Download Article
Download Article
Garter belts were invented in the 1920s as a way to hold stockings high in a time when elastic didn't exist. Nowadays, they're primarily used as a fashion accessory, adding a bit of pizzazz to your undergarments. Putting one on isn't particularly difficult, though they can be a bit finicky if you wear them throughout the day. To make them easier to wear, you should start by picking the right garter belt for your purposes.
Steps
-
Put the garter on. Some garters may just slip on. However, most will have a hook and clasp system or Velcro. Wrap it around your waist. Usually the closure goes in the back. Adjust it so it stays up but is comfortable. [1] X Research source
- Wrap the belt around your waist. It should sit about at your waistline.
- Attach it at the back by sliding the hooks into the clasps [2] X Research source . Choose the line of clasps that is the most comfortable for you. This step is basically like attaching a bra.
- If you have trouble attaching it in the back, hook it together in the front, and then move it around to the back.
-
Put on your stockings. Pull up your thigh highs to the right height. Start adjusting the straps to meet the top of your hose.
- You'll want your straps to be at slightly different lengths. The ones in the back should be the longest, giving you room to bend over.
- The straps on the sides should be an inch shorter, and the ones on the front should be two inches shorter than the back, all of which will help you bend easier. It also helps when you sit down.
Advertisement -
Attach the garter clasps to your thigh highs. Each clasp consists of a rubber nub and a metal piece that fits over it. To attach it, put the rubber nub underneath the top edge of the stocking. [3] X Research source The clasp should reach straight down to the stocking, unless it's sewn on at an angle. It should fall about an inch past the top of the stocking. Slide the metal clasp over the nub. Pull up so the nub slides into place. Repeat with the remaining clasps around the belt. [4] X Research source
- When you fasten a clasp, push the rubber nub from behind so that you can see it sticking out through the front. [5] X Research source However, don't push so hard that you tear a hole in your stockings.
- The top of each clasp has a wide end and a narrow end at the bottom. Start with the wide end, sliding it over the nub, then pull up so the narrow end is surrounding the nub, holding it in place.
- Be careful if you have plastic clasps. If you apply too much pressure to a plastic clasp, it will snap in two, and your garter won't be usable.
-
Readjust as needed. You'll likely need to readjust once you've gotten your stockings settled to make sure they're at the right height. In addition, you'll probably need to readjust throughout the day. An easy way to do this is to check on them when you're in the bathroom.
- Make sure you sit down and stand up with the garter belt on so you can see how it fits. You don't want it to have too much tension when you sit down because it might pop off.
- However, when you stand up, your thigh highs should be mostly taut, as you don't want them pooling at your ankles.
- Loosen and tighten the straps as needed.
-
Put on your underwear last. This step may seem counter-intuitive. A belt should go on the outside of your undergarments, right? Well, not if you want to use the bathroom more easily. If you put your panties on before the belt, you'll have to undo the straps, take off your garter belt, and pull down your underwear to use the restroom. Putting your underwear over the belt and straps prevents that problem.
- Therefore, if you're only going to wear the garter belt for a little while, it's fine to put your underwear on first.
- However, if you plan to wear it all day, you might want put your underwear on last, though under your skirt or pants, of course.
- You can also go without underwear if you prefer.
Advertisement
-
Find the right size. You may find that a garter belt you're looking at is a "one-size-fits-all" model. That may fit some people, but it of course won't fit everyone. A better bet is finding one that is actually in your size, as many brands make them in standard sizes. It's best if you can try it on first, though some stores may not let you do that.
- You want a garter belt that stays in place. If it slips, your thigh highs will slip also.
- However, you don't want one so tight you can't breathe. Make sure it's loose enough to be comfortable.
- Finally, look for one that is adjustable. Most of them will have several rows of hooks, much like a bra, so that you can make adjustments as needed. [6] X Research source
-
Pick one with metal clasps. Plastic clasps don't grasp as well as metal. In addition, the plastic ones tend to break. Therefore, try to pick a garter belt that has metal clasps for the best possible grip. [7] X Research source
-
Find the best straps. Generally, for the best hold, pick a belt that has 6 clasps. Some have only 4, and those may pop off if you plan on wearing it for more than an hour or so. Another important component to look for is elastic straps. While most straps are adjustable, elastic will allow the straps to keep hold of your thigh highs when you move around or bend over, as it means the straps have give and won't pop off at the clasp.
- You can even find garter belts with many more straps, up to 8 or 10, which will hold even better.
- Also, thick straps are better because they're less likely twist and they provide a better hold.
-
Decide how much coverage you want. Some garter belts just cover a small area, forming a small belt across your waist. Others are much wider. What you choose is up to you. You should base it on how comfortable it is and the look you are going for, as garter belts are often used as lingerie. A wider belt will be more comfortable if you plan to wear it all day. [8] X Research source
-
Pick a practical fabric. While that fur belt might look pretty, it's not going to be comfortable or breathe well. That's fine if you're only planning on wearing the belt for a little while. However, if you plan to wear it all day, pick something like satin or cotton that will breathe better and provide more comfort.
-
Decide how much you want to spend. Cheap garter belts may seem like a great option, but they probably won't hold up. If you're planning to wear it often, you might want to spend a little more money to get a better quality belt.
Advertisement
Community Q&A
Search
-
QuestionHow many straps is best?Community AnswerSix straps or more will give you a better hold for all day use, but if you're only wearing it in the bedroom or for a little while, four straps are fine.
-
QuestionIs there an easy way to fasten the suspenders to the stocking?Community AnswerPut your stockings on, then attach your garter belt to the stockings first then pull up the belt and stockings like a pair of pantyhose.
-
QuestionIs a garter belt size the same as my underwear size?Josh1997Community AnswerUsually, yes, but I would try it on in the shop just to make sure, as you definitely don't want it to be too tight.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Tips
- Be gentle with your stockings as you can put a run or hole in them with your nails if you're not careful.Thanks
- To avoid runs or kinks in the material when putting them away, unclip your suspenders from the stocking tops and prop your leg up on a chair or bed, bend your knee slightly and slowly, and carefully roll your stocking down your leg to your ankle. When you reach it, raise your foot and continue until it is off. You should end up with them in circular-shaped rolls. You can put them away in a draw like this or gentle unravel them and fold them. Repeat this for the other stocking.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
References
- ↑ https://www.youtube.com/watch?v=sL7o-47y4lM
- ↑ https://www.tiktok.com/@boudoirbyalyssa/video/7355170754193018158
- ↑ https://www.tiktok.com/@boudoirbyalyssa/video/7355170754193018158
- ↑ https://www.youtube.com/watch?v=sL7o-47y4lM
- ↑ https://www.tiktok.com/@boudoirbyalyssa/video/7355170754193018158
- ↑ https://www.youtube.com/watch?v=sL7o-47y4lM
- ↑ https://www.youtube.com/watch?v=sL7o-47y4lM
- ↑ https://www.youtube.com/watch?v=sL7o-47y4lM
About This Article
Article Summary
X
To attach thigh highs to your garter belt, you’ll need to put your garter and pantyhose on, then hook the straps together. Most garters will use a Velcro or clasp system, like a bra. If you’re struggling to fasten it at the back, do it at the front, then rotate it. Once you’ve put your garter on, pull on your thigh highs to a comfortable height. Then, adjust the straps to the right lengths. You’ll need the back ones to be longest, the front a couple of inches shorter, and the sides an inch shorter. To connect the straps, hook the rubber nubs underneath the top edge of your stockings. Slide the metal clasp over the nub and pull it up so the nub slides into place. Finally, put your underwear on over the top of your garter belt. For more tips, including how to choose the right garter belt for you, read on!
Did this summary help you?
Thanks to all authors for creating a page that has been read 635,142 times.
Reader Success Stories
- "I am a straight cross dresser and even though my wife helps me with everything, I am starting to learn femme dressing myself, also makeup, etc. This has been a wonderful article for me. Thank you." ..." more
Advertisement
"I am a straight cross dresser and even though my wife helps me with everything, I am starting to learn femme dressing myself, also makeup, etc. This has been a wonderful article for me. Thank you."
..."
more
"Excellent and very informative. I'm a crossdresser and find these tips invaluable."
