PDF download Download Article PDF download Download Article

Air conditioner units consist of condenser (which itself contains the compressor, cooling tubes, and a fan), an evaporator (the large internal unit which cools the air), tubes to drain moisture from the dehumidified air, and a fan to blow the cool air out into the house or apartment. [1] To clean the unit, you’ll need to vacuum the compressor unit, and replace the inside air filter. The air conditioner unit should be cleaned annually in order to continue operating correctly.

Part 1
Part 1 of 3:

Cleaning the Condenser

PDF download Download Article
  1. There should be an outdoor shutoff near the condenser unit. This will resemble a square box on the wall of the apartment or house. Inside, look for a switch that you can slide to the “OFF” position. If there is no switch, you’ll need to manually pull the plug which feeds power to the condenser. [2]
    • Before you begin disassembling any portion of the condenser, it’s crucial that you disable the power supply.
    • If you cannot find the power outlet where the compressor unit is plugged in, or if you’re inclined to be extra cautious, you can simply flip the switch to “OFF” in the circuit breaker box which controls power to the AC condenser.
  2. The fine, narrow slats of metal which line the sides of the compressor unit are called “fins.” You can clean the fins by running the nozzle of a vacuum cleaner over them; this will remove the debris and allow the condenser to pull in air without obstruction. A wet/dry vacuum is the tool best suited for this job. [3]
    • The condenser unit sucks in air through these fins. Over the course of time, these will become dirty with bits of leaves, grass, and dust.
    • If you don’t have a wet/dry vacuum, see if any of your friends or neighbors have one. You may also be able to rent a wet/dry vacuum from your local hardware store.
    Advertisement
  3. Often with normal wear, some fins on the condenser can become bent. If you notice that any of the fins are crooked or have been twisted, you can use a knife or kitchen utensil to gently straighten the fins. Apply gentle, steady pressure to bend the fins back into position. [4]
    • If you use excessive force, you risk snapping off the fins or damaging them further.
  4. The fan unit sits on top of the compressor, and is typically covered by metal wiring or a grate. Using a screwdriver, remove the wiring on top of the fan, and then unscrew and remove the fan itself. [5]
    • Due to the wires connecting the fan motor to the compressor unit, you may not be able to fully lift off the fan. You’ll simply have to lift the fan as far out of its housing as possible.
  5. Using your garden hose, rinse any debris (bits of leaves, grass, dust, or pollen) from the blades of the fan. To make sure that the fan blades are clean, you can also wipe them off with a clean cloth or rag. Then, use the hose again to spray water through the compressor’s fins from the inside of the unit. [6]
    • Rinsing the fins from the inside will make sure that any obstructions are cleared, and the unit can effectively draw in air.
  6. Once you’ve finished cleaning the fan blades and the interior of the compressor, you’re ready to put everything back together. Set the fan back in place, and re-insert the screws holding it to the metal frame. Do the same thing with the metal wiring over the top of the fan. [7]
    • At this point, you can also turn the power supply back on.
  7. Advertisement
Part 2
Part 2 of 3:

Cleaning the Inside Unit

PDF download Download Article
  1. To change the filter, remove the metal grate which covers the filter. Then pull out the air filter, and set in a replacement unit. [8] The air filter is located indoors, and will typically be close to the evaporator unit. It’s about two feet (0.6 meters) wide and 1 foot (0.3 meters) high. [9]
    • Over time, the air filter will become clogged and dirty with all of the dust and dirt particles that it has filtered out of the air. A dirty filter will obstruct airflow within the AC system, and will cause the system to function with much less efficiency.
  2. If your AC unit’s air filter can be washed and reused, you can simply clean it and place it back in the unit rather than disposing it and purchasing a new one. [10] To clean your reusable filter, follow the manufacturer’s instructions. Most reusable filters are cleaned by running them under lukewarm tap water, and a gentle application of dish soap.
    • To quickly tell a disposable from a reusable air filter, inspect the material it’s made from. Disposable filters will be made of thick, papery material, while reusable filters are made of a rubbery frame and metal mesh.
  3. As the evaporator unit cools and de-humidifies air from outside, it produces runoff liquid. In most air conditioner units, this air runs down from the top of the evaporator in a thin, plastic pipe, and runs through a drain in the floor. To make sure that the drain hasn’t gotten clogged, you can run a stiff wire through the drain. [11]
    • If the plastic pipe is flexible, poke the wire into the bottom of the pipe as well, to make sure that it’s not clogged.
    • In some more modern units, the pipe which drains water runs directly into the floor, and does not have a drain. In this case, you do not need to clean the setup.
    • Call a AC professional cleaner—or your landlord—if you notice water pooling around the base of the evaporator unit, or see water-damaged flooring nearby.
  4. Advertisement
Part 3
Part 3 of 3:

Maintaining the Air Conditioner System

PDF download Download Article
  1. Although condenser units are often viewed as an eyesore, they need to be surrounded by open space in order to function properly. If you have weeds, vines, or bushes encroaching on your condenser unit, use a pair of garden shears and trim the plants back. Make sure that you have a space of about two feet on all sides of the condenser unit. [12]
    • This space will maximize the unit’s efficiency by allowing plenty of free-flowing air.
  2. Rinse the condenser by spraying it with water from a garden hose. Work the spray from the hose over all sides of the condenser unit. Rinse from top to bottom, so that runoff from the top portion of the condenser does not stain the bottom portion. [13]
    • Over the course of time, the outdoor condenser unit can become covered in a layer of dirt and pollen kicked up by the wind. This coating of dust can reduce the efficiency of the condenser unit by blocking the unit from pulling in air.
  3. While maintaining the function of the air conditioner unit should keep it functioning efficiently, it’s still smart to have it inspected by a professional. Plan to schedule your inspection in spring, before you start using the AC unit heavily in the summer. AC professionals will be able to inspect all parts of the air conditioning unit—including the evaporator coils and the air compressor—and can prevent or repair any problems early on. [14]
    • If you live in an apartment or a rental house, the landlord or property owner will likely have annual inspections performed. If you notice that your AC unit is not working properly or seems to be broken, contact your rental agency.
  4. Advertisement

Expert Q&A

Search
Add New Question
  • Question
    How do you clean a central air conditioner filter?
    Victor Belavus
    Air Conditioning Specialist
    Victor Belavus is an Air Conditioning Specialist and the Owner of 212 HVAC, an air condition repair and installation company based in Brooklyn, New York. In addition to HVAC and air conditioning units, Victor also specializes in furnace repair and air duct cleaning. He has over 10 years of experience working with HVAC systems.
    Air Conditioning Specialist
    Expert Answer
    If you have a washable filter, vacuum it first to remove all big particles. Then, mix 30 grams of citric acid with 1 liter of water and submerge the filter in the solution for 15 minutes. To finish cleaning the filter, rinse it in water.
Ask a Question
      Advertisement

      Tips

      • When trimming foliage around your condenser unit, also take the time to rake leaves away from its base.
      Submit a Tip
      All tip submissions are carefully reviewed before being published
      Name
      Please provide your name and last initial
      Thanks for submitting a tip for review!
      Advertisement

      About This Article

      Article Summary X

      To clean a central air conditioner, you’ll need to vacuum the compressor unit and replace the inside air filter. Before you begin cleaning, shut off power to the unit. Clean the narrow slats of metal that line the sides of the compressor by running the nozzle of a vacuum over them. Once you’ve cleaned the slats, use a screwdriver to remove the wiring on top of the fan, then remove the fan itself. Use a garden hose to wash the fan blades and the interior slats. When you’re done cleaning the fan and the interior compressor, put everything back together. Twice a year, you’ll also want to change the replaceable air filters by removing the metal grate that covers them, pulling the old filter out, and putting the new one in. To learn how to clean the drain, keep reading!

      Did this summary help you?
      Thanks to all authors for creating a page that has been read 103,925 times.

      Reader Success Stories

      • Anonymous

        Apr 5, 2023

        "Not cooling yet but I have maintained our old central units for 30+ years and the only thing I would change is for ..." more
      Share your story

      Did this article help you?

      Advertisement