How to Clean Mold Off Concrete

Co-authored by Mike Kapur

Last Updated: August 23, 2024 References

Choose from several cleaning agents to remove mold from concrete. Spot test a small area with your chosen cleaning agent to make sure no damage occurs. You’ll need to wear protective gear and scrub the moldy areas vigorously. Rinse exterior concrete afterwards with a power washer. Interior concrete can be wiped dry. Merely killing mold won’t prevent it from returning, so make sure to address the water source that is causing the mold.

Part 1

Part 1 of 2:

Removing the Mold

Download Article

1
Choose a cleaning agent to treat the mold, like white vinegar or bleach. You can use a mold-killing detergent, diluted bleach, vinegar, or a commercial cleaner made specifically for killing mold. ^{[1]
X
Research source} Don’t mix anything other than water with bleach, as certain cleaning agents can produce highly toxic fumes when mixed with bleach. ^{[2]
X
Research source}
- For a diluted bleach solution, mix three parts water with one part bleach in a bucket.
- You can also use white vinegar or hydrogen peroxide to kill mold. ^{[3]
  X
  Expert Source
  
  Mike Kapur
  Certified Mold Assessor & Home Inspector, Sonic Home Inspections
  
  Expert Interview. 19 August 2020.}
- Don’t forget to test a small, discreet area first. Bleach and other chemicals can discolor concrete that’s been colored or stained. ^{[4]
  X
  Research source}
- Reader Poll: We asked 310 wikiHow readers which chemical solution they prefer to use to clean mold, and only 10% of them said 3% hydrogen peroxide. [Take Poll] While peroxide can be effective at removing mold, other cleaners may work better.
Any organic material adjacent to the moldy area can be infected. Throw away any disposables like cardboard boxes. Set aside other removable items like furniture or area rugs.

Advertisement
3
Apply the solution. Use a heavy duty sponge or scrub brush to apply your chosen cleaning solution to all visible moldy areas on the concrete. Scrub the areas vigorously. If you’re using mold-killing detergent, apply it directly to the spots and scrub it with a bristle brush. ^{[5]
X
Research source}
- Don’t use a wire brush, which can scratch concrete. ^{[6]
  X
  Research source}
- Wear old clothes, rubber gloves, safety goggles and a respirator or dust mask.
If the spots aren’t lifting, leave the solution to sit for several minutes. Then scrub the areas with the solution until the mold is gone.
5
Rinse outdoor concrete. Use a hot water pressure washer for the fastest and most effective rinse. Wear safety goggles, sturdy footwear and long pants. Use a pressure rating of at least 3000 psi with a flow rate of at least four gpm (gallons per minute). ^{[7]
X
Research source} This should lift any organic matter that has seeped into the pores of the concrete. ^{[8]
X
Research source} If you don’t want to use a pressure washer, try a regular water hose.
- You can rent a pressure washer at a home or building supply store. You may need a van, pickup truck or SUV to transport it, and a friend to help load and unload it. ^{[9]
  X
  Research source}
- Ask the rental agent how to use the washer and to give you any safety precautions. Find out if the washer comes with nozzles. Don’t use settings finer than fifteen degrees. Never use a zero degree nozzle on a pressure washer.
Once it’s dry, inspect carefully for any mold that may not have been cleaned. If there is still visible mold, rinse the area clean and try one of the stronger methods you haven’t used yet: diluted bleach or commercial cleaner.
Leather, wood or inorganic furniture can be deep cleaned. Upholstered furniture with visible mold will need to be disposed of or reupholstered by a professional. Carpet that shows significant mold growth or is soaked completely through will need to be removed.

Part 2

Part 2 of 2:

Eliminating the Source of Moisture

Download Article

1
Check the land for sloping and debris. Dirt should be slightly sloped away from the house so that water will travel away from the perimeter rather than pool up against the outer walls. Don’t allow wet leaves or other debris to pile up against the exterior walls of your home. ^{[10]
X
Research source}
- Pooling water can seep into the home and cause mold to grow inside the house.
- If your driveway is showing signs of mold, consider removing trees or shrubbery that are blocking sunlight on your driveway. Mold thrives in damp and shady areas. ^{[11]
  X
  Research source}
Sump pumps should discharge water at least twenty feet from your home. Your gutters should expel water at least six feet away from the exterior walls. If your gutters are releasing water too close to the home, install gutter extenders. ^{[12]
X
Research source}
Make sure none of your outside hose spots are dripping. Examine the perimeter of the building for any potential water dripping or seepage.
If there are any leaks – for example in your piping or roof – repair them. Insulate your roof, exterior walls , windows and pipes to cut down on moisture that forms condensation.
If your mold problem is indoors, increase the ventilation to prevent warm and stagnant air where mold can thrive. Make sure large appliances are vented, such as your washer and dryer. Make sure kitchens and bathrooms are well ventilated. Run air conditioners and dehumidifiers as needed.
6
Waterproof the concrete. Seal the concrete with water-proofing chemicals. Seal any cracks in the concrete walkway around your home with concrete, caulking or tar. ^{[13]
X
Research source} If you plan to paint concrete walls, use a waterproof sealant first, then apply stain-blocking primer and paint .
- For outdoors, try a high quality acrylic sealer made for exterior use. If your weather tends to be warm and humid, look for a low-solids solvent-based sealer. Choose dry, sunny weather and allow the sealer to dry for at least two to three days. ^{[14]
  X
  Research source}

Expert Q&A

Search

Add New Question

Question

What household products will kill bleach?

Mike Kapur
Mold Removal Specialist
Mike Kapur is a home inspector and the owner of Sonic Home Inspections, a home inspection company in Westchester, New York. With over 15 years of experience in pre-inspecting properties, Mike specializes in mold, radon, asbestos, lead, water, and air quality testing as well as hazardous materials, pest, infrared, and general home inspections. Prior to founding Sonic Home Inspections, Mike worked pre-inspecting apartments. Mike holds a BS in Accounting from Queens College and is a Certified Mold Assessor in the state of New York.

Mike Kapur

Mold Removal Specialist

Expert Answer

You can use vinegar, you can use diluted bleach, you can use ammonia—there are a lot of household cleaners that will work on mold. These work for most surfaces, but they wouldn't work for mold on wood.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 0 Helpful 3

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Tips

Cleaning the mold off of your concrete is important, but you also need to find what's causing the mold in the first place so it doesn't come back. ^{[15]
X
Expert Source

Mike Kapur
Certified Mold Assessor & Home Inspector, Sonic Home Inspections

Expert Interview. 19 August 2020.}

Thanks
Helpful 0 Not Helpful 1
Most mold comes from a source of water or moisture. ^{[16]
X
Expert Source

Mike Kapur
Certified Mold Assessor & Home Inspector, Sonic Home Inspections

Expert Interview. 19 August 2020.}

Thanks
Helpful 0 Not Helpful 0

Submit a Tip

All tip submissions are carefully reviewed before being published

Name

Please provide your name and last initial

Submit

Thanks for submitting a tip for review!

Warnings

If you have large amounts of mold, more than ten square feet, it is best to have it professionally removed.

Thanks
Helpful 1 Not Helpful 0
Be careful not to rinse chemicals away onto plants. ^{[17]
X
Research source}

Thanks
Helpful 0 Not Helpful 0
If your concrete countertop has mold, consult with the manufacturer about what stain removal technique to use. ^{[18]
X
Research source}

Thanks
Helpful 0 Not Helpful 0

[1]

[2]

[3]

Expert Source

Mike Kapur
Certified Mold Assessor & Home Inspector, Sonic Home Inspections

[4]

[5]

[6]

[7]

[8]

[9]

[10]

[11]

[12]

[13]

[14]

[15]

[16]

[17]

[18]

Log in

How to Clean Mold Off Concrete

Steps

Removing the Mold

Eliminating the Source of Moisture

Expert Q&A

Tips

Warnings

You Might Also Like

References

About This Article

Did this article help you?

Quizzes

You Might Also Like

Featured Articles

Trending Articles

Featured Articles

Featured Articles

Watch Articles

Trending Articles

Quizzes

Explore Categories