Download Article
Download Article
Artificial Insemination (AI) is the second-most common practice of breeding livestock--well, it's the only alternative to breeding livestock next to natural breeding using a male over females. AI is, however, much more common in dairy production than in beef production, though AI is gaining ground in beef breeding herds due to the increased access and marketing of superior and favourable proven sires. Knowing how to AI cattle is important in order to achieve a high success rate in cattle breeding herds where owning a herd bull is not profitable nor recommended.
The following steps are a reasonably detailed article of what is involved in AI'ing cattle. In order to fully understand how AI is done and to even gain certification for being able to AI livestock, visit a bull semen marketing company like Semex, Genex, Select Sires, or any other bull-semen dispersal company. Check to see if they host any programs for AI certification or becoming a certified AI tech that you can attend to learn more about artificial insemination.This is helpful if you have not yet got a bull to help you breed.
Please also consider using an experienced certified AI tech to AI your cows. These people are better to use than training yourself to do it.
Steps
-
Watch your cows and/or heifers for signs of estrus . Females go into heat once every ~21 days, and the heat periods themselves last for 24 hours. [1] X Research source
- Check out this article: How to Tell if a Cow or Heifer is in Estrus
for physiological, behavioral and physical signs of heat.
- Most heat periods start or end around dusk or dawn.
- Check out this article: How to Tell if a Cow or Heifer is in Estrus
for physiological, behavioral and physical signs of heat.
-
Twelve (12) hours after estrus is when females should be AI'd. This time period is when the female ovulates, sending an ovum out to the fallopian tube to await fertilization from sperm from a bull. [2] X Research source
-
Calmly, with proper handling practices put the heifers or cows in to the working alley to the squeeze chute (or alleyway with just a head gate is good enough), and catch the first female in the head gate. If there are others behind her, make sure they are back behind another gate to prevent them from squishing you when they try to move up further in the race. If you have a squeeze chute with a palpation cage attached to it, use this as a means to do your AI'ing. Some barns are set up so that each cow is in a stanchion or head-catch lined up beside one another. This is very convenient for the AI tech who has to AI over 50 cows in one day!
- If doing AI outside, it is best to do it on sunny warm days, not when the weather is rainy or windy or even stormy. If you have a facility that is set up inside a shed or barn, so much the better!
-
Prepare a water bath that is between 90 to 95 degrees Fahrenheit (or 34 to 35 degrees Celsius) in a thermos. Use a thermometer for better accuracy.
-
Identify which canister contains the semen you need. A semen inventory on the tank that keeps track of the location of each bull prevents any unnecessary searching.
-
Remove the canister from its storage location to the center of the tank. Lift the canister just high enough into the neck region of the tank to grasp the desired cane of semen. Keep the tops of the canister or canes no higher than the frost line, or two to three inches from the top of the tank.
-
Grasp the desired cane then immediately lower the canister to the tank floor. Keep the cane as low inside the tank as possible while removing the straw of semen with tweezers.
- You only have 10 seconds to take the semen straws out!!!
-
Shake the straw to remove excess liquid nitrogen (nitrogen quickly goes into a gaseous state when exposed to air and warmer temperatures)
-
Immediately place it the prepared thermos of water and keep it in there for 40 to 45 seconds. [3] X Trustworthy Source Penn State Extension Educational organization dedicated to delivering science-based information to people, businesses, and communities Go to source
- The warm water should be around 95ºF (35ºC) for optimum thawing of the semen straws.
-
After the straw is put in to the warm water, put the can back in the canister by raising the canister up and over the cane and return the canister to its storage position. [4] X Research source
- Anytime it takes over 10 seconds to locate a cane the canister must be lowered back into the tank to cool completely. Never return a unit of semen to the tank once you've removed it from the cane.
-
Get your AI gun ready by having it pre-assembled (this should be done before/after you prep the thermos with warm water. If it's cold outside, warm the "business end" of the gun up in your coveralls close to your body so it warms up completely. Rubbing a paper towel on the rod also helps warm it up. If it's hot outside, keep it in a cool place. The AI gun should not be extremely hot nor cold to the touch.
-
Remove the straw from the thermos and wipe it dry with a paper towel. It should be completely dry before you do anything else with it. Flick your wrist slightly, while holding the crimped end, to adjust the air bubble in the straw. The flick should move the bubble to the end you are holding
-
Put the straw in the rod. Clip 1/2" (or 1 cm) from the crimped end of the straw. Use sharp scissors or specially designed straw-cutter scissors should be used, and cut in the area that the air bubble is located.
-
Wrap the AI gun in a clean dry paper towel or protective sheath and tuck it in your clothing close to your body to both transport it to the cow and to maintain a constant temperature.
-
Move the tail so it's on top of your left forearm or tie it up so it will not interfere with the AI process. Raise the tail with one hand (preferably the right) and with the other (which should be gloved and lubricated), gently reach inside the cow to clean out any feces that may interfere with the process of feeling for and inserting the AI gun into the cow's vagina.
-
Clean the vulva with a clean paper towel or rag to remove excess manure and debris.
-
Take the gun out of your jacket or overalls, unwrap it, then insert it at a 30 degree angle into the cow's vulva. This is so that you avoid going into the urethral opening into the bladder.
-
With your left hand in the rectum of the cow (which should have been there to begin with), feel with your finger tips through the wall of the rectum and vagina the location of the end of the AI gun until you reach the cervix. [5] X Research source
-
Grasp the cervix with the hand in the rectum of the cow (like you would hold a bar that is below your hand) and hold it steady while you thread the rod into and through the cow's cervix.
-
When the rod is all the way through the cervix, check the location with your index finger. The rod should be only 1/2 to 1/4 of an inch into the uterus. [6] X Research source
-
Slowly depress the plunger at the end where your right hand is so that 1/2 or is deposited.
-
Recheck the location of the semen to make sure you are in the cow's uterus and not in any of her "blind spots" (see tips below), and deposit the other half of the straw's contents.
-
Slowly remove the AI gun, your hand and arm from inside the cow. Check for any blood, infection or semen "feedback" from inside the sheath.
-
Recheck the straw to see if you used the right bull semen for the cow.
-
Dispose the straw, glove, and towels in the proper place.
-
Clean the AI gun if necessary.
-
Record breeding information on any record keeping system you have on hand.
-
Release the cow (if necessary, depending on the breeding set-up you have) and restrain the next one to be inseminated.
-
Recheck the temperature of the water in the thermos before repeating the steps above for another cow.
-
Repeat the steps above for the next cow.
Community Q&A
Search
-
QuestionWhat is artificial insemination in cattle, in simple terms?Community AnswerArtificial insemination, as noted by the article above, is impregnating cattle with bull semen minus the bull. Semen collected from the bull is frozen then unfrozen and put into the cow as described above. It eliminates the risk of having a dangerous bull around, the extra feed and space needed to keep a bull, as well as the costs of fence repair if the bull should escape because he smells some other cows in heat a mile away that need his attention.
-
QuestionAt what temperature can the semen be preserved and what chemical should be used to preserve it before insemination?Community AnswerBefore the insemination the semen can be preserved in liquid nitrogen at -196ºC.
-
QuestionWhy do I need to put the straw containing semen into the warm water?KarinTop AnswererTo thaw out the semen. When the semen comes out of the tank, it's frozen, and needs to be warmed to above room temperature so it's not so cold when it goes into the uterus of the cow, and so it "wakes up" the sperm in the semen sample so they can start moving and wiggling to the ovum as soon as they're put in the uterus. Thawed semen is also much easier to inject into the uterus than frozen.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Tips
- Always keep inseminating equipment clean, warm and dry.Thanks
- Inseminating equipment should avoid contact with lubricants at all time, because most lubes are spermicides.Thanks
- Liquid nitrogen is the best solution to use to keep semen cold and keep them for a long time.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Warnings
- Low conception rates are common in cows done by inexperienced technicians.Thanks
- Beware of those blind spots mentioned above in TipsThanks
- Never artificially inseminate cows yourself unless you are very experienced and have the necessary training.Thanks
- AI is actually a lot harder than it sounds. A lot of errors can be made in the location of the pipette (or rod or AI gun) in the cow's uterine tract, because often the location of the pipette is easily moved, and it is impossible to check pipette placement.Thanks
Things You'll Need
- AI tank with canisters and canes inside
- Liquid nitrogen
- Straws with desired semen
- AI gun
- Paper towels
- Straw-cutter scissors
- Thermos (preferably wide-mouthed one)
- OB lubricant
- Shoulder-length gloves
- Tweezers
- Thick gloves
References
- ↑ https://embryology.med.unsw.edu.au/embryology/index.php/Bovine_Development#Bovine_Estrous_Cycle
- ↑ http://www.selectsires.com/resources/fertilitydocs/heat_detection_timing.pdf?version=20180803
- ↑ https://extension.psu.edu/storing-and-handling-frozen-semen
- ↑ http://www.thecattlesite.com/articles/721/artificial-insemination-for-beef-cattle/
- ↑ https://www.fwi.co.uk/livestock/livestock-breeding/8-step-guide-artificially-inseminating-dairy-cow
- ↑ https://www.fwi.co.uk/livestock/livestock-breeding/8-step-guide-artificially-inseminating-dairy-cow
- http://agritech.tnau.ac.in/animal_husbandry/animhus_cattle_AI.html
About This Article
Thanks to all authors for creating a page that has been read 435,486 times.
Reader Success Stories
- "I'm considering learning this technique, and wanted to know what is involved. After reading this article, I believe I can do it successfully. Knowing what not to do is just as important as knowing what to do." ..." more
91%
of readers found this article helpful
.
Click a star to add your vote
% of people told us that this article helped them.
"I'm considering learning this technique, and wanted to know what is involved. After reading this article, I believe I can do it successfully. Knowing what not to do is just as important as knowing what to do."
..."
more
"We have this Agricultural Science Project in Year 12 and AI is my topic. I have extracted the much needed information, not forgetting the colorful pictures, and I am so grateful!"
..."
more
"This article has tremendously refreshed my memories on AI procedures. Thanks very much, and thumbs up to the team."
"Sure helped to find out what to look for in my cow to see if she pregnancy coming on or not. Thank you."
"The article helped with how to pass the gun and where to deposit semen. I had no knowledge about this."
