Download Article
Conserve water, time, and money with this speedy shower technique
Download Article
Do you want to take a shower that wastes less water and takes very little time? A normal shower can waste up to 37 gallons (140 L) of water (or more!), where a navy shower can use as little as 3 gallons (11.4 L) over the course of only 2–3 minutes. Developed on naval ships to preserve the supply of freshwater on ships, the technique is simple: just get wet, turn the water off to lather up, turn it back on to rinse, and you’re done! Read on to see how navy showers can save you time, money on your water bill, and have a positive impact on the environment.
Steps
Section 1 of 4:
Download Article
-
Turn on the water and fully wet your body, face, and hair. Step into the shower and quickly get yourself fully wet. Use your hands or a washcloth to fully douse your body before turning off the water.
- Let the water warm up for a few seconds first if you like. It’s a myth that navy or military personnel have to take cold showers, although some choose to for muscle recovery or alertness after a workout or training. [1] X Research source
- If you plan on scrubbing with a loofah or washcloth, get that fully wet too.
- If you’re trying navy showers for the environment, collect cool water in a bucket while the shower heats up to water plants or even shave with.
-
Turn off the water and lather up with shampoo and soap. Perform this while your shower is off by using a loofah, washcloth, or your hands. Some showerheads even have a switch that lets you turn the water on and off without adjusting the temperature knob or handle. [2] X Research source
- Scrub yourself firmly since you won’t have the benefit of running water and its additional cleansing power.
- Wash quickly, especially if you have an inefficient water heater. Waiting too long can let the water cool down.
Advertisement -
Turn the water back on to rinse out your shampoo and soap. Now that you've finished washing yourself thoroughly, rinse yourself off with a short blast from the shower.
- Once you’re rinsed off, you’re done with your navy shower!
-
Repeat to use conditioner or other extra products if needed. If you need to apply extra products after your rinse, turn the water off again and lather up. When you're finished applying your conditioner, turn the water back on and quickly rinse off again to finish showering.
Advertisement
Section 4 of 4:
Finding Your Shower Water Usage
Download Article
-
Measure the flow rate of your shower in gallons per minute (gpm). Place a 1-gallon bucket under your showerhead and gauge the length of time it takes for the bucket to fill. This will give you your approximate gallons per minute. For example, if it takes 20 seconds for the bucket to fill, your flow rate is about 3 gallons per minute. [7] X Research source
- The goal of a navy shower is to reduce the amount of water you use to about 3 gallons (11.4 liters). To reach this goal, you must first understand your average water consumption.
- A standard modern showerhead uses 2.5 gpm, so if you don’t have a bucket on hand, use this value to get an estimate. [8] X Trustworthy Source United States Environmental Protection Agency Independent U.S. government agency responsible for promoting safe environmental practices Go to source
-
Multiply your gpm by the number of minutes you take to shower. Say you typically take 10 minutes to shower and your gpm is 3. Since 10x3=30, your average shower uses about 30 gallons of water.
- The typical flow rate of a shower is approximately four gallons per minute. If you have difficulty measuring your flow rate for some reason, use this number to predict the total gallons used.
-
Install a WaterSense showerhead or flow restrictor to lower your gpm. Showerheads with the “WaterSense” label are legally required to use no more than 2 gpm while still providing a quality shower and are easy to install . [9] X Trustworthy Source United States Environmental Protection Agency Independent U.S. government agency responsible for promoting safe environmental practices Go to source Or, install a flow restrictor with your current showerhead to lower its gpm manually.
Advertisement
Expert Q&A
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement
Tips
- Navy showers are also known as a military shower, combat shower, sea shower, staggered shower, G.I. bath, or a water-saving shower.Thanks
- The opposite of a navy shower (a long and indulgent shower with hot water running the whole time) is called a “Hollywood shower.”Thanks
Submit a Tip
All tip submissions are carefully reviewed before being published
Name
Please provide your name and last initial
Thanks for submitting a tip for review!
Advertisement
Video
References
- ↑ https://www.military.com/military-fitness/should-you-take-ice-baths-part-of-training-and-recovery
- ↑ https://droughtresources.unl.edu/water-conservation-shower
- ↑ https://niagaracorp.com/news/learn-from-the-us-navy/
- ↑ https://www.epa.gov/watersense/showerheads
- ↑ https://droughtresources.unl.edu/water-conservation-shower
- ↑ https://droughtresources.unl.edu/water-conservation-shower
- ↑ https://www.e-tankless.com/measuring-flow-rate.php
- ↑ https://www.epa.gov/watersense/showerheads
- ↑ https://www.epa.gov/watersense/showerheads
About This Article
Article Summary
X
Taking a navy shower is a great way to save you time and water. First, step into your shower when it gets warm and wet your hair and body. Then, shut it off. Shampoo your hair and wash your body, and try to do it quickly so the water doesn’t go cold again. Turn the water back on and rinse your hair and body. If you need to condition your hair, shut the water off again, condition your hair, turn the water back on, then rinse it out. To save even more water, use a bucket to collect the cold water as your shower first warms up. Then, use the water to shave or water your plants. For more tips, including how to reduce the flow of your shower to save water, read on!
Did this summary help you?
Thanks to all authors for creating a page that has been read 150,870 times.
Reader Success Stories
- "In this article, I learned how to save water. Before, I used to take showers that lasted at least 20 to 30 minutes."
Advertisement
84%
of readers found this article helpful
.
Click a star to add your vote
% of people told us that this article helped them.
"In this article, I learned how to save water. Before, I used to take showers that lasted at least 20 to 30 minutes."
