Download Article
Download Article
Fixing a water pump refers to the process of replacing an essential part of your vehicle's cooling system. It is one of the least complicated procedures to carry out, as far as auto repairs go, so almost anyone who can operate a wrench can do this on their own. Follow these steps for how to fix a water pump.
Steps
-
Confirm that the water pump is nonoperational by examining the functionality of the bearings by manually jostling the fan blade. [1] X Research source
- This applies to fan operated cooling systems. The fan bearing should remain firmly seated if it is not in need of repair.
-
Jiggle the pulley that operates the pump in the case of a motorized fan.
- The shaft should remain tight if it is working properly.
Advertisement -
Inspect the pump casing for splotches, caused by an inordinate amount of fluid leakage, which would indicate a faulty seal.
- A few drops of water should sweat from the vent hole over a long period of time, but a ruined seal will cause excessive overflow.
-
Detach the negative battery line once the faulty water pump has been verified. [2] X Research source
-
Remove the radiator cap and empty the radiator by disengaging the valve under the front passenger's side.
-
Remove the fan belt, if one is present.
-
Detach the radiator hoses.
-
Unbolt the fan shroud, found on the water pump's shaft.
-
Remove the fan shroud. [3] X Research source
-
Remove the bolts from the fan and dislodge it.
-
Disengage the bolts from the drive pulley and remove it.
-
Dislodge the bolts from the dysfunctional water pump and remove it.
-
Scrape any dirt and debris away from the area surrounding the gaskets. [4] X Research source
-
Apply industrial cleaning solution to the area and clean it thoroughly.
-
Follow the water pump manufacturer's instructions regarding sealant for the gaskets.
-
Apply gasket sealant, if directed. [5] X Research source
-
Install the replacement gaskets. [6] X Research source
-
Position the replacement water pump and secure the bolts. [7] X Research source
-
Reinstall the drive pulley.
-
Position the fan and the shroud and reinstall the bolts.
-
Reattach the radiator hoses.
-
Reinstall the fan belt, referring to the manufacturer's belt routing diagram. [8] X Research source
-
Confirm that the radiator valve is closed and refill the radiator.
-
Seal the radiator cap.
-
Reconnect the negative battery cable.
-
Start the car and verify that there are no irregular noises or leaks.
Advertisement
Community Q&A
Search
-
QuestionHow do I know if my engine block got cracked?Community AnswerOpen the radiator cap and stick your finger in it when the engine is cold. If there is oil on your finger, this is one sign of a cracked block. Your engine will lose compression and overheat, this is another sign. Your vehicle might also lose or burn a lot of oil.
-
QuestionHow do I find the water pump on my car?Community AnswerOpen the hood, follow the belt, and it should be underneath the main fan right behind the radiator.
-
QuestionHow important is a temperature sensor?Community AnswerVery important, because without it the cooling fan cannot start at the right time, and also the car's main computer needs to know it for the right fuel air mixture.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Video
Tips
- Maintaining the proper ratio of water to coolant, specified in your owner's manual, is the easiest way to prevent damage to the cooling system.Thanks
- Label the bolts to make reinstallation easier.Thanks
- It is imperative to inspect the water pump as soon as you suspect a problem, as a faulty cooling system can be disastrous for your engine.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Warnings
- Do not attempt this repair unless the engine is completely cool.Thanks
Advertisement
References
- ↑ https://knowhow.napaonline.com/6-signs-you-may-have-a-bad-water-pump-on-your-hands/
- ↑ https://www.youtube.com/watch?v=xzG2tvp68mQ
- ↑ https://www.2carpros.com/articles/water-pump-replacement
- ↑ https://www.howacarworks.com/cooling-systems/replacing-a-water-pump
- ↑ https://www.youtube.com/watch?v=W9lM0Av0yeU
- ↑ https://www.youtube.com/watch?v=W9lM0Av0yeU
- ↑ https://www.howacarworks.com/cooling-systems/replacing-a-water-pump
- ↑ https://www.youtube.com/watch?v=O4aqIiWR9JU&vl=en
- https://www.popularmechanics.com/cars/how-to/maintenance/1272366
About This Article
Thanks to all authors for creating a page that has been read 111,118 times.
Advertisement