Download Article
Download Article
There are a variety of ways to curl ribbon, whether it's a curling ribbon for a package or a bit of fabric ribbon for a hair clip. You can curl a curling ribbon with just a pair of scissors. Fabric ribbon, on the other hand, needs to be baked, or have a starch solution applied to it. Either way, it isn't that hard!
Steps
-
Prepare your ribbon. Cut your curling ribbon to the desired length. If you're not sure, cut about 12 inches (about 30 centimeters). If this isn't long enough, you can cut off a longer piece. Remember that when you curl a ribbon it will get shorter, so take that into account. [1] X Research source
- Find the natural curl of the ribbon. Even when the curling ribbon hasn't been curled, it will have a natural curl to it. You will want to follow that natural curl when you're using the scissors to curl it. [2] X Research source
- Note which side is shiny and which is dull. The dull side will need to face downwards, towards the ground, when you're curling the ribbon with scissors. Typically the curl follows the shinier side of the ribbon. [3] X Research source
-
Grasp one end of the ribbon between your forefinger and thumb. You want to pull this as taut as possible. It depends on whether you've already tied it to a package, or whether you're going to do that after you've curled the ribbon. [4] X Research source
- It's easier to tie the ribbon on the package and then curl it because then you only have to grip it on one end. Otherwise, you have to tape down one end to hold it in place.
- If you're right-handed, place the ribbon in your left hand, and vice versa if you're left-handed.
Advertisement -
Hold the scissors upward, with the blades facing up and open. Wrap your fingers around the middle of the blades and handles (in the X that's created when the scissors are opened up). Your thumb should be holding the ribbon against the sharpened edge of the scissors
-
Press the dull underside of the ribbon firmly against the blade of the scissors with your thumb. Make sure that the ribbon is still facing dull side down. -
Pull the ribbon across the scissors blade while continuing to press with your thumb. You need to make sure that you do this quickly. The pressure will cause the ribbon to curl. [5] X Research source
- you must do this part quickly because if you do it too slow the ribbon won't curl. In some cases, it will get flatter.
-
Release the ribbon from the scissors blade. The curling ribbon should spiral up. If it doesn't or isn't as curly as you want it to be, then you can try the procedure again. If it doesn't work a second time, then you'll need to get a new length of ribbon and try again.
Advertisement
-
Gather your materials. Although you need more materials than you would if you used a simple curling ribbon, this procedure doesn't take that long to accomplish. Fabric ribbons that you've taken the time to curl can add something a little extra to a nice package. [6] X Research source
- Find a dowel stick (pencil or rod works, too) which you'll use to curl the ribbon around. A bigger diameter creates a bigger curl, while a smaller diameter creates a smaller curl.
- Get a length of fabric ribbon. The width doesn't particularly matter, it just depends on what you want in terms of width. Make it a few inches (or centimeters) longer than the final desired length because curling will make it smaller.
- Mix cornstarch and water in a spray bottle.
- Grab a couple of clothespins or clips or use tape.
-
Mix one tablespoon of cornstarch powder with one-pint water. You'll slosh the mixture around in the spray bottle until you've made sure that the cornstarch has completely dissolved. [7] X Research source
-
Clip fabric ribbon to one end of your dowel. You'll do this with the clothespin or the clip, or you can tape it. Make sure that the ribbon is secured, because if it comes undone during the drying period, it won't curl very well.
-
Wind ribbon around dowel. When you're doing this you want to make it as tight or as loose as you want your curls to be. Again, depending on the diameter of the dowel stick (or whatever rod you're using) the curls will be bigger or smaller. Don't overlap the ribbon as you're winding it or those parts won't get the starch spray.
- Tape or clip the end of the ribbon in place, so that it is secured on both sides.
-
Spray ribbon with cornstarch solution. Don't drown the ribbon in the solution, but make sure that the entire ribbon is completely coated. Any parts that aren't coated completely won't be stiff enough to maintain their shape.
-
Allow your ribbons to dry. They have to be completely dry before you remove them from the dowel, because otherwise, they may lose their shape. This can take a while so it's a good idea to curl your ribbons with plenty of time to spare before you need to use them.
-
Remove clothespins and slide the ribbon off the dowel. Your ribbon should be stiff and curling. You can somewhat manipulate the shape if you need to attach it to a package, but don't let it get wet, because that will make it lose its curls.
Advertisement
-
Gather supplies. Unlike curling fabric ribbons with a starch solution, you'll need a few more supplies and a little more time, because it can take a little bit of time to bake the ribbons into curls than to simply allow them to dry. This method, however, tends to leave them less stiff than the cornstarch method.
- Get your fabric ribbon. When it curls it is smaller than what you started with so always cut off a bit more than you think you need.
- Grab some wooden dowels or skewers to wind the ribbons around.
- Get clothespins to hold the ribbons in place.
- Use a spray bottle with water to spray everything before baking it.
- Line a cookie sheet with tinfoil on which to bake your ribbons.
-
Wind your ribbons around the skewers and secure them. You want to make sure that the ribbons are tight enough that they won't slip off or lose their shape when you bake them. Avoid overlapping them so that the water gets every part of the ribbon.
- Secure ribbons on both ends of skewers with clothespins.
-
Spray the ribbons with water. You don't have the soak the ribbons, but give them a good spray and make sure that you're getting all parts of the ribbon. This will make it so they don't burn while in the oven.
- Spray the clothespins as well, so they don't burn when they're in the oven either.
-
Bake ribbons for about 10 minutes at 200 degrees Fahrenheit. Place the ribbons on the tinfoil lined cookie sheet. The timing depends on your oven, so if it needs to go a little longer that's okay.
- That would be about 93 degrees Celsius.
-
Remove from oven when the ribbon is completely dry. Keep checking while it's baking so that you don't over or under-bake the ribbon or ribbons. When the ribbons are completely dry, that's when you take it out of the oven.
- Check underneath to make sure that it is completely dry on all sides.
-
Take ribbon off dowel when it is cool. Your ribbon should be well curled It should retain this shape unless it gets wet. You can use it to decorate a hair clip, or add it to a lovely package for that little extra touch!
Advertisement
Community Q&A
Search
-
QuestionHow do I curl lightweight fabric (chiffon) that is 4" wide for 'floaties' for my dance dress?Community AnswerDo it the normal way, with scissors, and sew them on your dress.
-
QuestionIt still didn't work when I curled with the scissors. Where do you think I went wrong?Community AnswerMake sure that you don't press down too hard with the scissors blade; this "kills" inexpensive curling ribbon.
-
QuestionWhat is the easiest way to curl ribbon?Community AnswerHold the top of it. Grab the ribbon with a finger and nail on your other hand. Let the fingernail slide tightly down the ribbon to curl it.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Reader Videos
Tips
- Pressing harder on one edge of the ribbon as you pull it across the scissors will curl it more tightly.Thanks
- It helps to pay close attention when having your gifts wrapped professionally at gift-wrapping counters; watch the method used by the wrappers to curl the ribbon as they're adept at it. You might even ask them to show you how to do it.Thanks
- If the ribbon didn't curl properly the first time, repeat the procedure, making sure to use the scissors blade on the same side to strengthen the curl.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Warnings
- Use care with the scissors when cutting or when pressing your thumb against the blade to curl the ribbon.Thanks
Advertisement
References
- ↑ https://www.realsimple.com/holidays-entertaining/gifts/wrapping/make-curly-bow
- ↑ https://diyprojects.com/how-to-make-a-bow-out-of-curling-ribbon/
- ↑ https://diyprojects.com/how-to-make-a-bow-out-of-curling-ribbon/
- ↑ https://www.realsimple.com/holidays-entertaining/gifts/wrapping/make-curly-bow
- ↑ https://www.scientificamerican.com/article/secret-of-ribbon-curling/
- ↑ https://www.firstpalette.com/quick-how-to/curling-fabric-ribbons.html
- ↑ https://www.firstpalette.com/quick-how-to/curling-fabric-ribbons.html
About This Article
Article Summary
X
If you want to curl ribbon, cut a 12-inch piece of curling ribbon and hold it so the dull side faces downward and the shiny side is facing up. Hold one end of the ribbon tightly between your forefinger and thumb. In the other hand, hold a pair of opened scissors with the blades facing up, and use the thumb on that hand to hold the dull side of the ribbon against one of the scissor blades. Quickly pull your ribbon across the blade while pressing down with your thumb. If the ribbon isn’t curly enough, try to curl it again. If that doesn’t work, cut a new piece of ribbon. To learn how to use starch to curl fabric ribbon, keep reading!
Did this summary help you?
Thanks to all authors for creating a page that has been read 521,787 times.
Advertisement
"It worked! My mom loved it so much! Thanks!"
