Download Article
Download Article
Malting is the process of partially germinating and then drying grain to preserve its enzymes. To malt your own corn, you'll need to first steep and germinate the kernels, and then dry, kiln, and clean them. By using the right tools and sticking to a schedule, you can turn corn into malt to use for things like baking and brewing.
Steps
-
Use a drill to drill holes in the bottom of a five gallon (20 liter) bucket. Make sure each hole is smaller than the size of a corn kernel. [1] X Research source
-
Place the bucket in an urn of the same size. Remove the lid of the urn so you can set the bucket inside. It’s OK if part of the bucket is sticking up out of the top of the urn. [2] X Research sourceAdvertisement
-
Fill the bucket with about four pounds (1.8 kilograms) of corn. The corn kernels shouldn’t reach the top of the bucket as they will expand during the steeping process. [3] X Research source
-
Pour water into the bucket until the water is one inch higher than the corn. You want the extra inch of water because a lot of the water will be absorbed into the corn during the steeping process. [4] X Research source
-
Set the urn thermostat to 77 degrees Fahrenheit (25 degrees Celsius). You want the water to remain this temperature during the entire steeping process. [5] X Research source
-
Let the corn steep in the water for nine hours. Check back after nine hours and lift the bucket of corn out of the urn. Let the water in the bucket drain into the urn through the drilled holes. [6] X Research source
-
Let the bucket of corn rest on an elevated surface for three hours. The rest period, called an "air rest," will help get rid of CO2 and encourage the corn to take up more water during the steeping process. When it's finished resting, place it back in the urn so it fills up with water. [7] X Research source
-
Alternate between steeping and resting the corn. Your steeping schedule should look like:
- First steeping: nine hours.
- First air rest: three hours.
- Second steeping: nine hours.
- Second air rest: three hours.
- Third steeping: nine hours.
- Third air rest: three hours.
- Fourth steeping: nine hours.
Advertisement
-
Remove the bucket of corn from the urn. Let the water drain back into the urn so only the corn is left in the bucket.
-
Pour the corn into an eight gallon (30 liter) tray. You can make the tray yourself out of wood or buy an aluminum tray at the store. Make sure the sides of the tray are tall enough to keep in all of the corn. [8] X Research source
-
Place a thermometer in the tray to monitor the temperature. You want the temperature to be between 72 and 82 degrees Fahrenheit (22 and 28 degrees Celsius) while the corn is germinating. [9] X Research source
- If the thermometer reads too high of a temperature, move the tray to a darker, cooler place.
- If the thermometer reads too low of a temperature, place a portable heater or small heat fan that allows you to adjust the temperature near the tray. Check the thermometer regularly to make sure the tray isn't overheating. [10] X Research source
-
Rinse and stir the corn every 12 hours while it's germinating. This will keep the grain moist and prevent heat buildup that naturally occurs during germination. [11] X Research source
-
Let the corn germinate until the shoots are twice as long as the kernels. The shoots are the long, root-looking parts of the corn that emerge during germination.
- You can start the drying process once 70 to 80 percent of the corn has shoots that are twice the length of the kernels. [12] X Research source
Advertisement
-
Dry the corn in a food dehydrator to stop the germination process. Set the food dehydrator to between 100 and 125 degrees Fahrenheit (38 to 52 degrees Celsius) and leave the corn inside to dry. [13] X Research source
-
Weigh the corn after several hours to check the moisture content. You want the corn to be at 10 percent moisture before you increase the temperature in the food dehydrator. You'll know the corn is at ten percent moisture when it weighs .5 ounces (14.2 grams) less per pound (.45 kilograms) than it did before you started the malting process. [14] X Research source
-
Increase the temperature when the corn is at ten percent moisture. Raise it to between 140 and 160 degrees Fahrenheit (60 to 71 degrees Celsius). The corn will be finished drying when it's between three and six percent moisture content, or when it's lost three ounces (85 grams) per pound (.45 kilograms) of its original weight. The entire drying and process can take between six to eight hours. [15] X Research source
-
Transfer the corn to a baking sheet and put it in the oven for four hours. Set the oven between 176 and 185 degrees Fahrenheit (80 to 85 degrees Celsius). After four hours, the corn will be finished kilning and malting. [16] X Research source
Advertisement
-
Pour the dried malt into a pillowcase. Tie the pillowcase shut so none of the malt can escape. [17] X Research source
-
Put the pillowcase in the dryer for ten minutes. Run the dryer on the coolest setting so you don’t heat up the malt. Tumbling the malt will help remove the bitter-tasting roots and shoots of the corn. [18] X Research source
-
Separate the malt from the broken off roots and shoots. You can do this by hand, or you can use a sieve to separate them more easily. The malt will look like small, dried-up corn kernels. [19] X Research source
-
Store your malt in a plastic container with an airtight lid. This will prevent oxygen and moisture from damaging the malt over time. Properly stored malt is good for up to a year. [20] X Research source
Advertisement
Community Q&A
Search
-
QuestionIs it fine to dry the corn/sprout with sunlight?Community AnswerYes, as long as you rotate the corn to help dry evenly, and the sunlight produces at least 150 degrees Fahrenheit.
-
QuestionDo I save the corn, sprouts, or both?Community AnswerUnless you want your wort or mash to be bitter, save only the corn to use for your brew.
-
QuestionIs there any way I can do it faster to use it immediately?Community AnswerNo, the malting process rate is limited/controlled by the biological process of sprouting the grain.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Video
Tips
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Things You'll Need
- Five-gallon plastic bucket
- Urn
- Drill
- Food dehydrator
- Tray
- Scale
- Pillowcase
- Sieve
- Thermometer
References
- ↑ http://www.glutenfreehomebrewing.org/advanced_malting_tutorial.php
- ↑ http://www.glutenfreehomebrewing.org/advanced_malting_tutorial.php
- ↑ https://byo.com/stout/item/1108-malting-your-own-techniques
- ↑ https://www.youtube.com/watch?v=g8fBsFxcoCs&feature=youtu.be&t=257
- ↑ http://www.glutenfreehomebrewing.org/advanced_malting_tutorial.php
- ↑ http://www.glutenfreehomebrewing.org/advanced_malting_tutorial.php
- ↑ http://www.glutenfreehomebrewing.org/advanced_malting_tutorial.php
- ↑ http://www.glutenfreehomebrewing.org/advanced_malting_tutorial.php
- ↑ http://www.glutenfreehomebrewing.org/advanced_malting_tutorial.php
- ↑ http://www.glutenfreehomebrewing.org/advanced_malting_tutorial.php
- ↑ http://www.glutenfreehomebrewing.org/advanced_malting_tutorial.php
- ↑ https://www.youtube.com/watch?v=g8fBsFxcoCs&feature=youtu.be&t=355
- ↑ https://byo.com/stout/item/1108-malting-your-own-techniques
- ↑ https://byo.com/stout/item/1108-malting-your-own-techniques
- ↑ https://byo.com/stout/item/1108-malting-your-own-techniques
- ↑ https://byo.com/stout/item/1108-malting-your-own-techniques
- ↑ http://www.glutenfreehomebrewing.org/advanced_malting_tutorial.php
- ↑ http://www.glutenfreehomebrewing.org/advanced_malting_tutorial.php
- ↑ http://www.glutenfreehomebrewing.org/advanced_malting_tutorial.php
- ↑ https://byo.com/hops/item/1362-shelf-life-storing-your-ingredients
About This Article
Article Summary
X
To malt corn, start by placing a bucket with holes in the bottom in an urn, then fill the bucket with the corn. Next, add water until it's an inch above the corn, set the thermostat to 77 degrees F, and allow to sit for 9 hours. Then, remove the bucket from the urn and allow the corn to air dry for 3 hours before repeating the soaking and drying process another 3 times. Pour the corn into a tray and allow it to germinate until the shoots are twice as long as the kernels. Finish by drying the corn in a dehydrator and baking it in the oven at 175 degrees F for 4 hours. For advice on how to clean the malt, keep reading!
Did this summary help you?
Thanks to all authors for creating a page that has been read 144,950 times.
Reader Success Stories
- "All information shared here was perfect for me, especially the picture explanations. Kudos!"
Advertisement
96%
of voters found this recipe helpful
.
Click a star to add your vote
% of people told us that this article helped them.
"All information shared here was perfect for me, especially the picture explanations. Kudos!"
"Very detailed description with splendid simple illustrations. Excellent!"
"Thank you! This worked really well. "
