Download Article
Download Article
Sometimes, when firewood is cut, it is too large in diameter to season well or fit the firebox or wood stove it is intended for. Splitting the wood can make even large diameter logs usable, as well as allowing them to season more quickly. Someone with scrawny arms and the right technique can split hardwood more quickly and more efficiently than a bulky linebacker swinging uncontrollably. Learn to set yourself up for success, splitting hardwood with a maul or wedges, and finishing the job properly.
Steps
-
Use a maul or splitting wedges to split hardwood. A splitting maul is essentially a thicker, more wedge-shaped axe made for splitting hardwood along the grain, with a blunt sledge-hammer edge on the back of the splitting blade. These are typically somewhat heavier than an axe, usually by several pounds, and the weight of the maul makes the job easier. [1] X Research source
- Splitting wedges are basically metal wedges that you drive into the wood with a sledge. The benefit of the wedge is that you can place it along the grain to split the wood, then drive it into the exact same place until it splits.
- Axes are used to chop wood , not to split it. It's best to use a maul or splitting wedges if you want to split hardwood.
-
Cut your wood to length. Normal wood stoves and smaller fireplaces usually take a 16 to 20-inch (40 to 50 cm) log, and the shorter the log is, the more easily it will split. You should cut your wood to the most efficient length for your purpose, in terms of both handling and storing it, as well as making it a suitable length for your application.
- Try to cut the ends of each piece of firewood square and flat, as you will need to stand them on end to split them, and crooked cuts will make this difficult to do.
Advertisement -
Set up a chopping block. Usually a large section of the tree's trunk, this will be the surface you place individual logs on to split them, making it easier to swing your axe, and causing less strain on your back. A wood surface about 6 inches off the ground is appropriate for any splitting job. [2] X Research source
- The block should be neither too high nor too short, to avoid dangerous ricochets if you should strike a glancing blow.
- Always split on some kind of block, never the ground and never concrete. The ground will do in a pinch, but you'll tire more easily if you have to lift the heavy maul that much higher. Save your strength and split on a block, especially if you've got a lot of wood to split.
-
Set up in a safe location. Allow for good footing and make sure there is no debris or overhanging limbs around where you will be working.
- Splitting hardwood is especially efficient on cold days, if the wood has been properly aged before splitting. Pieces of hardwood will pop right apart with the proper technique during cold weather, making your job much easier.
-
Always wear the appropriate protective gear. For a day of splitting hardwood, outfit yourself properly. You should wear good-quality gloves to save your hands from splinters that will make the work much more uncomfortable, safety glasses, and solid work boots, preferably with a steel-toe. Never split wood by yourself, make sure someone else is at least around who'll be able to aid if you should have an accident. [3] X Research source
Advertisement
-
Place your first log on the chopping block. Make sure it is stable, and near the center of the block, if possible.
- Swinging a heavy maul at an unsteady block is extremely dangerous. A glancing blow could strike your leg, or send the wood flying off like a dangerous projectile. Set yourself up for success by placing the wood securely. [4] X Research source
-
Examine the wood before splitting it. Look for hairline cracks in the log. You should aim so that the blade of you the maul runs in the same direction as the crack. [5] X Research source
- Different woods split in different ways, so plan accordingly. Oak splits somewhat easily through the center, even large-diameter portions. Maple, on the other hand, is split more easily toward the edges of the end-grain.
- Look for large knots or places where a limb was removed when the wood was cut and avoid them. These places will likely have very crooked, gnarly grain, which should be avoided if possible. You could spend all day hacking away at knots.
-
Aim. Choose the location you want to split the log, stand with your maul resting on that location, and set your feet square. You might tap a little indentation into the wood so you'll have a good visual cue at which to guide the maul, if the grain isn't obvious from where you're placed.
-
Bring the maul up and down. You don't really "swing" a maul, and you don't need to put the end behind your head at any point to split wood properly. Hold the maul firmly with your non-writing hand at the end of the handle, and cradle the maul with your dominant hand, just below the head of the maul. Flex your knees slightly, then lift the maul head straight up above your head, extending your arms straight. [6] X Research source
- Slide your strong hand down until both of your hands are close, gripping the end of the handle, then bring your hands down and flick your wrists, letting gravity do much of the work for you.
- Splitting has much less to do with strength and more to do with using the correct technique. Swinging the maul wildly is both dangerous and exhausting.
-
Pull the axe bit out of the log if the wood fails to split on the first swing. You may have to pull and twist it hard to remove it, if the bit is sunk deeply and stuck in the wood. Rock the axe bit up and down to work it out of the wood.
- Alternatively, you can treat the planted maul like a splitting wedge and hit the blunt metal end of the maul with a sledge. This is a popular and common technique for splitting logs. If you've placed the maul accurately, or it's quite stuck, don't waste energy pulling it out.
-
Repeat your swing into the wood until the wood splits. Try to strike in exactly the same place as the first time, or along the length of any crack which appeared when you hit it.
-
Split and stack. Split each block of wood into progressively smaller pieces, until they are the desired size. Normally, you will split the block in half, then each half will be split again, until the pieces are about 6 to 8 inches (15 to 20 cm) at the largest cross section.
- Stack split wood so that air can circulate around it to allow it to season thoroughly before it is burned in a wood stove or fireplace. Cover it to prevent rain from repeatedly wetting it, which will cause it to rot, but do so in a manner which still allows good air circulation.
Advertisement
-
Have several wedges on hand. Wedges work best for knotty pieces of wood or especially hard or large-diameter pieces of wood. Because it's possible to drive a wedge deep into a thick log without necessarily splitting it, it's good to have back-up wedges available to save your initial wedge and complete the job, if it should get in over its "head". [7] X Research source
- If you're commonly splitting with wedges, a good combination would be a sharp starter wedge that you can use to really bite into the wood and get it started, and another blunter but wider wedge that you can use to continue splitting once you've gotten it started.
-
Tap the wedge into the grain with a sledge. A short-handled sledge should work just fine for the job, depending on the size of the log and what's available. Holding the wedge like you would a very-large nail, tap it in until it can stand on its own.
-
Hammer with the sledge. Using solid and straight blows, hammer the wedge into the log along the grain until it splits. If you hammer it all the way in and the log still hasn't split, start your other wedge along the same crack, but closer to the edge of the wood so the force will make the split longer, freeing both wedges and splitting the log.
- Be sure to stand clear of the line of the cracking, so the wedge won't pop out at your feet, dangerously. As you hammer, stand perpendicular to the splitting of the log and the wedge itself.
-
Finish the job. There might be some remaining connected wood fiber that you can finish with an axe, and you can likely use a maul or an axe to split the sections into smaller, more manageable pieces. Don't use wedges to split smaller sections of wood, as the likelihood of them popping through and flailing loose is more probable.
Advertisement
Community Q&A
Search
-
QuestionWhat's the ideal weight for the hammer while using the wedges?Community AnswerA nice 5-pound maul should do the trick, especially if you plan to split a lot. You don't want to be continuously lifting a ten pound maul.
-
QuestionWhat is a maw for cutting wood?Community AnswerA "maw" is a much heavier splitting tool. (Normally they're 7.5 lbs. vs. an ax which is 3 to 4 lbs.) It's angle of attack is much more flat than that of an ax. It requires less of a swing to chop smaller pieces; it's normally used for splitting wider logs.
-
QuestionDo wood splitting contests exist?Community AnswerYes they do exist.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Tips
- Stop before you get too tired. It's always the one-last-piece you chop that you get hurt on. [8] X Research sourceThanks
- If you are splitting wood for cooking stove use, take the time to split plenty of kindling, smaller sticks. Much easier to start a fire, and the cook will appreciate it!Thanks
- It's sometimes easier to split very large pieces by striking the very front edge of the log's cut face as opposed to striking the center of the cut face. This gives your swing a better chance of splitting down the edge, which frequently results in the entire log splitting.Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Warnings
- Be aware of your stance so that if your axe or maul misses the target the completed swing will not strike a foot or leg. If you are lowering your body as you lower the axe, if it misses, its force will just be directed downward, hitting the chopping block and not your shin.Thanks
- Check for and do not allow bystanders behind you or in front of you for quite some distance: Should the axe head come off or the shaft slip out of your hands the results can be deadly.Thanks
- DO NOT do this alone. Have a companion or cell phone nearby to call for helpThanks
Advertisement
Things You'll Need
- A good heavy axe or maul
- A chainsaw or other means of cutting your logs.
References
- ↑ https://www.artofmanliness.com/articles/how-to-split-firewood/
- ↑ https://www.thisoldhouse.com/fireplaces/21017294/how-to-split-logs-for-firewood
- ↑ http://www.artofmanliness.com/2009/11/24/how-to-split-firewood/
- ↑ http://www.motherearthnews.com/diy/splitting-wood-zmaz80ndzraw.aspx#axzz2vxF4Prsk
- ↑ https://www.iamcountryside.com/self-reliance/the-best-way-to-split-wood-efficiently/
- ↑ https://www.bobvila.com/articles/how-to-split-wood/
- ↑ https://www.bobvila.com/articles/how-to-split-wood/
- ↑ https://www.bobvila.com/articles/how-to-split-wood/
About This Article
Article Summary
X
While splitting hardwood firewood may appear daunting, it can actually be quick and easy with a maul. Cut the ends of your pieces of wood square so you’re able to stand them on end to split them. To put less strain on your back, set up a chopping block that’s approximately 6 inches off the ground, like a tree’s trunk or another wood surface. Put your log on the block and look for any hairline cracks that you can take advantage of. Once you know where you want to aim, bring your maul up, extend your arms straight, and let gravity take it down into the wood. If it doesn’t split on the first swing, rock the maul to work it out of the wood. Repeat your swing until the wood splits. To learn how to use splitting wedges, keep reading!
Did this summary help you?
Thanks to all authors for creating a page that has been read 475,403 times.
Reader Success Stories
- "I needed to know how to initiate getting the wedge into the wood. Now I know I can use even my smaller sledge to tap it in. I also needed to know techniques when my maul gets stuck in the wood, and this article helped a lot." ..." more
Advertisement
90%
of readers found this article helpful
.
Click a star to add your vote
% of people told us that this article helped them.
"I needed to know how to initiate getting the wedge into the wood. Now I know I can use even my smaller sledge to tap it in. I also needed to know techniques when my maul gets stuck in the wood, and this article helped a lot."
..."
more
"This was a great writer's resource. I've always bought my wood split, but I wanted to write about the first time my character had to split a cord of wood. This was the perfect amount of detail (and great illustrations)."
..."
more
"Excellent step-by-step instruction. Much better than any other sites I have checked out on splitting firewood."
"I was about to hire a log splitter before I read this article. Very clear and informative. Thanks!"
"Learned the technique of swinging a maul, which is very different from swinging an axe."
