right to raise the temperature or turn it a few degrees to the left to decrease the temperature.
    • It can be hard to see how much you're offsetting the temperature. Stick the knob back onto the oven's panel to see if the temperature dial is now accurate.
  3. Some analog ovens have a small dial on the back of the knob that shows degrees. Take your screwdriver and turn each screw to the left a few times to loosen them. Then, follow the directions on the dial to raise or lower the temperature by turning the knob slightly. [10]
    • The dial might say "Make hotter" on one side and "Make cooler" on the other side so you know which direction to turn the knob.
  4. It should still point at 350 °F (177 °C) since this is the temperature you tested and calibrated your oven to. [11]
    • If you put the knob back on and it's pointing to a totally different temperature, adjust the dial or shaft and try again.
    • If you loosened the screws to adjust the dial, tighten the screws before you return the knob to its place.
    5. Advertisement

Expert Q&A

Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
      Advertisement

      Tips

      • Most ovens will allow you to calibrate the oven up to 30 degrees. If your oven is off by more than this, it's a good idea to call an appliance specialist to inspect your oven.
        Thanks
        Helpful 0 Not Helpful 0
      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Submit
      Thanks for submitting a tip for review!
      Advertisement

      You Might Also Like

      How to
      Use a Ratchet Strap
      How to
      Use a Light Timer
      Homemade Dawn Powerwash: Easy Recipe for Refills
      Moving a Vehicle’s Electric Power Seat Forward or Back Manually
      5 Ways to Reset Any Maytag Washing Machine
      How to
      Make a Smokeless Fire Pit
      How to
      Fix a Leaky Sink Trap
      How to
      Make a Drone
      Safe & Effective Ways to Clean & Unclog Any Sink Drain
      How to
      Paint on Plastic
      How to
      Clean a USB C Charging Port
      How to
      Adjust a Lazy Susan
      How to
      Adjust a Furnace Gas Valve
      How to
      Disassemble and Clean a Honeywell Quietset Tower Fan
      Advertisement

      Expert Interview

      Thanks for reading our article! If you’d like to learn more about baking, check out our in-depth interview with Maria Short .

      References

      1. ↑ https://www.thekitchn.com/diy-oven-maintenance-adjusting-99850
      2. ↑ https://youtu.be/rm5i4btzqzQ?t=67
      3. ↑ https://www.cnet.com/home/smart-home/how-to-test-your-oven-for-temperature-preheating-accuracy/
      4. ↑ https://www.cnet.com/home/smart-home/how-to-test-your-oven-for-temperature-preheating-accuracy/
      5. ↑ https://youtu.be/rm5i4btzqzQ?t=144
      6. ↑ https://youtu.be/U6loSc_VH7o?t=100
      7. ↑ https://youtu.be/4uD8ryVWeYo?t=41
      8. ↑ https://youtu.be/4uD8ryVWeYo?t=64
      9. ↑ https://youtu.be/U6loSc_VH7o?t=92
      1. ↑ https://youtu.be/NoQjnNYqov8?t=39
      2. ↑ https://www.thekitchn.com/diy-oven-maintenance-adjusting-99850

      About This Article

      In other languages
      Thanks to all authors for creating a page that has been read 53,193 times.
      If you buy through links on our site, we may earn a commission .

      Did this article help you?

      Advertisement