How to Change an Oil Filter

PDF download Download Article
PDF download Download Article

A vehicle’s oil filter keeps dirt and particles out of the oil so that it stays cleaner and lubricates your engine better. Be sure to change your oil filter every time you change your oil to keep your engine running smoothly. Once you locate the oil filter on your vehicle’s engine block, all you need is an oil pan, a new filter, and some oil to get the job done.

How to Remove an Oil Filter

You can use your hands or a filter wrench to remove an oil filter. If you can’t loosen the oil filter by hand, use as the filter wrench to loosen it by turning it counterclockwise.

Get Car Support Solve Any Problem

wH
Hi there! Do you have a question about how to diagnose or fix a problem with your car? I’ve read the manual so you don’t have to. Select your make, model, and year, then ask away!
*
*
Part 1
Part 1 of 2:

Draining the Oil and Removing the Old Filter

PDF download Download Article
  1. The oil fill cap is a round cover at the top of the engine that covers the hole where you check your oil or pour oil into. Twist it counterclockwise to loosen it so that the oil can drain out quicker. [1]
    • Make sure your vehicle’s engine is off before performing this procedure. If the engine is hot, wait at least 30 minutes to start the procedure. If the engine is cold, let your car warm it up for 2-3 minutes, then shut it off before beginning.
  2. The drain plug is a square nut typically located beneath the engine block on the lowest possible point of the oil pan that is attached to the underside of the engine block. It is usually either on the bottom or the side of of the oil pan.
    • The drain plug is sometimes located near the crankshaft, which is the shaft connected directly to the underside of the engine block that supplies power to the moving parts of the vehicle. It is housed inside a casing that is attached to the underside of the engine block.
    Advertisement
  3. Remove the oil plug to drain the oil out, then replace the plug. Use a square-end wrench (a socket wrench without the socket) to loosen and remove it. Let the oil drain out into the oil pan until it stops trickling out. This may take 10-30 minutes. Don't forget to replace the oil drain plug! [2]
    • Be ready to move your hand away quickly as soon as you remove the plug so you don’t get covered in oil.
    • If your oil drain plug has a gasket, then replace it with a new one before you put the plug back in. This will ensure a tight fit and seal.
  4. Look on the top, bottom, and sides of the engine to locate the filter attached to an outlet coming from the engine block. The filter is often black, white, blue, or orange and labeled as a filter. [3]
    • The location of the oil filter depends on the model of vehicle. Check your vehicle’s manual if you aren’t sure where the oil filter is located.
  5. This is necessary to catch any oil that drains out when you remove the filter. Make sure the pan is located directly below the oil filter. [4]
    • The amount of oil that will drain out when you remove the filter can range from a few drops to 1 liter (1/4 gallon).

    Tip: You can also put some old newspapers on the ground underneath the oil pan to catch any drops that don’t make it into the pan.

  6. Turn the oil filter counterclockwise until it comes off completely. Be prepared for oil to start leaking out when you take off the filter. [5]
    • It’s a good idea to put on some work gloves before you take off the oil filter to keep your hands oil-free.
    • Make sure you screw off the filter in a position where the leaking oil won’t spill straight down your arm.
    • Since oil filters should only be tightened on by hand, many can be removed completely by hand. However, it’s possible for them to get stuck on if they were tightened too much or there isn’t enough lubrication.
  7. Try to loosen the filter by hand first, then turn the oil filter counterclockwise with a filter wrench to loosen it if it is stuck on. You just need to get it started so you will be able to screw it off all the way by hand. [6]
    • A filter wrench is a ratchet-type wrench designed specifically to fit tightly around oil filters. You can get filter wrenches for your specific model of vehicle online or at an auto parts dealer. Place the wrench around the oil filter, then ratchet it to tighten it and twist it counterclockwise to loosen the filter.
  8. You need to let all of the old oil drain out before you can dispose of the old filter. Throw it away in your regular trash after 24 hours. [7]
    • You will have to recycle the oil at a service station, mechanic shop, or recycling center.
    9. Advertisement
Part 2
Part 2 of 2:

Putting in the New Filter and Adding Oil

PDF download Download Article
  1. Dip your fingers into some new motor oil and rub enough on to cover the whole rubber ring around the base of the new oil filter. This will help it fit tightly and with no leaks to the engine block. [8]
    • Check the engine block before attaching the new filter to make sure that the gasket from the old filter didn’t stick to it when you removed it.
    • Always refer to your vehicle’s owner’s manual for the recommended grade and amount of oil for your vehicle.
  2. Spin the new oil filter on clockwise until you feel it stop turning easily. Only ever screw on a new oil filter by hand. [9]
    • Only apply gentle pressure when you start screwing on the new filter. If you apply too much pressure, you can end up cross-threading the filter and causing damage to the threads that can be expensive to fix.
    • Wearing work gloves will give you some added grip to screw on the new filter.
  3. Give the new filter another partial twist, no more than 3/4 of a twist, to finish tightening it. Only do this part by hand as well. [10]
    • If you notice the oil filter still leaking after you tighten it, then give it 1/4 of a turn more until it is leak-free.
  4. Remove the oil fill cap and place a funnel into the hole. Refer to your owner's manual to figure out what kind of oil to use and how much oil you need to add. Then, pour the recommended amount of oil into the funnel. Twist the oil fill cap back on when you're done. [11]
    • Make sure to use the oil recommended in your owner’s manual. Most standard engines will not receive added benefits from putting in more expensive premium oils, whereas high-performance engines will not react well to lower-grade oils.

    Types of Oil

    Conventional Oil: This type of oil is the cheapest and most common. It is suitable for most vehicles if you follow the standard guidelines and change your oil every 3,000 mi (4,800 km) or so.
    Premium Conventional Oil: This kind of oil is the standard for most new vehicles. It is a step above conventional oil.
    Full-Synthetic Oil: This oil is made for more high-performance engines. It has superior and longer-lasting performance. There is no need to use this oil unless your owner’s manual recommends it.
    Synthetic-Blend Oil: This kind of oil is recommended for vehicles with engines that work harder, such as trucks and SUVs.
    High-Mileage Oil: This is a special kind of oil developed for vehicles that have more than 75,000 mi (121,000 km) on their engines.

    5. Advertisement

Expert Q&A

Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
      Advertisement

      Video

      Tips

      Tips from our Readers

      The advice in this section is based on the lived experiences of wikiHow readers like you. If you have a helpful tip you’d like to share on wikiHow, please submit it in the field below.
      • Note that not all cars use a canister oil filter. Some use a replaceable cartridge that unscrews.
      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Submit
      Thanks for submitting a tip for review!

      Warnings

      Advertisement

      Things You’ll Need

      • Oil drain pan
      • Oil filter
      • Motor oil
      • Work gloves (optional)
      • Filter wrench
      • Socket wrench
      • Mallet


      You Might Also Like

      How to
      Reset a Traction Control Light (TCS)
      How to
      Reset Your Steering Angle Sensor Without an OBD-2
      How to
      Get Out of Limp Mode: 5 Ways to Bypass, Signs, & More
      "Stop Vehicle Leave Engine Running" Mercedes-Benz Warning: Causes & Fixes
      How to
      Fix a Locked Steering Wheel
      How to
      Change an Oxygen Sensor
      What to Do If Your Car’s Anti-Theft System Prevents It from Starting
      Quick and Easy Steps to Reset the Maintenance Required Light
      How to
      Open a Hood with a Broken Latch
      How to
      Fix a Cigarette Lighter in a Car
      How to
      Unlock the Hood of Your Car
      How to
      Reset a Gas Gauge Needle
      How to
      Identify Your Vehicle’s Transmission
      How to
      Determine Gear Ratio
      Advertisement

      Expert Interview

      Thanks for reading our article! If you’d like to learn more about car maintenance, check out our in-depth interview with Matthew Rava .

      References

      1. ↑ https://www.youtube.com/watch?v=O1hF25Cowv8
      2. ↑ https://www.youtube.com/watch?v=O1hF25Cowv8
      3. ↑ https://www.youtube.com/watch?v=O1hF25Cowv8
      4. ↑ https://www.youtube.com/watch?v=O1hF25Cowv8
      5. ↑ http://www.myautorepairadvice.com/how-to-change-oil-filter.html
      6. ↑ https://www.familyhandyman.com/automotive/diy-oil-change/diy-car-maintenance-how-to-change-your-car-oil-yourself/
      7. ↑ http://www.myautorepairadvice.com/how-to-change-oil-filter.html
      8. ↑ http://www.myautorepairadvice.com/how-to-change-oil-filter.html
      9. ↑ http://www.myautorepairadvice.com/how-to-change-oil-filter.html
      1. ↑ http://www.myautorepairadvice.com/how-to-change-oil-filter.html
      2. ↑ https://www.familyhandyman.com/automotive/diy-oil-change/diy-car-maintenance-how-to-change-your-car-oil-yourself/

      About This Article

      Thanks to all authors for creating a page that has been read 158,222 times.

      Did this article help you?

      Advertisement