Download Article
Download Article
Having a clogged sewer line is a frustrating problem for homeowners. Fortunately, you might be able to fix the smelly situation without hiring an expensive plumbing service or using a snake. Once you take the necessary precautions, you can use a power washer to clear a clog of food particles or items like sanitary products. If you think your backup is caused by grease buildup or tree roots, pour a natural or chemical solution down the sewer line to dissolve it.
Steps
-
Determine the cause or source of the clog if possible. Unless you have a professional plumbing service come and thread a video monitor down your pipe, it's difficult to know for sure what or where your clog is in the line. However, if you dump grease down your drain all the time, or if there are giant trees right near your sewer line, you may be able to form an educated guess. [1] X Research sourceCommon Causes Of a Clogged Main Sewer Line
If you often pour cooking oil into the sink, you likely have a buildup of grease or fat.
If you flush feminine hygiene products or cotton swabs down the toilet, they don't dissolve in water and instead get stuck in the pipes.
If you have large trees growing in your front yard , the roots can eat through the pipe and block the sewer line.
If your house is over 50 years old , you may need a new sewer line, since the pipes can rust and deteriorate over time.
-
Run hot water through your pipes if you have a partial clog. If you can still flush your toilet or if water is still draining down the sink, you may just have partially clogged pipes. Turn your water on as hot as it will go and let it run for 5 to 10 minutes to dissolve or break up the clog. [2] X Research source- You can also replace the water in your toilet tank with hot water, then flush it.
- Do this once a week as a preventative measure if you want to avoid fully clogged pipes.
Advertisement -
Turn off all the water to your home to prevent further buildup. If you keep flushing the toilet or running the water in the sink, the clog will just get worse. Shut off the main water valve so whatever's left in the pipes can drain out and no more water can come into the house. [3] X Research source- A house's main water valve is often located in the basement or on an exterior wall.
- If you aren't sure where it is, look for the water meter, which is often in the front yard under a cement or iron lid. Lift the lid to find the meter and look for the main water valve, which should be close by.
-
Locate the sewer cleanout and open it up. This is the entryway to the main sewer line, and is usually situated just outside the front of your house, in between your home and the city sewer line. Once you find it, unscrew the cap to open it.- Sewer cleanouts might also be in a garage or basement.
- Look for a piece of pipe that's about 4 inches (10 cm) in diameter and that usually has a cap with a square knob or indentation.
Advertisement
-
Put on protective glasses and rubber gloves. These will protect your eyes and skin from any debris or wastewater that might come out of the line. Water that's been contaminated by sewage can carry harmful bacteria and diseases so do your best to avoid exposing your skin to it. [4] X Research source- If any wastewater gets on you, wash and sanitize the area immediately with soap and hot water.
- If you notice any symptoms like vomiting or diarrhea after you had contact with sewer water, contact your doctor or urgent care.
-
Attach the sewer jetter securely to the power washer trigger gun. A sewer jetter attachment looks like a long hose with a nozzle at 1 end. Screw the other end tightly onto the trigger gun or spray wand of your power washer.- You can rent a sewer jetter attachment from most hardware stores if you don't want to buy your own.
- There are longer and shorter hoses available, depending on the length of your line.
-
Lower the nozzle at least 1 foot (0.30 m) down the pipe. Do this before you turn on the power washer or start spraying. Slowly thread the sewer jetter into the sewer cleanout opening far enough so that the water won't splash up on you.- The further you can insert the nozzle down the drain, the better.
-
Spray the water into the drain, continuing to feed the hose down the pipe. When you first turn on the power washer and pull the trigger, you'll feel a slight tug on the hose as it gets pulled downwards. Lower the hose while you spray so that it works its way through the entire sewer line to find the clog.- If the hose hits a pipe tee or an elbow, pull the attachment up slightly, then attempt to thread it through again. Wiggle it around until it continues down the pipe.
- Pulsing your finger on the trigger can also help propel the hose through the line.
-
Listen for the sound of the clog clearing. It should sound like a rush of liquid running through the pipes. When you hear that, you'll know that you've successfully unclogged the line.- Step away from the cleanout opening when you hear the clog burst. There's a good chance some wastewater might splash out.
-
Turn off the power washer and pull the hose out of the pipe. Before removing the sewer jetter from the pipe, make sure the power washer is off and no water is spraying out. Carefully pull up the hose and detach it from the power washer.- To clean the sewer jetter attachment, use the gentle setting on your power washer to spray it off.
- Wipe down the power washer with soap and warm water to sanitize it before putting it away.
- Return the sewer jetter to the store if you rented it. If you bought it, store the attachment somewhere out of reach of kids and pets.
- Don't forget to close up the sewer cleanout opening when you're finished.
Advertisement
-
Mix baking soda and vinegar if a buildup of grease is clogging your line. Since baking soda is slightly caustic, it will eat away at any grease on the pipes. Combine 1 part baking soda and 1 part vinegar, then pour it into the sewer cleanout opening. Wait at least 1 hour before flushing it with hot water. [5] X Research source- The baking soda and vinegar will start reacting and fizzing immediately. Pour it into the pipe as quickly as possible.
- You can use any type of vinegar. However, white vinegar is the most commonly used.
-
Opt for hydrogen peroxide to prevent future clogs from forming. The hydrogen peroxide you keep in your medicine cabinet eats away at clogs and kills off any growth on the inside of pipes, which makes it more difficult for clogs to occur later on. After putting it into the sewer line, wait 2 to 3 hours, then run hot water into the pipes. [6] X Research source- For an extra strong cleaner, combine 1 part hydrogen peroxide with 1 part baking soda before pouring it into the sewer line.
- Wear gloves and protective glasses when you're using hydrogen peroxide. It is very harsh on your skin and should never come in contact with your mouth or eyes.
-
Use a chemical drain cleaner with extreme caution if nothing else works. Pouring chemicals down your line is very risky as it can damage the pipes. Make sure that you follow the directions on the bottle very closely. After pouring in the cleaner, wait 15 minutes before flushing the system with hot water. [7] X Research source- Always wear protective eyewear and gloves when handling harsh chemicals. If any of the substance gets on you, it could irritate or burn your skin.
- Never mix chemical cleaners together or use more than 1 kind on your drain. It could cause a reaction.
How to Choose a Chemical Cleaner
If your clog is caused by grease, use a caustic cleaner, which contains potash or lye and will burn the clog.
If you think that invasive tree roots are the cause of your clog, opt for copper sulfate. This is poisonous to roots and should kill them within 1 week.
For all other clogs, opt for an oxidizing cleaner, which has bleach or nitrates. These cleaners dissolve food and other particles to clear clogs.
Advertisement
Expert Q&A
Search
-
QuestionCan I take care of a clogged sewer line myself?David Balkan is a Professional Plumber, CEO of Balkan Sewer and Water Main Service, and President of Balkan Sewer and Drain Cleaning. As a hands-on owner of these companies for over 40 years, David is knowledgeable about water service lines, sewers, and drain line issues. David is a Committee Chairman of the Master Plumbers Council and has sat on the Executive Committee of the Sub Surface Plumbers Association of New York for over 30 years. His knowledge and solution-oriented approach contributed to Balkan Sewer and Water Main Service being the largest and most trusted service in New York City and the recipient of the 2017 Angie’s List Super Service Award.You can try snaking the line. However, if you don't have a snake, you need a professional. They'll use high-pressure water jets to remove whatever's blocking the sewer line.
-
QuestionHow do you stop sewer backup in a basement?David Balkan is a Professional Plumber, CEO of Balkan Sewer and Water Main Service, and President of Balkan Sewer and Drain Cleaning. As a hands-on owner of these companies for over 40 years, David is knowledgeable about water service lines, sewers, and drain line issues. David is a Committee Chairman of the Master Plumbers Council and has sat on the Executive Committee of the Sub Surface Plumbers Association of New York for over 30 years. His knowledge and solution-oriented approach contributed to Balkan Sewer and Water Main Service being the largest and most trusted service in New York City and the recipient of the 2017 Angie’s List Super Service Award.Unfortunately, it's usually the public sewer that's backed up after a heavy rain, and you have to wait until it starts functioning properly again. However, you can install one-way backwater valves on your sewer so the water can't get into your house—it can only go out.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Things You’ll Need
Using a Power Washer
- Power washer
- Sewer jetter attachment
- Protective eyewear
- Rubber gloves
Tips
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Warnings
- Always wear protective eyewear and gloves when dealing with sewage clogs to prevent coming in contact with wastewater.Thanks
- Be careful when working with harsh chemical cleaners. Avoid getting them on your skin.Thanks
- Never combine 2 different chemical substances or you could cause a dangerous reaction.Thanks
Advertisement
References
- ↑ https://www.stpaul.gov/departments/public-works/sewer-utility/proper-care-your-private-sewer-line
- ↑ https://www.today.com/series/one-small-thing/how-often-should-you-clean-drains-right-way-do-it-t114416
- ↑ https://www.familyhandyman.com/plumbing/valves/how-to-locate-your-gas-shutoff-valve-and-water-shutoff-valve/view-all/
- ↑ https://portal.ct.gov/-/media/Departments-and-Agencies/DPH/dph/environmental_health/environmental_engineering/docs/SewageBackupFactSheetpdf.pdf?la=en
- ↑ https://www.wisebread.com/10-really-easy-ways-to-unclog-drains
- ↑ https://greenerideal.com/guides/1218-ways-to-unclog-a-drain-naturally/
- ↑ https://homequicks.com/clogged-sewer-line
About This Article
Thanks to all authors for creating a page that has been read 223,459 times.
Reader Success Stories
- "This gives me confidence. I watched a professional do it six months ago, but need a quick fix until I can get my plumber in." ..." more
Advertisement
86%
of readers found this article helpful
.
Click a star to add your vote
% of people told us that this article helped them.
"This gives me confidence. I watched a professional do it six months ago, but need a quick fix until I can get my plumber in."
..."
more
