How to Make Fondant Shiny

Download Article

5 Recipe Ratings | Success Stories

Co-authored by Jessica Banh and Megaera Lorenz, PhD

Last Updated: April 15, 2024

Download Article

ARTICLE

VIDEO

On its own, fondant generally has a matte appearance. There are several techniques you can use to make fondant decorations and fondant-covered cakes shiny, though. The degree of gloss varies depending on the technique, so the best one to use may depend on the project itself.

How can you make fondant shine?

Dip a thin paintbrush into a bowl of pasteurized egg whites and apply it to the fondant. Let it dry for a few hours, and then apply any extra coats if your fondant needs it. Steam, corn syrup glaze, alcohol, shortening, and gum arabic can also help make fondant shiny.

Method 1

Method 1 of 6:

Steaming

Download Article

1
Load the steamer with water. Fill the basin of a handheld steamer with distilled water. Turn on the steamer and allow the water to heat up. ^{[1]
X
Expert Source

Jessica Banh
Pastry Chef

Expert Interview. 6 April 2022.}
- You can use a clothing steamer for this technique as long as no detergents or other chemicals were ever poured into the basin.
- Every steamer works differently, so it's best to consult the manufacturer's instructions prior to use. Typically, however, you should use a plain hose attachment and low heat for the best results.
2
Pass the steam over the fondant. Hold the steamer approximately 4 inches (10 cm) away from the fondant. Press the steam trigger to release the steam onto the piece. ^{[2]
X
Expert Source

Jessica Banh
Pastry Chef

Expert Interview. 6 April 2022.}
- Turn the fondant piece or move the steamer around as needed to evenly apply steam to all sides.
- Only allow the steam to hit the fondant for 3 to 5 seconds per spot. Using too much steam can cause the fondant to melt and may also cause water droplets to form on the surface.
- In addition to giving the fondant a soft glossy finish, steam can also remove traced of corn starch and powdered sugar previously left behind on the surface of the fondant.
Advertisement
3
Re-steam as needed. Within an hour, you'll likely notice the gloss fading as the water dries. Apply additional steam in the same manner to return the gloss.
- Steamed gloss will fade every time you apply it, so it's generally best to use this method only if you plan on presenting the fondant immediately.
- Note that any sugar or starch residue obscured by the steam will not return, however.

Method 2

Method 2 of 6:

Corn Syrup Glaze

Download Article

1
Avoid using fats on the fondant. Fats can cause this glaze to separate. As a result, the surface will look "bubbled" and uneven instead of smooth and shiny.
- Do not knead the fondant in shortening, oil, or other fats prior to applying this glaze. Do not use this method in conjunction with the shortening glaze technique, either.
- Additionally, you should avoid using silicone or vinyl sheets for rolling your fondant when you intend to use this glaze. Oils and fats can collect on these sheets from previous works, and the residue can be enough to cause separation of this glaze.
2
Combine corn syrup and alcohol. Pour one part light corn syrup and one part clear drinking alcohol into a shallow cup. Stir well to combine.
- The alcohol should be 150 proof or higher. Vodka works well, but clear grain alcohols are also effective.
- The exact amount will vary depending on the amount of fondant you need to glaze, but using 1 tsp (5 ml) of each component will usually work well for small decorations.
3
Brush the mixture over the fondant. Use a small, soft paintbrush to evenly apply the glaze of the surface of the fondant.
- The glaze should create an instant and permanent high gloss over the fondant.
- It's best to apply the glaze in thin layers. Thicker coats will create a shinier appearance, but they will also take longer to dry.
4
Let it dry. Let the glaze dry completely before you handle the fondant further. This can take anywhere from 1 to 12 hours, depending on how thick the glaze is.
- Avoid brushing over the glazed area or touching it with your fingers once the glaze starts setting. You can easily leave marks in the glaze during this stage, and those marks will be permanent.
- You can apply additional coats once the glaze is completely dry, but re-application should not be necessary to maintain the initial sheen.

Method 3

Method 3 of 6:

Alcohol

Download Article

1
Fill a spray bottle with vodka. ^{[3]
X
Research source} Fill a small, clean spray bottle with approximately 2 inches (5 cm) of vodka.
- If you don't have vodka, clear grain alcohols may also work. Avoid using tinted alcohols, though, since the color will bleed onto the fondant.
- Use a clean spray bottle that has never held hair products or other chemicals to avoid accidental contamination. Salon-quality spray bottles are better than cheap bottles since cheap bottles may spray unevenly. Note than an airbrush could also work.
2
Mist the fondant. Hold the nozzle about 4 inches (10 cm) away from the surface of the fondant. Lightly and evenly spray the alcohol over the fondant.
- Only spray a light mist of alcohol onto the fondant. Using too much can cause puddles to form and may dry out the fondant to a damaging degree.
3
Let it dry. Wait several hours for the alcohol to completely dry. After it dries, the fondant should have a soft glossy finish.
- The gloss should be semi-permanent. It may fade after several days, but you should avoid re-applying the alcohol since too much can quickly dry out the fondant.

Method 4

Method 4 of 6:

Shortening

Download Article

1
Apply shortening to the fondant. Use your fingers to carefully rub a thin, smooth, and even layer of vegetable shortening over the surface of the fondant. ^{[4]
X
Expert Source

Jessica Banh
Pastry Chef

Expert Interview. 6 April 2022.}
- If you want to keep your fingers clean, you could try using vegetable cooking spray instead of solid shortening. Hold the nozzle approximately 4 inches (10 cm) away from the fondant and lightly mist it over the surface at even intervals.
2
Buff the fondant. After applying the fondant, use a dry paper towel to lightly buff the shortening into the fondant, working in small, circular strokes.
- Any irregularities, fingerprints, or stroke marks should fade as you buff the fondant. Press lightly, however, to avoid leaving any indentations.
- After you buff the piece, you should be left with a smooth, satin gloss.
3
Re-apply as needed. The gloss should remain intact for a day or so, but you may notice some fading once the fondant begins to absorb the oil. You can apply another coating at this point in the same manner used for the first.
- Shortening does not dry completely, however, so some gloss will likely remain even after absorption occurs.
- Since fondant remains wet and sticky, it's easy to accidentally leave fingerprints and other marks while moving the cake. You can remove these marks before presenting the piece by lightly buffing them out with a dry paper towel.

Method 5

Method 5 of 6:

Gum Arabic

Download Article

1
Combine gum arabic and water. Add one part gum arabic and two parts distilled water to a small bowl. Stir vigorously to combine.
- The exact amount will vary depending on the amount of fondant you need to cover, but you should always maintain these proportions. For most small pieces, 1 Tbsp (15 ml) gum arabic and 2 Tbsp (30 ml) water should suffice.
2
Let it sit. Allow the mixture to sit at room temperature for 15 minutes. Afterward, vigorously stir it again to combine the components.
- Resting and re-stirring the mixture in this manner should help the two ingredients combine more evenly, making the glaze more effective after application.
3
Brush the mixture onto the fondant. Using a small, soft paintbrush, immediately paint an even layer of glaze over the fondant.
- Work carefully to avoid getting stroke marks, fingerprints, or other marks in the glaze.
- Immediately after applying the glaze, the fondant should have a very high gloss. This will not be the way the final finish looks, however.
4
Let it dry. Wait for the glaze to dry a full 24 hours before handling the fondant further. Once dry, the fondant should be slightly hard and semi-glossy.
- This glaze should be permanent, so re-application is not necessary.

Method 6

Method 6 of 6:

Egg Whites

Download Article

1
Apply pasteurized egg white to the fondant. Pour 2 to 4 Tbsp (30 to 60 ml) of pasteurized egg whites into a small, clean dish. Using a small, soft paintbrush, lightly and evenly brush these egg whites onto the surface of the fondant.
- For safety reasons, you should use pre-separated, pasteurized egg whites from a carton.
- When working with small pieces, you can dip the fondant directly into the egg whites instead of brushing the egg whites over the piece. Tap off any excess before leaving the piece to dry.
- When you need to brush the fondant onto the piece, use a small brush and leave behind as few stroke marks as possible. Tap off any excess egg whites that pool in the crevices of the piece immediately after application.
2
Let it dry. Let the egg whites dry for several hours. Once dry, the fondant should have a natural, medium-level shine.
- The egg whites must dry completely before you handle the piece. If you touch it while the whites are still drying, you may leave behind fingerprints that you won't be able to remove later.
- Note that the egg whites should dry to a semi-hard, permanent finish. Re-application should not be necessary.
3
Add further coats as needed. If the fondant is not as shiny as you would prefer, you can apply additional coats following the same procedure.
- Allow each coat to finish drying before applying the next coat. Doing so minimizes the risk of imprinting the egg whites with fingerprints or brush marks.

Community Q&A

Search

Add New Question

Question

Can I do the same thing with modeling chocolate?

wikiHow Staff Editor
Staff Answer
This answer was written by one of our trained team of researchers who validated it for accuracy and comprehensiveness.

wikiHow Staff Editor

Staff Answer

You may be able to use the alcohol and corn syrup technique with modeling chocolate. You can also create shiny modeling chocolate by tempering it with a small amount of paraffin or canning wax, or bring out the shine by gently heating the chocolate with a hair dryer on low speed and medium heat. The heat will bring the oils in the chocolate to the surface to create a shine. Just take care not to melt it by leaving the heat in one place for too long!

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 3 Helpful 0
Question

Everyone claims they have used the vodka/corn syrup for a shine and it dries. Well mine did and then the next day it was sticky again. And going over with vodka again did nothing. Can I fix this?

wikiHow Staff Editor
Staff Answer
This answer was written by one of our trained team of researchers who validated it for accuracy and comprehensiveness.

wikiHow Staff Editor

Staff Answer

Humidity and temperature can affect how well these finishes work. Make sure to store your cake in a cool, dry area so that the glaze can dry completely.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 4 Helpful 0
Question

Can glossing techniques be used on dried fondant?

Community Answer

Except for steam and spraying vodka, all of the methods should only be used on dried fondant.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 3 Helpful 14

See more answers

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Video

Read Video Transcript

Tips

Submit a Tip

All tip submissions are carefully reviewed before being published

Name

Please provide your name and last initial

Submit

Thanks for submitting a tip for review!